Jeep Wrangler - 2013 Fuse Box Diagram

Jeep Wrangler - 2013 Fuse Box Diagram

with air bag system electrical components. While the air
bag system is designed to be maintenance free, if any of
the following occurs, have an authorized dealer service
the air bag system immediately.
The Air Bag Warning Light does not come on during
the four to eight seconds when the ignition switch is
first turned to the ON/RUN position.
The Air Bag Warning Light remains on after the four to
eight-second interval.
The Air Bag Warning Light comes on intermittently or
remains on while driving.
NOTE:
If the speedometer, tachometer, or any engine
related gauges are not working, the Occupant Restraint
Controller (ORC) may also be disabled. The air bags may
not be ready to inflate for your protection. Promptly
check the fuse block for blown fuses. Refer to the label
located on the inside of the fuse block cover for the
proper air bag fuses. See your authorized dealer if the
fuse is good.
Event Data Recorder (EDR)
This vehicle is equipped with an event data recorder
(EDR). The main purpose of an EDR is to record, in
certain crash or near crash-like situations, such as an air
bag deployment or hitting a road obstacle, data that will
assist in understanding how a vehicle’s systems per-
formed. The EDR is designed to record data related to
vehicle dynamics and safety systems for a short period of
time, typically 30 seconds or less. The EDR in this vehicle
is designed to record such data as:
How various systems in your vehicle were operating;
Whether or not the driver and passenger safety belts
were buckled/fastened;
How far (if at all) the driver was depressing the
accelerator and/or brake pedal; and,
2
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
75
A second power outlet is located inside the center console
and is powered directly from the vehicle battery.
CAUTION!
Do not exceed the maximum power of 160 Watts
(13 Amps) at 12 Volts. If the 160 Watt (13 Amp)
power rating is exceeded the fuse protecting the
system will need to be replaced.
Power outlets are designed for accessory plugs
only. Do not insert any other object in the power
outlets as this will damage the outlet and blow the
fuse. Improper use of the power outlet can cause
damage not covered by your New Vehicle Limited
Warranty.
On vehicles equipped with a rear subwoofer, there is a
third power outlet located in the right rear cargo area.
Rear Power Outlet — If Equipped
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
185
WARNING!
To avoid serious injury or death:
Only devices designed for use in this type of outlet
should be inserted into any 12 Volt outlet.
Do not touch with wet hands.
Close the lid when not in use and while driving the
vehicle.
If this outlet is mishandled, it may cause an electric
shock and failure.
Power Outlet Fuse Locations
1 — M36 Fuse 20 A Yellow Power Outlet Console Bin
2 — M6 Fuse 20 A Yellow Cigar Lighter Instrument Panel
3 — M7 Fuse 20 A Yellow Power Outlet Rear with Sub Woofer
(Opt.)
186
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
(e.g., snow plowing, off-road operation). If this “HOT-
OIL” message turns on, stop the vehicle and run the
engine at idle or faster with the transmission in NEU-
TRAL until the message turns off.
CAUTION!
Continuous driving with the Transmission Tempera-
ture “HOTOIL” Warning message illuminated will
eventually
cause
severe
transmission
damage
or
transmission failure.
WARNING!
If the Transmission Temperature “HOTOIL” Warn-
ing message is illuminated and you continue operat-
ing the vehicle, in some circumstances you could
cause the fluid to boil over, come in contact with hot
engine or exhaust components and cause a fire.
gASCAP
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
“gASCAP” message will display in the odometer display
area. Tighten the fuel filler cap properly and press the
TRIP ODOMETER button to turn off the message. If the
problem continues, the message will appear the next time
the vehicle is started.
noFUSE
If the vehicle diagnostic system determines that the
Ignition Off Draw (IOD) fuse is improperly installed, or
damaged, a “noFUSE” message will display in the odom-
eter display area. For further information on fuses and
fuse locations refer to “Fuses” in “Maintaining Your
Vehicle”.
316
UNDERSTANDING YOUR INSTRUMENT PANEL
ENGINE COMPARTMENT — 3.6L
1 — Integrated Power Module (Fuses)
7 — Washer Fluid Reservoir
2 — Battery
8 — Engine Coolant Reservoir
3 — Engine Oil Dipstick
9 — Air Cleaner Filter
4 — Automatic Transmission Dipstick (Under Engine Cover)
10 — Coolant Pressure Cap
5 — Engine Oil Fill
11 — Power Steering Fluid Reservoir
6 — Brake Fluid Reservoir
7
MAINTAINING YOUR VEHICLE
567
FUSES
Totally Integrated Power Module
The Totally Integrated Power Module is located in the
engine compartment near the battery. This center con-
tains cartridge fuses, mini fuses and relays. A label that
identifies each component is printed on the inside of the
cover.
