Jeep Wrangler - 2005 Fuse Box Diagram

Jeep Wrangler - 2005 Fuse Box Diagram

bulb. If an indicator fails to light when the lever is
moved, it would suggest that the fuse or indicator bulb is
defective.
NOTE:
A tone will chime if the turn signals are left on
for more than 1 mile (2 km).
Daytime Running Lights — Canada Only
The headlights come on at a low intensity level after the
vehicle has been driven approximately 3 feet (1 meter).
They will turn off when the vehicle is turned off or when
the headlights are switched on.
WINDSHIELD WIPERS AND WASHERS
CAUTION!
In cold weather, always turn off the wiper switch
and allow the wipers to return to the park position
before turning off the engine. If the wiper switch is
left on and the wipers freeze to the windshield,
damage to the wiper motor may occur when the
vehicle is restarted.
Intermittent Wiper System
Use the intermittent wiper when weather conditions
make a single wiping cycle, with a variable pause be-
tween cycles, desirable. Move the lever to the DELAY
position, then select the delay interval by turning the end
of the lever. The delay can be regulated from a maximum
of approximately 18 seconds between cycles, to a cycle
every second.
64
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
NOTE:
If the red latch on the connector is locked, push
the red latch to the right until you can only see the latch
on one end (right) of the connector. This will unlock
connector tab, allowing the tab to be pressed down and
enabling the harness to be disconnected from the hard
top.
9. Remove the hard top from the vehicle.
NOTE:
If the doors are to be removed, pull the #4 fuse
from the fuse block to prevent dome lamp illumination.
Hard Top Installation
NOTE:
If the door frames are installed from soft top
usage, they must be removed prior to installation of the
hard top.
1. Inspect the hard top seals for damage and replace if
necessary.
2. Install the hard top using the same steps for removal
in reverse order.
NOTE:
The hard top must be positioned properly to
ensure sealing. Set the hard top on the windshield frame
so that there is no overhang. Also, make sure that the
hard top is sitting flush with the body at the sides and
check to ensure that there is a uniform gap between the
lift glass and hard top.
90
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
If required for certain off-road uses, the side bars can be
removed and the windshield folded down. However, the
protection afforded by these features is then lost. If you
remove the side bars and fold down the windshield,
drive slowly and cautiously. It is recommended that the
speed of the vehicle be limited to 10 mph (16 km/h), with
low range operation preferred, if you are driving off-road
with the windshield folded down.
Raise the windshield and reinstall the side bars as soon as
the task that required their removal is completed and
before you return to on-road driving. Both you and your
passenger should wear seat belts at all times, on-road and
off-road, regardless of whether the windshield is raised
or folded down.
Outside rear view mirrors are mounted on the doors. If
you choose to remove the doors, see your authorized
dealer for a replacement cowl-mounted outside mirror.
Federal law requires outside mirrors on vehicles for
on-road use.
NOTE:
If the doors are removed, the courtesy lights will
remain on. To turn these lights off, remove fuse #4 in the
fuse panel. Refer to “Fuse Panel” in Section 7 of this
manual.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
131
3
off-road driving (4L range only), which will allow crank-
ing the engine without depressing the clutch, follow
these steps:
1. Locate the Power Distribution Center (PDC) in the
engine compartment. Refer to “Fuse Panel” in Section 7
of this manual.
2. Put a 10 Amp fuse in the PDC cavity (#28) marked as
Clutch Override.
NOTE:
A fuse is provided in fuseblock cavity (f19 or
f20) marked as Spare.
3. Be sure to re-engage the clutch interlock safety feature
by following these steps in reverse order when you are
finished off-road driving.
Automatic Transmission
Shifting from D (Drive) to P (Park) or R (Reverse) (or
from
P or
R
to
D)
should
be
done
only
after
the
accelerator pedal is released and the vehicle is stopped.
Be sure to keep your foot on the brake when moving the
shift lever between these gears.
Automatic Shift Controls
184
STARTING AND OPERATING
FUSE PANEL
Interior Fuses
The fuse panel is located behind the glove box.
