Dodge Ram 5500 - 2009 Fuse Box Diagram

Dodge Ram 5500 - 2009 Fuse Box Diagram

NOTE:
Perchlorate Material – special handling may apply:
Refer to www.dtsc.ca.gov/hazardouswaste/perchlorate.
Airbag Warning Light
You will want to have the airbags ready to
inflate for your protection in an impact. While
the airbag system is designed to be mainte-
nance free, if any of the following occurs, have
an authorized dealer service the system promptly:
The Airbag Warning Light does not come on or flickers
during the six to eight seconds when the ignition
switch is first turned ON.
The light remains on or flickers after the six to eight
second interval.
The light flickers or comes on and remains on while
driving.
NOTE:
If the speedometer, tachometer or any engine
related gauges are not working, the ORC may also be
disabled. The airbags may not be ready to inflate for your
protection. Promptly check the fuse block for blown
fuses. For proper location of airbag fuses, refer to “Fuses
(Integrated Power Module)” in Section 7. See your au-
thorized dealer if the fuse is good.
Event Data Recorder (EDR)
In the event of an accident, your vehicle is designed to
record up to approximately five seconds of specific
vehicle data parameters (see the following list) in an
event data recorder prior to the moment of airbag de-
ployment, or near deployment, and up to a quarter-
second of high-speed deceleration data during and/or
after airbag deployment. EDR data are ONLY recorded if
an airbag deploys, or nearly deploys, and are otherwise
unavailable.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
57
2
ELECTRICAL POWER OUTLETS
The auxiliary electrical outlet can provide power for
in-cab accessories designed for use with the standard
“cigar lighter” plug. The outlet is located in the instru-
ment panel below and to the right of the climate control
panel. A cap is attached to the outlet base indicating
“Power Outlet” 12-Volt/20 A.
There is an additional power outlet inside the center
console of vehicles equipped with 40-20-40, or bucket
front seats. There is also a power outlet located on the
rear of the center console (if equipped with bucket seats).
The outlet(s) has/have a fused direct feed from the
battery so it/they receive power whether the ignition is
ON or OFF.
All accessories connected to this/these outlet(s) should
be removed or turned off when the vehicle is not in use
to protect the battery against discharge.
NOTE:
If desired, all of the power outlets can be
converted by your authorized dealer to provide power
with the ignition switch in the ON position only.
WARNING!
To avoid serious injury or death:
Do not use a three-prong adapter.
Do not insert any objects into the receptacles.
Do not touch with wet hands.
Close the lid when not in use and while driving
the vehicle.
If this outlet is mishandled, it may cause an
electric shock and failure.
144
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
15. Shift Lever Indicator (Automatic Transmission
Only)
This display indicator shows the automatic transmission
shift lever selection.
NOTE:
You must apply the brake before shifting from
PARK.
16. Odometer/Trip Odometer
The odometer shows the total distance the vehicle has
been driven. U.S. federal regulations require that upon
transfer of vehicle ownership, the seller certify to the
purchaser the correct mileage that the vehicle has been
driven. Therefore, if the odometer reading is changed
during repair or replacement, be sure to keep a record of
the reading before and after the service so that the correct
mileage can be determined.
The two trip odometers show individual trip mileage. To
switch
from
odometer
to
trip
odometers,
press
and
release the Trip Odometer button.
To reset a trip odometer, display the desired trip odom-
eter to be reset then push and hold the button until the
display resets (approximately two seconds).
Vehicle Warning Messages
When the appropriate conditions exist, messages such as
“door” (indicates that a door(s) may be ajar), “hood” (if
the hood is open or ajar, on vehicles with remote start),
“gASCAP” (indicates that your gas cap is possibly loose
or damaged), “Low Tire” (indicates low tire pressure),
´
CHANgE OIL” (indicates that the engine oil should be
changed), “LoWASH” (low washer fluid), and “noFUSE
(indicates that the IOD fuse is removed from the Inte-
grated Power Module), will display in the odometer.
NOTE:
There is also an engine hour function. This
indicates the total number of hours the engine has been
running. To display the engine hours perform the follow-
ing: Place the ignition in RUN, but do not start the
engine. With the odometer value displayed, hold the trip
166
UNDERSTANDING YOUR INSTRUMENT PANEL
Seat Belt Maintenance
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
If the belts need cleaning, use a mild soap solution or
lukewarm water. Do not remove the belts from the
vehicle to wash them.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
Dry with a soft tissue.
FUSES
Integrated Power Module
The integrated power module is located in the engine
compartment near the battery. This center contains car-
tridge fuses and mini fuses. A description of each fuse
and component may be stamped on the inside cover,
otherwise the cavity number of each fuse is stamped on
the inside cover that corresponds to the following chart.
Integrated Power Module
364
MAINTAINING YOUR VEHICLE
Cavity
Cartridge
Fuse
Mini
Fuse
Description
1
20 Amp
Yellow
Power Outlet Console
2
20 Amp
Yellow
Cabin Compartment
Node (CCN) Door
Locks
3
4
15 Amp
Blue
Aisin Transmission
Controls (Diesel Only)
5
20 Amp
Yellow
Power Sunroof
6
10 Amp
Red
Vistronic Fan/
Wastegate Solenoid
7
8
10 Amp
Red
Heated Mirrors
Cavity
Cartridge
Fuse
Mini
Fuse
Description
9
30 Amp
Pink
Off Road Module
Power
10
5 Amp
Orange
Trx-Off Rd Pkg Sen
(Gas Engine Only)
NOTE: Insert 5 amp
fuse in this cavity to
enable the TRX capa-
bility (If Equipped).
