Jeep Compass - 2016 Fuse Box Diagram

Jeep Compass - 2016 Fuse Box Diagram

Power is available when the ignition switch is in the ON
or ACC position. Insert the cigar lighter or accessory plug
into the outlet for use.
To preserve the heating element,
do not hold the lighter in the heating position.
NOTE:
To ensure proper operation a MOPAR knob and
element must be used.
CAUTION!
Do not exceed the maximum power of 160 Watts
(13 Amps) at 12 Volts. If the 160 Watt (13 Amp)
power rating is exceeded the fuse protecting the
system will need to be replaced.
Power outlets are designed for accessory plugs
only. Do not insert any other object in the power
outlets as this will damage the outlet and blow the
fuse. Improper use of the power outlet can cause
damage not covered by your New Vehicle Limited
Warranty.
12 Volt Power Outlet
192
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
WARNING!
To avoid serious injury or death:
Only devices designed for use in this type of outlet
should be inserted into any 12 Volt outlet.
(Continued)
WARNING!
(Continued)
Do not touch with wet hands.
Close the lid when not in use and while driving the
vehicle.
If this outlet is mishandled, it may cause an electric
shock and failure.
CAUTION!
Many accessories that can be plugged in draw
power from the vehicle’s battery, even when not in
use
(i.e.,
cellular
phones,
etc.).
Eventually,
if
plugged in long enough, the vehicle’s battery will
discharge sufficiently to degrade battery life and/or
prevent the engine from starting.
(Continued)
Power Outlet Fuse Location
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
193
damaged, a “noFUSE” message will display in the odom-
eter display area. Refer to “Fuses” in “Maintaining Your
Vehicle” for further information on fuses and fuse loca-
tions.
CHAngE OIL
Your vehicle is equipped with an engine oil change
indicator system. The odometer display will toggle be-
tween
CHAngE
and
Oil
for approximately 12 seconds,
after a single chime has sounded, to indicate the next
scheduled oil change interval. The engine oil change
indicator system is duty cycle-based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style.
5. Fuel Gauge
The pointer shows the level of fuel in the fuel tank
when the ignition is in the ON/RUN position
The fuel pump symbol points to the side of the
vehicle where the fuel door is located.
WARNING AND INDICATOR LIGHTS
IMPORTANT:
The warning / indicator lights switch on
in the instrument panel together with a dedicated mes-
sage
and/or
acoustic
signal
when
applicable.
These
indications are indicative and precautionary and as such
must not be considered as exhaustive and/or alternative
to the information contained in the Owner’s Manual,
which you are advised to read carefully in all cases.
Always refer to the information in this chapter in the
event of a failure indication.
All active telltales will display first if applicable. The
system check menu may appear different based upon
equipment options and current vehicle status. Some
telltales are optional and may not appear.
4
UNDERSTANDING YOUR INSTRUMENT PANEL
217
ENGINE COMPARTMENT — 2.0L
1 — Washer Fluid Reservoir
6 — Air Cleaner Filter
2 — Power Steering Fluid Reservoir
7 — Coolant Pressure Cap
3 — Engine Oil Fill
8 — Engine Oil Dipstick
4 — Brake Fluid Reservoir
9 — Engine Coolant Reservoir
5 — Integrated Power Module (Fuses)
7
MAINTAINING YOUR VEHICLE
487
ENGINE COMPARTMENT — 2.4L
1 — Washer Fluid Reservoir
6 — Air Cleaner Filter
2 — Power Steering Fluid Reservoir
7 — Coolant Pressure Cap
3 — Engine Oil Fill
8 — Engine Oil Dipstick
4 — Brake Fluid Reservoir
9 — Engine Coolant Reservoir
5 — Integrated Power Module (Fuses)
488
MAINTAINING YOUR VEHICLE
WARNING!
(Continued)
Damaged parts must be replaced immediately. Do
not disassemble or modify the system. Seat belt
assemblies must be replaced after a collision if they
have been damaged (i.e., bent retractor, torn web-
bing, etc.).
FUSES
WARNING!
When replacing a blown fuse, always use an ap-
propriate replacement fuse with the same amp
rating as the original fuse. Never replace a fuse
with another fuse of higher amp rating. Never
replace a blown fuse with metal wires or any other
(Continued)
WARNING!