To access the fuse panel the glove box must be removed.
It is removed by slipping the glove box strap off the hook
and letting the door roll down off its hinges. To reinstall,
position the glove box door at an 8 o’clock orientation,
engage the hinge hook formations on the lower edge of
the glove box door with the hinge pins on the lower edge
of the instrument panel. Tilt the upper edge of the glove
box door upward toward the instrument panel enough to
reattach the glove box strap to the door. Rotate glove box
door to closed position. Open and close to insure proper
installation.
Fuse Panel
286
MAINTAINING YOUR VEHICLE
Cavity
Fuse
Description
1
20 Amp Yel-
low
Park Lights, Skim (Sentry
Key)
2
20 Amp Yel-
low
Stop Lights
3
20 Amp Yel-
low
Subwoofer System
4
10 Amp Red
Door Switch Defeat
5
10 Amp Red
Airbag
6
20 Amp Yel-
low
Rear Wiper
7
10 Amp Red
Back-Up Lights, Rear Win-
dow Defroster Relay, ABS
8
10 Amp Red
HEVAC
9
10 Amp Red
Airbag
10
10 Amp Red
Instrument Cluster
11
10 Amp Red
Solenoids, DRL
Cavity
Fuse
Description
12
10 Amp Red
Power Distribution Relays,
Skim (Sentry Key)
13
10 Amp Red
Turn Signals
14
10 Amp Red
Radio
15
10 Amp Red
HBL (Rear Window De-
froster) Switch
16
10 Amp Red
Headlamp Aim (Export
Only)
17
25 Amp
Natural
Front Wiper
18
20 Amp Yel-
low
Cigar Lighter
19
20 Amp Yel-
low
Spare
20
20 Amp Yel-
low
Spare
MAINTAINING YOUR VEHICLE
287
7
Underhood Fuses (Power Distribution Center)
Your vehicle is equipped with an electrical power distri-
bution center located in the engine compartment near the
battery. This power center houses plug-in “Cartridge”
fuses, ISO relays, and Mini (Micro) fuses.
A label inside the latching cover of the center identifies
each component for ease of replacement, if necessary.
Cartridge and mini (micro) fuses can be obtained from
your authorized dealer.
Cavity
Fuse/Color
Description
1
40 Amp Green
HEVAC
2
40 Amp Green
HBL (Rear Window De-
froster)
3
40 Amp Green
Exterior Lighting
4
40 Amp Green
Radiator Fan
5
20 Amp Yellow
Transmission
6
30 Amp Pink
Starter
7
Open
8
40 Amp Green
ABS Motor
9
20 Amp Yellow
ASD
10
40 Amp Green
HD/LP
11
Open
IOD Storage
12
30 Amp Pink
ABS Valve
Power Distribution Center
288
MAINTAINING YOUR VEHICLE
Cavity
Fuse/Color
Description
13
40 Amp Green
Accessories
14
Open
15
50 Amp Red
IOD
16
Open
17
20 Amp Yellow
Power
18
20 Amp Yellow
Horn
19
20 Amp Yellow
Fog Lights
20
15 Amp Lt. Blue
Radio
21
10 Amp Red
A/C Clutch
22
25 Amp Natural
Ignition Switch
23
20 Amp Yellow
Fuel
24
20 Amp Yellow
Off Road
25
Open
26
10 Amp Red
Accessories
27
20 Amp Yellow
MFSW
28
10 Amp Red
Clutch Override
Cavity
Fuse/Color
Description
29
Relay
ASD
30
Relay
A/C Clutch
31
Relay
Transmission
32
Relay
Starter
33
Relay
ABS
34
Open
35
Relay
Fog Lamp
36
Relay
Horn
37
Relay
Fuel Pump
38
Relay
HBL (Rear Window De-
froster)
39
Relay
Front Differential Locker
(Rubicon) or High Speed
Fan (2.4L Engines)
40
Relay
Rear Differential Locker
(Rubicon) or Low Speed
Fan (2.4L Engines)
MAINTAINING YOUR VEHICLE
289
7