11
20 Amp
Yellow
Ignition Off Draw
(IOD)-Cabin Com-
partment Node
(CCN)/Radio/Under
Hood Lamp/Wireless
Control Module
(WCM)/Satellite Digi-
tal Audio Receiver
(SDARS)/Hands Free
Module (HFM)/EOM
MAINTAINING YOUR VEHICLE
365
7
Cavity
Cartridge
Fuse
Mini
Fuse
Description
12
30 Amp
Pink
Electric Brake
13
25 Amp
Natural
Power-Battery
RWAL/ABS Module
Feed
14
15 Amp
Blue
Park Lights Left
15
20 Amp
Yellow
Trailer Park Lights
16
15 Amp
Blue
Park Lights Right
17
18
40 Amp
Green
ABS Pump
19
30 Amp
Pink
Trailer Tow Battery
Feed
Cavity
Cartridge
Fuse
Mini
Fuse
Description
20
10 Amp
Red
Occupant Restraints
Controller (ORC) 2
21
10 Amp
Red
Occupant Restraints/
Pass Disable Switch
22
2 Amp
Gray
IGN Switch Feed
23
10 Amp
Red
HVAC
24
20 Amp
Blue
AISIN Relay Feed
(Diesel Only)
25
10 Amp
Red
Power Mirror/T-Case
Brake
26
20 Amp
Yellow
Brake Switch/Center
High Mount Stop
Light (CHMSL)/
Aftermarket CHMSL
366
MAINTAINING YOUR VEHICLE
Cavity
Cartridge
Fuse
Mini
Fuse
Description
27
40 Amp
Green
Power Seats
28
10 Amp
Red
Power Run/Start-
PCM/Steering Angle
Sensor
29
10 Amp
Red
4X4 Switch/Pass Dr
Switch/EC Mirror
30
15 Amp
Blue
Power Run/Start-
ABS/RWAL/Smart
Bar/YAW Sensor/
Universal Exhaust
Gas Oxygen (Uego)
Sensor Controller
31
10 Amp
Red
PCM (Gas)/TCM
(Diesel 58RFE)
Cavity
Cartridge
Fuse
Mini
Fuse
Description
32
10 Amp
Red
Power Ignition Run
— Adjustable Pedals
LED
33
10 Amp
Red
Power-IGN Run —
HVAC
34
35
15 Amp
Blue
Cabin Compartment
Node (CCN) Illumi-
nation
36
25 Amp
Natural
Audio_Amplifier
37
15 Amp
Blue
Variable Gate Turbo
(VGT) — Turbo Die-
sel
38
20 Amp
Yellow
Power Outlet IP
MAINTAINING YOUR VEHICLE
367
7
Cavity
Cartridge
Fuse
Mini
Fuse
Description
39
10 Amp
Red
Seatbelt Tension
Reducer/Power IGN
Run/Acc
40
20 Amp
Yellow
Power IGN Run/Acc
— Cigar Lighter/Rear
Power Point
41
42
30 Amp
Pink
Diesel PCM (Diesel
Only)
CAUTION!
When
installing
the
Integrated
Power
Module
cover, it is important to ensure the cover is prop-
erly positioned and fully latched. Failure to do so
may allow water to get into the Integrated Power
Module, and possibly result in a electrical system
failure.
When replacing a blown fuse, it is important to
use only a fuse having the correct amperage rating.
The use of a fuse with a rating other than indicated
may result in a dangerous electrical system over-
load. If a properly rated fuse continues to blow, it
indicates a problem in the circuit that must be
corrected.
368
MAINTAINING YOUR VEHICLE
VEHICLE STORAGE
If you are storing your vehicle for more than 21 days, we
recommend that you take the following steps to mini-
mize the drain on your vehicle’s battery:
Disconnect the Ignition-Off Draw (IOD) fuse located in
the Integrated Power Module, located in the engine
compartment. The IOD cavity includes a snap-in re-
tainer that allows the fuse to be disconnected without
removing it from the fuse block.
The electronic shift transfer case should be placed in
the 4HI mode and kept in this position to minimize the
battery drain.
As an alternative to the above steps you may discon-
nect the negative cables from both batteries.
Any time you store your vehicle or keep it out of
service (i.e., vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
NOTE:
When reinstalling the IOD fuse push firmly until fully
seated; the gauges in the instrument cluster will do a
full sweep when the ignition key is cycled to RUN.
This is a normal condition.
When the vehicle is shipped from the factory, the IOD
fuse is in the up or extracted position. If the radio,
interior lamps, keyless entry or other features do not
work with the key OFF, check the position of the fuse
(or check to see if the fuse is blown) to ensure that it is
fully seated. When the IOD fuse is extracted, the
instrument cluster in the odometer window will dis-
play
´
NO FUSE.”
MAINTAINING YOUR VEHICLE
369
7
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.