Jeep Patriot - 2013 Fuse Box Diagram

Jeep Patriot - 2013 Fuse Box Diagram

NOTE:
If the speedometer, tachometer, or any engine
related gauges are not working, the Occupant Restraint
Controller (ORC) may also be disabled. The air bags may
not be ready to inflate for your protection. Promptly
check the fuse block for blown fuses. Refer to the label
located on the inside of the fuse block cover for the
proper air bag fuses. See your authorized dealer if the
fuse is good.
Event Data Recorder (EDR)
This vehicle is equipped with an event data recorder
(EDR). The main purpose of an EDR is to record, in
certain crash or near crash-like situations, such as an air
bag deployment or hitting a road obstacle, data that will
assist in understanding how a vehicle’s systems per-
formed. The EDR is designed to record data related to
vehicle dynamics and safety systems for a short period of
time, typically 30 seconds or less. The EDR in this vehicle
is designed to record such data as:
How various systems in your vehicle were operating;
Whether or not the driver and passenger safety belts
were buckled/fastened;
How far (if at all) the driver was depressing the
accelerator and/or brake pedal; and,
How fast the vehicle was traveling.
These data can help provide a better understanding of
the circumstances in which crashes and injuries occur.
NOTE:
EDR data are recorded by your vehicle only if a
non-trivial crash situation occurs; no data are recorded by
the EDR under normal driving conditions and no per-
sonal data (e.g., name, gender, age, and crash location)
are recorded. However, other parties, such as law en-
forcement, could combine the EDR data with the type of
personally identifying data routinely acquired during a
crash investigation.
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
75
NOTE:
To ensure proper operation a MOPAR® knob
and element must be used.
CAUTION!
Do not exceed the maximum power of 160 Watts (13
Amps) at 12 Volts. If the 160 Watt (13 Amp) power
rating is exceeded the fuse protecting the system
will need to be replaced.
Power outlets are designed for accessory plugs
only. Do not insert any other object in the power
outlets as this will damage the outlet and blow the
fuse. Improper use of the power outlet can cause
damage not covered by your New Vehicle Limited
Warranty.
Power Outlet Fuse Location
190
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
ENGINE COMPARTMENT — 2.0L
1 — Washer Fluid Reservoir
6 — Air Cleaner Filter
2 — Power Steering Fluid Reservoir
7 — Coolant Pressure Cap
3 — Engine Oil Fill
8 — Engine Oil Dipstick
4 — Brake Fluid Reservoir
9 — Engine Coolant Reservoir
5 — Integrated Power Module (Fuses)
7
MAINTAINING YOUR VEHICLE
443
ENGINE COMPARTMENT — 2.4L
1 — Washer Fluid Reservoir
6 — Air Cleaner Filter
2 — Power Steering Fluid Reservoir
7 — Coolant Pressure Cap
3 — Engine Oil Fill
8 — Engine Oil Dipstick
4 — Brake Fluid Reservoir
9 — Engine Coolant Reservoir
5 — Integrated Power Module (Fuses)
444
MAINTAINING YOUR VEHICLE
Instrument Panel Bezels
CAUTION!
When installing hanging air fresheners in your ve-
hicle,
read
the
installation
instructions
carefully.
Some
air
fresheners
will
damage
the
finish
of
painted or decorated parts if allowed to directly
contact any surface.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye, or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
If the belts need cleaning, use MOPAR® Total Clean, a
mild soap solution, or lukewarm water. Do not remove
the belts from the vehicle to wash them. Dry with a soft
cloth.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
FUSES
Integrated Power Module
The Integrated Power Module is located in the engine
compartment near the air cleaner assembly. This center
contains cartridge fuses and mini-fuses. A label that
7
MAINTAINING YOUR VEHICLE
479
identifies each component may be printed on the inside
of the cover. Refer to “Engine Compartment” in “Main-
taining Your Vehicle” for further information.
