Lincoln Continental - 1999 Fuse Box Diagram

Lincoln Continental - 1999 Fuse Box Diagram

NHTSA recommends a minimum distance of at least 25 cm (ten
[10] inches) between an occupant’s chest and the air bag
module.
Steps you can take to properly position yourself away from the airbag:
Move your seat to the rear as far as you can while still reaching the
pedals comfortably.
Recline the seat slightly (one or two degrees) from the upright
position.
Do not put anything on or over the air bag module. Placing
objects on or over the air bag inflation area may cause those
objects to be propelled by the air bag into your face and torso causing
serious injury.
Do not attempt to service, repair, or modify the Air Bag
Supplemental Restraint System or its fuses. See your Ford or
Lincoln-Mercury dealer.
Children and air bags
For additional important safety
information, read all information on
safety restraints in this guide.
Children must always be properly
restrained. Accident statistics
suggest that children are safer when
properly restrained in the rear
seating positions than in the front
seating position. Failure to follow
these instructions may increase the
risk of injury in a collision.
Seating and safety restraints
102
Determining if the system is operational
The SRS uses a readiness light in the instrument cluster or a tone to
indicate the condition of the system. Refer to the
Air bag readiness
section in the
Instrumentation
chapter. Routine maintenance of the air
bag is not required.
A difficulty with the system is indicated by one or more of the following:
The readiness light will either
flash or stay lit.
The readiness light will not
illuminate immediately after
ignition is turned on.
A series of five beeps will be heard. The tone pattern will repeat
periodically until the problem and light are repaired.
If any of these things happen, even intermittently, have the SRS serviced
at your dealership or by a qualified technician immediately. Unless
serviced, the system may not function properly in the event of a
collision.
Side air bag system (if equipped)
Do not use accessory seat covers. The use of accessory seat
covers may prevent the deployment of the side air bags and
increase the risk of injury in an accident.
Do not lean your head on the door, the side air bag could injure
you as it deploys from the side of the seatback.
Do not attempt to service, repair, or modify the air bag
Supplemental Restraint System, its fuses or the seat cover on a
seat containing an air bag. See your Ford or Lincoln Mercury dealer.
All occupants of the vehicle including the driver should always
wear their safety belts even when an air bag SRS is provided.
AIR
BAG
Seating and safety restraints
105
The air suspension shut-off switch is
located on the left side of the trunk.
If this switch is in the OFF position,
the rear air suspension will not
operate.
On vehicles equipped with
Air Suspension, turn OFF
the Air Suspension switch prior to
jacking, hoisting or towing your
vehicle.
Normal vehicle operation does not
require any action by the driver.
AUTOMATIC TRANSAXLE OPERATION
Brake-shift interlock
This vehicle is equipped with a brake-shift interlock feature that prevents
the gearshift from being moved from P (Park) unless the brake pedal is
pressed.
If you cannot move the gearshift out of P (Park) with the brake pedal
depressed:
1. Apply the parking brake, turn ignition key to LOCK, then remove the
key.
2. Insert the key and turn it to OFF. Apply the brake pedal and shift to N
(Neutral).
3. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift, it is
possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to
Fuses and relays
in the
Roadside
emergencies
chapter.
Do not drive your vehicle until you verify that the brakelamps
are working.
OFF
Driving
125
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause
severe wire damage and could start a fire.
Standard fuse amperage rating and color
COLOR
Fuse
Rating
Mini
Fuses
Standard
Fuses
Maxi
Fuses
Cartridge
Maxi
Fuses
Fuse Link
Cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
Pink
40A
Orange
Green
Orange
50A
Red
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
15
Roadside emergencies
136
Passenger compartment fuse panel
The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the panel cover to access the fuses.
To remove a fuse use the fuse puller tool provided on the fuse panel
cover.
