Chrysler Sebring - 2006 Fuse Box Diagram

Chrysler Sebring - 2006 Fuse Box Diagram

Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
Dry with a soft tissue.
Seat Belt Maintenance
Do not bleach, dye or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage will also weaken the fabric.
If the belts need cleaning, use a mild soap solution or
lukewarm water. Do not remove the belts from the
vehicle to wash them.
Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
FUSES
Underhood Fuses (Power Distribution Center)
Power Distribution Center
MAINTAINING YOUR VEHICLE
245
7
A Power Distribution Center is located in the engine
compartment; near the air cleaner. This information ap-
plies to vehicles built without the fuse and relay num-
bering embossed on the Power Distribution Center Top
Cover.
Interior Fuses
The fuse access panel is behind the end cover at the left
side of the instrument panel. To remove the panel, pull it
out, as shown.
The identity of each fuse is indicated on the backside of
the cover.
Cavity
Fuse
Circuit
1
30 Amp
Green
Blower Motor
2
10 Amp
Red
Right High Beam Headlight,
High Beam Indicator
3
10 Amp
Red
Left High Beam Headlight
4
15 Amp
Blue
Power Door Lock Switch Illumi-
nation, Transmission Range
Switch, Daytime Running Light
Module (Canada), Power Win-
dows, Anti-lock Brake System
Module
5
10 Amp
Red
Power Door Lock and Door Lock
Arm/Disarm Switches, Vanity,
Reading, Map, Rear Seating, Igni-
tion, and Trunk Lights, Illumi-
nated Entry, Radio, Power An-
tenna, Data Link Connector, Body
Control Module, Power Amplifier
Fuse Panel Cover
246
MAINTAINING YOUR VEHICLE
Cavity
Fuse
Circuit
6
10 Amp
Red
Heated Rear Window Indicator
7
20 Amp
Yellow
Instrument cluster illumination,
Park and tail Lights
8
20 Amp
Yellow
Power Receptacle, Horns, Igni-
tion, Fuel, Start
9
15 Amp
Blue
Power Door Lock Motors (Body
Control Module)
10
20 Amp
Yellow
Daytime Running Light Module
(Canada)
11
10 Amp
Red
Instrument Cluster, Transmission
Control, Park/Neutral Switch,
Body Control Module
12
10 Amp
Red
Left Low beam Headlight
13
20 Amp
Yellow
Right Low Beam Headlight, Fog
Light Switch
14
10 Amp
Red
Radio
Cavity
Fuse
Circuit
15
10 Amp
Red
Turn Signal and Hazard Flashers,
Wiper Switch, Seat Belt Control
Module, Wiper Relays, Rear Win-
dow Defroster Relay
16
10 Amp
Red
Airbag Control Module
17
10 Amp
Airbag Control Module
18
20 Amp
C/BRKR
Power Seat Switch, Remote Trunk
Release
19
30 Amp
C/BRKR
Power Windows
CAUTION!
When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If a
properly rated fuse continues to blow, it shows a
problem in the circuit that must be corrected.
MAINTAINING YOUR VEHICLE
247
7