Cavity
Car-
tridge
Fuse
Mini-
Fuse
Description
1
Empty
Empty
2
15 Amp
Lt Blue
AWD/4WD Control
Module – If Equipped
3
10 Amp
Red
Rear Center Brake
Light Switch
4
10 Amp
Red
Ignition Switch/
Occupant Classifica-
tion Module
5
20 Amp
Yellow
Trailer Tow – If
Equipped
6
10 Amp
Red
Power Mirror/
Steering Control Satel-
lite Radio/Hands-Free
Phone
Integrated Power Module
480
MAINTAINING YOUR VEHICLE
Cavity
Car-
tridge
Fuse
Mini-
Fuse
Description
7
30 Amp
Green
Ignition Off Draw
8
30 Amp
Green
Ignition Off Draw
9
40 Amp
Green
Power Seats
10
20 Amp
Yellow
Power Locks/Interior
Lighting
11
15 Amp
Lt Blue
Power Outlet
12
20 Amp
Yellow
115V AC Inverter – If
Equipped
13
20 Amp
Yellow
Cigar Lighter
Cavity
Car-
tridge
Fuse
Mini-
Fuse
Description
14
10 Amp
Red
Instrument Cluster
15
40 Amp
Green
Radiator Fan
16
15 Amp
Lt Blue
Dome Lamp/
Sunroof/Rear Wiper
Motor
17
10 Amp
Red
Wireless Control Mod-
ule
18
40 Amp
Green
Auto Shutdown Relay
19
20 Amp
Yellow
Radio Amplifiers
7
MAINTAINING YOUR VEHICLE
481
Cavity
Car-
tridge
Fuse
Mini-
Fuse
Description
20
15 Amp
Lt Blue
Radio
21
10 Amp
Red
Intrusion Module/
Siren – If Equipped
22
10 Amp
Red
Heating, AC/Compass
23
15 Amp
Lt Blue
Auto Shutdown Relay
24
15 Amp
Lt Blue
Power Sunroof – If
Equipped
25
10 Amp
Red
Heated Mirror – If
Equipped
26
15 Amp
Lt Blue
Auto Shutdown Relay
Cavity
Car-
tridge
Fuse
Mini-
Fuse
Description
27
10 Amp
Red
Airbag Control Mod-
ule
28
10 Amp
Red
Airbag Control
Module/Occupant
Classification Module
29
Hot Car (No Fuse Re-
quired)
30
20 Amp
Yellow
Heated Seat – If
Equipped
31
10 Amp
Red
Headlamp Washer – If
Equipped
32
30 Amp
Pink
Auto Shutdown Relay
482
MAINTAINING YOUR VEHICLE
Cavity
Car-
tridge
Fuse
Mini-
Fuse
Description
33
10 Amp
Red
J1962 Conn/
Powertrain Control
Module
34
30 Amp
Pink
Antilock BrakeValve
35
40 Amp
Green
Antilock Brake Pump
36
30 Amp
Pink
Headlamp/Washer
Control/Smart Glass –
If Equipped
37
25 Amp
Natural
Diesel Fuel Heater – If
Equipped
CAUTION!
When installing the IPM cover, it is important to
ensure the cover is properly positioned and fully
latched. Failure to do so may allow water to get into
the IPM, and possibly result in an electrical system
failure.
When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
VEHICLE STORAGE
If you will not be using your vehicle for more than 21
days, you may want to take steps to preserve your
battery.
7
MAINTAINING YOUR VEHICLE
483
Disengage the mini-fuse in the Power Distribution
Center labeled IOD (Ignition Off-Draw).
Or disconnect the negative cable from the battery.
Anytime you store your vehicle, or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base.
Aluminum base bulbs are not approved and should not
be used for replacement.
Interior Bulbs
Bulb Number
Front Header Lamp
T578
Center Dome Lamp
T578
Rear Cargo Lamp/
Flashlight
8–A35LF
Exterior Bulbs
Bulb Number
Low Beam/High Beam
Headlamp
H13
Front Park/Turn Signal/
Side Marker Lamp
3757KA
Front Fog Lamp
PSX24W
Center High Mounted
Stop Lamp (CHMSL)
LED Assembly (Serviced
At Authorized Dealer)
484
MAINTAINING YOUR VEHICLE
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
POWER OUTLET
The power outlet is located on the instrument panel below the climate control and
is powered when the ignition switch is in the ON/RUN position.