1
2
3
4
5
7
8
9
10
11
17
13
14
15
16
19
20
21
25
26
27
28
29
31
30
36
6
12
18
24
32
33
34
35
37
38
39
40
41
22
23
Roadside emergencies
137
The fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Description
1
5A
Lighting Control Module: Anti-Theft Indicator
Lamp, PWM Dimming Output, Illumination
Lamps for Microphone, RR and LR Door
Ashtrays, Heated Seat Switches, Rear Defrost
Control Switch, EATC Control Panel, Message
Center Switches, Speed Control Switches,
Cigar Lighter, Console and Ashtray
2
10A
Data Link Connector (DLC), Powertrain
Control Module (PCM)
3
15A
Multi-Function Switch, Cornering Lamps,
High Beam and Turn Signal Input to LCM
4
10A
Power Door Locks and Power Windows
Switch Backlights, Radio, Mobile Telephone
Transceiver, Lighting Control Module,
(RUN/ACC Sense), Electronic Day/Night
Mirror
5
10A
Virtual Image Instrument Cluster, Lighting
Control Module (LCM RUN/START Sense),
Autolamp Light Sensor
6
10A
Virtual Image Instrument Cluster, RF
Park/Turn Lamp
7
20A
Power Point
8
20A
Fuel Filler Door Release Switch, Trunk Lid
Relay
9
10A
Air Bag Diagnostic Monitor, EATC Module,
Blower Motor Relay
10
30A
Windshield Wiper Motor, Windshield Wiper
Module
11
10A
Ignition Coils, Radio Interference Capacitor,
PCM Power Relay, Passive Anti-Theft System
(PATS) Transceiver
Roadside emergencies
138
Fuse/Relay
Location
Fuse Amp
Rating
Description
12
10A
Lighting Control Module
13
15A
Lighting Control Module (LCM): RF Turn
Lamp, Right Turn Indicator (VIC), RR Side
Marker Lamps, Tail Lamps, License Lamps,
LR Stop/Turn Lamps, Clock Illumination
14
20A
Cigar Lighter
15
10A
ABS Evac and Fill Connector
16
30A
Moonroof Switch
17
Not Used
18
10A
Lighting Control Module
19
10A
Lighting Control Module (LCM): Left
Headlamp, DRL
20
15A
Multi-Function Switch: Flash to Pass, and
Hazard Warning Input to LCM
21
Not Used
22
——
Not Used
23
10A
Digital Transmission Range Sensor
24
10A
Virtual Image Cluster-LF Turn Indicator, LF
Turn Signal
25
10A
Lighting Control Module (LCM): Right
Headlamp
26
10A
Virtual Image Instrument Cluster, EATC
Module
27
Not Used
28
10A
Shift Lock Actuator, Vehicle Dynamic Module,
Virtual Image Instrument Cluster, Rear
Window Defrost, Heated Seat Switch
Assembly, Low Tire Pressure Module, RESCU
29
10A
Radio
30
10A
Heated Mirrors
Roadside emergencies
139
Fuse/Relay
Location
Fuse Amp
Rating
Description
31
15A
Lighting Control Module (LCM): FCU,
Electronic Day/Night Mirror, RH and LH
Courtesy Lamp, Door Courtesy Lamps, RH
and LH Map Lamps, RR and LR Reading
Lamps, RH and LH Visor Lamps, Storage Bin
Lamps, Trunk Lid Lamp, Glove Box Lamp,
Light Sensor Amplifier
32
15A
Speed Control DEAC. Switch, Brake On/Off
(BOO) Switch
33
Not Used
34
15A
Console Shift Illumination, A/C Clutch
Cycling Pressure Switch, A/C Clutch Relay
(DTR) Sensor, Intake Manifold Runner
Control, Backup Lamps
35
Not Used
36
Not Used
37
30A
Subwoofer Amplifier, Radio
38
10A
Analog Clock, CD Player, Mobile Telephone
Transceiver, RESCU
39
10A
Power Door Locks, Power Seats, Power
Mirrors, Keyless Entry, LF Seat Module, LF
Door Module
40
10A
Cornering Lamps
41
20A
Door Locks
Power distribution box
The power distribution box is located in the engine compartment. The
power distribution box contains high-current fuses that protect your
vehicle’s main electrical systems from overloads.
Always disconnect the battery before servicing high current
fuses.
Roadside emergencies
140
Always replace the cover to the Power Distribution Box before
reconnecting the battery or refilling fluid reservoirs.
The high-current fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Description
175
Generator/Voltage Regulator
1
30A**
Driver’s Seat Module
2
30A**
Passenger’s Seat Module
3
40A**
Ignition Switch
4
40A**
Ignition Switch
5
40A**
Driver Window
6
30A**
Low Speed Cooling Fan
7
30A**
Powertrain Control Module
8
40A**
Rear Window Defrost Control
9
60A**
I/P Fuse Panel
10
60A**
Lighting Control Module
11
60A**
Compressor Relay
12
60A**
Anti-Lock Brake Control Module
13
40A**
Blower Motor
14
60A**
High Speed Cooling Fan
MEGA
175A
PCM
PWR
RELAY
1
2
3
4
8
7
6
5
1
2
4
3
5
7
9
11
10
12
14
13
6
8
NOT USED
7
BLOWER
MOTOR
RELAY
6
A/C
CLUTCH
RELAY
4
NOT
USED
2
HORN
RELAY
3
HIGH
BEAM
1
STARTER
SOL
RELAY
5
1
2
Roadside emergencies
141
Fuse/Relay
Location
Fuse Amp
Rating
Description
1
30A*
PCM
2
20A*
ALT SENSE
3
30A*
Right Rear Passenger Window
4
30A*
Air Suspension
5
Not Used
6
20A*
Horns
7
15A*
High Beam
8
30A*
Right Front Passenger Window
1
A/C Diode
2
PCM Diode
* Mini Fuses ** Maxi Fuses
Auxiliary relay box
The auxiliary relay box is located in the engine compartment. The
auxiliary relay box contains the high and low speed cooling fan relays.
CHANGING THE TIRES
If you get a flat tire while driving, do not apply the brake heavily.
Instead, gradually decrease your speed. Hold the steering wheel firmly
and slowly move to a safe place on the side of the road.
Tire change procedure
To prevent the vehicle from moving when you change a tire, be
sure the parking brake is set, then block (in both directions) the
wheel that is diagonally opposite (other side and end of the vehicle) to
the tire being changed.
If the vehicle slips off the jack, you or someone else could be
seriously injured.
1. Park on a level surface, activate hazard flashers and set parking brake.
2. Place gearshift lever in P (Park) and turn engine OFF.
Roadside emergencies
142