Jeep Liberty - 2009 Fuse Box Diagram

Jeep Liberty - 2009 Fuse Box Diagram

ELECTRICAL POWER OUTLET
Your vehicle is equipped with a fused 12-Volt (DC) power
outlet. This power outlet is located on the instrument
panel, below the climate controls. It has power available
when the ignition switch is in the ON or ACC position.
Insert the cigar lighter or accessory plug into the outlet
for use to ensure proper operation.
NOTE:
To ensure proper operation a MOPAR
²
knob and
element must be used.
Do not exceed the maximum power of 160 Watts (13
Amps) at 12-Volts.
WARNING!
To avoid serious injury or death:
Do not insert any objects into the receptacles.
Do not touch with wet hands.
Close the lid when not in use and while driving
the vehicle.
If this outlet is mishandled, it may cause an
electric shock and failure.
Front Power Outlet
180
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
1. Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye, or clean the seat belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
If the seat belts need cleaning, use a mild soap solution or
lukewarm water. Dry with a soft cloth. Do not remove the
seat belts from the car to wash them.
Replace the seat belts if they appear frayed or worn or if
the buckles do not work properly.
FUSES
Totally Integrated Power Module (TIPM)
The Totally Integrated Power Module (TIPM) is located
in the engine compartment near the battery. This center
contains cartridge fuses, mini-fuses and relays. A label
that identifies each component is printed on the inside of
the cover.
Totally Integrated Power Module (TIPM)
440
MAINTAINING YOUR VEHICLE
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
J1
J2
30 Amp
Pink
Transfer Case Module - if
equipped
J3
40 Amp
Green
Rear Door Modules
J4
25 Amp
White
Driver Door Node
J5
25 Amp
White
Passenger Door Node
J6
40 Amp
Green
Anti-Lock Brake System
(ABS) Pump/ESP - if
equipped
J7
30 Amp
Pink
Anti-Lock Brake System
(ABS) Valve/ESP - if
equipped
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
J8
40 Amp
Green
Power Seats - if equipped
J9
40 Amp
Green
PZEV/Flex Fuel - if
equipped
J10
J11
J13
60 Amp
Yellow
Ignition Off Draw (IOD)
J14
40 Amp
Green
EBL (Rear Window De-
fogger) - if equipped
J15
J17
40 Amp
Green
Starter Solenoid
MAINTAINING YOUR VEHICLE
441
7
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
J18
20 Amp
Blue
Powertrain Control Mod-
ule (PCM) Transmission
Relay
J19
60 Amp
Yellow
Radiator Fan
J20
30 Amp
Pink
Front Wiper
J21
20 Amp
Blue
Front Washer/Rear
Washer - if equipped
J22
25 Amp
White
Sunroof Module - if
equipped
M1
15 Amp
Blue
Stop Light Switch Feed
— Center High Mounted
Stop Light (CHMSL)
M2
20 Amp
Yellow
Trailer Lighting - if
equipped
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
M3
M4
10 Amp
Red
Trailer Tow - if equipped
M5
25 Amp
Natural
Power Inverter – if
equipped
M6
20 Amp
Yellow
Power Outlet #1 (cigar
lighter)/Rain Sensor - if
equipped/Trailer Tow - if
equipped
M7
20 Amp
Yellow
Power Outlet #2 (BATT/
ACC SELECT)
M8
20 Amp
Yellow
Front Heated Seats - if
equipped
M9
442
MAINTAINING YOUR VEHICLE
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
M10
15 Amp
Blue
Hands-Free Module
(HFM) – if equipped/
Universal Garage Door
Opener (UGDO) – if
equipped/Vanity Light
M11
10 Amp
Red
Automatic Temperature
Control (ATC) - if
equipped
M12
30 Amp
Green
Radio/Amplifier - if
equipped
M13
20 Amp
Yellow
Cabin Compartment
Node (CCN)/Wireless
Control Module (WCM)/
Multifunction Control
Switch
M14
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
M15
20 Amp
Yellow
Multifunction Control
Switch/Cabin Compart-
ment Node (CCN)/
Steering Column Control
Module (SCM)/Rear
View Mirror/Tire Pres-
sure Monitor (TPM) - if
equipped/IR Sensor - if
equipped/Transfer Case
Module - if equipped
M16
10 Amp
Red
Occupant Restraint Con-
troller (ORC)
M17
15 Amp
Blue
Exterior Lighting — Left
Front Park and Side
Marker, Left Tail and
Running, License Lights
MAINTAINING YOUR VEHICLE
443
7
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
M18
15 Amp
Blue
Exterior Lighting —
Right Front Park and
Side Marker, Right Tail
and Running Lights
M19
25 Amp
Natural
Auto Shut Down (ASD)
#1 and #2
M20
15 Amp
Blue
Interior Lighting/Steering
Wheel Switches - if
equipped/Switch Bank/
Electronic Vehicle Infor-
mation Center (EVIC) - if
equipped
M21
20 Amp
Yellow
Auto Shut Down (ASD)
#3
M22
10 Amp
Red
Right Horn (Hi/Low)
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
M23
10 Amp
Red
Left Horn (Hi/Low)
M25
20 Amp
Yellow
Fuel Pump
M26
10 Amp
Red
Power Mirror Switch/
Driver Window Switch
M27
10 Amp
Red
Ignition Switch/Wireless
Control Module (WCM)/
Steering Column Lock - if
equipped
M28
10 Amp
Red
Powertrain Control Mod-
ule (PCM)
M29
10 Amp
Red
Occupant Classification
Module (OCM)
444
MAINTAINING YOUR VEHICLE
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
M30
15 Amp
Blue
Rear Wiper Module - if
equipped/Diagnostic
Link
M31
20 Amp
Yellow
Back-Up Lights
M32
10 Amp
Red
Occupant Restraint Con-
troller (ORC)
M33
10 Amp
Red
Powertrain Control Mod-
ule (PCM)
M34
10 Amp
Red
Park Assist Module - if
equipped/Heating, Venti-
lation, and Air Condition-
ing (HVAC) Module - if
equipped/Compass Mod-
ule - if equipped
Cav-
ity
Car-
tridge
Fuse
Mini-
Fuse
Description
M35
10 Amp
Red
Heated Mirrors - if
equipped
M36
M37
10 Amp
Red
Anti-Lock Brake System
(ABS)/Electronic Stability
Program (ESP) Module/
Stop Light Switch
M38
25 Amp
Natural
Door and Liftgate Lock/
Unlock Motors
MAINTAINING YOUR VEHICLE
445
7
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.