Totally Integrated Power Module
606
MAINTAINING YOUR VEHICLE
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
J1
J2
30 Amp
Pink
Transfer Case Mod-
ule
J3
J4
25 Amp
Natural
Driver Door Node
J5
25 Amp
Natural
Passenger Door
Node
J6
40 Amp
Green
Anti-Lock Brake
System (ABS)
Pump/Stability
Control System
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
J7
30 Amp
Pink
Anti-Lock Brake
System (ABS)
Valve/Stability
Control System
J8
J9
40 Amp
Green
PZEV Sec Motor/
Flex Fuel
J10
30 Amp
Pink
Headlamp Wash
Relay/Manifold
Tuning Valve
J11
30 Amp
Pink
Sway Bar
7
MAINTAINING YOUR VEHICLE
607
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
J12
30 Amp
Pink
Rear Blower
Motor/Radiator
Fan
J13
60 Amp
Yellow
Ignition Off Draw
(IOD) – Main
J14
40 Amp
Green
Rear Defroster
J15
40 Amp
Green
Front Blower
J17
40 Amp
Green
Starter Solenoid
J18
20 Amp
Blue
Powertrain Control
Module (PCM)
Trans Range
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
J19
60 Amp
Yellow
Radiator Fan
J20
30 Amp
Pink
Front Wiper LO/HI
J21
20 Amp
Blue
Front/Rear Washer
J22
Spare
M1
15 Amp
Blue
Center High-
Mounted Stop
Light (CHMSL)/
Switch Stop Lamp
Feed
M2
20 Amp
Yellow
Relay Trailer Light-
ing (Stoplamp)
608
MAINTAINING YOUR VEHICLE
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
M3
20 Amp
Yellow
Frt/Rear Axle
Locker Relay
M4
M5
25 Amp
Natural
Power Inverter – If
Equipped
M6
20 Amp
Yellow
Power Outlet #1/
Rain Sensor
M7
20 Amp
Yellow
Power Outlet #2
(BATT/ACC SE-
LECT)
M8
20 Amp
Yellow
Front Heated Seat
M9
20 Amp
Yellow
Rear Heated Seat –
If Equipped
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
M10
15 Amp
Blue
Ignition Off Draw –
Vehicle Entertain-
ment System, Satel-
lite Digital Audio
Receiver (SDARS),
DVD, Hands-Free
Module, RADIO,
Antenna, Universal
Garage Door
Opener, Vanity
Lamp
M11
10 Amp
Red
(Ignition Off Draw)
Climate Control
System, Underhood
Lamp
7
MAINTAINING YOUR VEHICLE
609
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
M12
30 Amp
Green
Amplifier
M13
20 Amp
Yellow
Ignition Off Draw –
Cabin Compart-
ment Node, Wire-
less Control Mod-
ule, SIREN,
Multifunction Con-
trol Switch
M14
20 Amp
Yellow
Trailer Tow (Export
Only)
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
M15
20 Amp
Yellow
Climate Control
System, Rear View
Mirror, Cabin Com-
partment Node,
Transfer Case
Switch, Multi-
Function Control
Switch, Tire Pres-
sure Monitor, Glow
Plug Module – Ex-
port Diesel Only
M16
10 Amp
Red
Airbag Module
M17
15 Amp
Blue
Left Tail/License/
Park Lamp
610
MAINTAINING YOUR VEHICLE
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
M18
15 Amp
Blue
Right Tail/Park/
Run Lamp
M19
25 Amp
Natural
Auto Shut Down
(ASD #1 and #2)
M20
15 Amp
Blue
Cabin Compart-
ment Node Interior
Light, Switch Bank
M21
20 Amp
Yellow
Auto Shut Down
(ASD #3)
M22
10 Amp
Red
Right Horn (HI/
LOW)
M23
10 Amp
Red
Left Horn (HI/
LOW)
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
M24
25 Amp
Natural
Rear Wiper
M25
20 Amp
Yellow
Fuel Pump, Diesel
Lift Pump – Export
Only
M26
10 Amp
Red
Power Window
Switch, Driver Win-
dow Switch
M27
10 Amp
Red
Ignition Switch
Feed, Wireless
Module
M28
10 Amp
Red
Powertrain Control
Module
7
MAINTAINING YOUR VEHICLE
611
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
M29
10 Amp
Red
Powertrain
M30
15 Amp
Blue
Wiper Motor Frt,
J1962 Diagnostic
Feed
M31
20 Amp
Yellow
Backup Lamps
M32
10 Amp
Red
Airbag Controller,
TT EUROPE
M33
10 Amp
Red
Powertrain Control-
ler
Cavity
Car-
tridge
Fuse
Mini
Fuse
Description
M34
10 Amp
Red
Park Assist, Cli-
mate Control Sys-
tem, Headlamp
Wash, Compass
M35
10 Amp
Red
Heated Mirrors
M36
20 Amp
Yellow
Power Outlet
M37
10 Amp
Red
Anti-Lock Brake
System, Electronic
Stability Control,
Stop Lamp Switch,
Fuel Pump Relay
M38
25 Amp
Natural
Lock/Unlock Mo-
tors
612
MAINTAINING YOUR VEHICLE
CAUTION!
When
installing
the
Integrated
Power
Module
cover, it is important to ensure the cover is properly
positioned and fully latched. Failure to do so may
allow water to get into the Integrated Power Mod-
ule, and possibly result in an electrical system
failure.
When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If
a properly rated fuse continues to blow, it indicates
a problem in the circuit that must be corrected.
VEHICLE STORAGE
If you are leaving your vehicle dormant for more than 21
days, you may want to take steps to protect your battery.
You may:
Remove Cartridge fuse #J13 in the Power Distribution
Center (PDC) labeled Ignition-Off Draw (IOD) and
store it in a safe location within the PDC.
Or, disconnect the negative cable from the battery.
Anytime you store your vehicle, or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
7
MAINTAINING YOUR VEHICLE
613
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.