The outlet can operate a conventional cigar lighter unit or power accessories
designed for use with a standard power outlet adapter.
NOTE:
Do not exceed the maximum power of 160 Watts (13 Amps) at 12 Volts. If the
160 Watt (13 Amp) power rating is exceeded, the fuse protecting the system will
need to be replaced.
Power outlets are designed for accessory plugs only. Do not insert any other object
in the power outlet as this will damage the outlet and blow the fuse. Improper use
of the power outlet can cause damage not covered by your new vehicle warranty.
ELECTRONICS
62
FUSES
Integrated Power Module (fuses)
The Integrated Power Module (fuses) is located in the engine compartment near
the air cleaner assembly. This center contains cartridge fuses and mini-fuses.
Cavity
Cartridge Fuse
Mini-Fuse
Description
1
Empty
Empty
2
15 Amp Lt
Blue
AWD/4WD ECU Feed
3
10 Amp Red
CHMSL Brake Switch Feed
4
10 Amp Red
Ignition Switch Feed/OCM
5
20 Amp Yellow
Trailer Tow
6
10 Amp Red
IOD Sw/Pwr Mir/Steering Cntrl Sdar/
Hands-Free Phone
7
30 Amp Green
IOD Sense1
8
30 Amp Green
IOD Sense2
9
40 Amp Green
Power Seats
10
20 Amp Yellow
CCN Power Locks/Interior Lighting
11
15 Amp Lt
Blue
Power Outlet
12
20 Amp Yellow
Ign Run/Acc Inverter
13
20 Amp Yellow
Pwr Run/Acc Outlet RR/Dome Lamp/
Cigar Lighter
14
10 Amp Red
IOD CCN
15
40 Amp Green
RAD Fan Relay Battery Feed
16
15 Amp Lt
Blue
IGN Run/ACC Dome Lamp/Sunroof/
Rear Wiper Motor/ACC Inverter
17
10 Amp Red
IOD Feed Mod-Wcm
18
40 Amp Green
ASD Relay Contact PWR Feed
MAINTAINING YOUR VEHICLE
92
Cavity
Cartridge Fuse
Mini-Fuse
Description
19
20 Amp Yellow
PWR Amp 1 & Amp 2 Feed
20
15 Amp Lt
Blue
IOD Feed Radio
21
10 Amp Red
IOD Feed Intrus Mod/Siren (If
Equipped)
22
10 Amp Red
IGN RUN Heat/AC/Compass Sensor
23
15 Amp Lt
Blue
ENG ASD Relay Feed 3
24
15 Amp Lt
Blue
Power Sunroof Feed
25
10 Amp Red
Heated Mirror (If Equipped)
26
15 Amp Lt
Blue
ENG ASD Relay Feed 2
27
10 Amp Red
IGN RUN Only ORC Feed
28
10 Amp Red
IGN RUN ORC/OCM Feed
29
Hot Car (No Fuse Required)
30
20 Amp Yellow
Heated Seat (If Equipped)
31
10 Amp Red
Headlamp Washer Relay Control (If
Equipped)
32
30 Amp Pink
ENG ASD Control Feed 1
33
10 Amp Red
ABS MOD/J1962 Conn/PCM
34
30 Amp Pink
ABS Valve Feed
35
40 Amp Green
ABS Pump Feed
36
30 Amp Pink
Headlamp/Washer Control/Smart
Glass (If Equipped)
37
25 Amp
Natural
Diesel Fuel Heater (If Equipped)
MAINTAINING YOUR VEHICLE
93
MAINTAINING YOUR VEHICLE
Where is my Fuse Block located? pg. 92
What type of oil do I use? pg. 86
How often should I change my engine’s oil? pg. 87
What should my tire pressure be set at? pg. 94
FAQ (How To?)
99