(Continued)
material. Failure to use proper fuses may result in
serious personal injury, fire and/or property dam-
age.
Before replacing a fuse, make sure that the ignition
is off and that all the other services are switched off
and/or disengaged.
If the replaced fuse blows again, contact an autho-
rized dealer.
If a general protection fuse for safety systems (air
bag system, braking system), power unit systems
(engine system, gearbox system) or steering system
blows, contact an authorized dealer.
528
MAINTAINING YOUR VEHICLE
Integrated Power Module (IPM)
The Integrated Power Module is located in the engine
compartment near the air cleaner assembly. This center
contains cartridge fuses and mini-fuses. A label that
identifies each component may be printed on the inside
of the cover. Refer to “Engine Compartment” in “Main-
taining Your Vehicle” for further information.
Cavity
Cartridge Fuse
Mini-Fuse
Description
1
20 Amp Blue
Trailer Tow – If Equipped
2
15 Amp Lt Blue
AWD/4WD Control Mod-
ule – If Equipped
Integrated Power Module
7
MAINTAINING YOUR VEHICLE
529
Cavity
Cartridge Fuse
Mini-Fuse
Description
3
10 Amp Red
Rear Center Brake Light
Switch
4
10 Amp Red
Ignition Switch/Clock
Spring
5
15 Amp Lt Blue
Battery Feed For Power
Tech
6
10 Amp Red
Power Mirror/Steering
Control Satellite Radio/
Hands-Free Phone
7
30 Amp Green
Ignition Off Draw
8
30 Amp Green
Ignition Off Draw
9
40 Amp Green
Power Seats
10
20 Amp Yellow
Power Locks/Interior
Lighting
11
15 Amp Lt Blue
Power Outlet
530
MAINTAINING YOUR VEHICLE
Cavity
Cartridge Fuse
Mini-Fuse
Description
12
20 Amp Yellow
115V AC Inverter – If
Equipped
13
20 Amp Yellow
Cigar Lighter
14
10 Amp Red
Instrument Cluster
15
40 Amp Green
Radiator Fan
16
15 Amp Lt Blue
Dome Lamp/Sunroof/
Rear Wiper Motor
17
10 Amp Red
Wireless Control Module
18
40 Amp Green
Auto Shutdown Relay
19
20 Amp Yellow
Radio Amplifiers
20
15 Amp Lt Blue
Radio
21
10 Amp Red
Intrusion Module/Siren –
If Equipped
22
10 Amp Red
Heating, AC/Compass
23
15 Amp Lt Blue
Auto Shutdown Relay
7
MAINTAINING YOUR VEHICLE
531
Cavity
Cartridge Fuse
Mini-Fuse
Description
24
15 Amp Lt Blue
Power Sunroof – If
Equipped
25
10 Amp Red
Heated Mirror – If
Equipped
26
15 Amp Lt Blue
Auto Shutdown Relay
27
10 Amp Red
Airbag Control Module
28
10 Amp Red
Airbag Control Module/
Occupant Classification
Module
29
Hot Vehicle (No Fuse
Required)
30
20 Amp Yellow
Heated Seat – If
Equipped
31
10 Amp Red
Headlamp Washer – If
Equipped
32
30 Amp Pink
Auto Shutdown Relay
532
MAINTAINING YOUR VEHICLE
Cavity
Cartridge Fuse
Mini-Fuse
Description
33
10 Amp Red
J1962 Conn/Powertrain
Control Module
34
30 Amp Pink
Antilock BrakeValve
35
40 Amp Green
Antilock Brake Pump
36
30 Amp Pink
Headlamp/Washer
Control/Smart Glass – If
Equipped
37
25 Amp Clear
Diesel
Heater
and
H2/
MOD power top
7
MAINTAINING YOUR VEHICLE
533
CAUTION!
When installing the IPM cover, it is important to
ensure the cover is properly positioned and fully
latched. Failure to do so may allow water to get into
the IPM, and possibly result in an electrical system
failure.
When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
VEHICLE STORAGE
If you will not be using your vehicle for more than 21
days, you may want to take steps to preserve your
battery.
Disengage the mini-fuse in the Power Distribution
Center labeled IOD (Ignition Off-Draw).
Or disconnect the negative cable from the battery.
Anytime you store your vehicle, or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
534
MAINTAINING YOUR VEHICLE
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.