Lincoln Aviator - 2004 Fuse Box Diagram

Lincoln Aviator - 2004 Fuse Box Diagram

CLOCK
Press the right control to increase
the time displayed.
Press the left control to decrease
the time displayed.
AUXILIARY POWER POINT (IF EQUIPPED)
Power outlets are designed for accessory plugs only. Do not hang
any type of accessory or accessory bracket from the plug.
Improper use of the power outlet can cause damage not covered
by your warranty.
The auxiliary power point is located
inside the center console.
Do not plug optional electrical
accessories into the cigarette lighter.
Use the power point.
Do not use the power point for
operating the cigarette lighter
element.
The Maximum power each power point can supply depends on the fuse
rating. For example: a 20A fuse can supply a maximum of 240 Watts, a
15A fuse can supply a maximum of 180 Watts and a 10A fuse can supply
a maximum of 120 Watts. Exceeding these limits will result in a blown
fuse.
Always keep the power point caps closed when not being used.
Driver Controls
101
All occupants of the vehicle, including the driver, should always
properly wear their safety belts, even when an air bag (SRS) is
provided.
Always transport children 12 years old and under in the back
seat and always properly use appropriate child restraints.
The National Highway Traffic Safety Administration (NHTSA)
recommends a minimum distance of at least 25 cm (10 inches)
between an occupant’s chest and the driver air bag module.
Never place your arm over the air bag module as a deploying air
bag can result in serious arm fractures or other injuries.
To properly position yourself away from the air bag:
Move your seat to the rear as far as you can while still reaching the
pedals comfortably.
Recline the seat slightly one or two degrees from the upright position.
Do not put anything on or over the air bag module. Placing
objects on or over the air bag inflation area may cause those
objects to be propelled by the air bag into your face and torso causing
serious injury.
Do not attempt to service, repair, or modify the air bag
supplemental restraint systems or its fuses. See your Ford or
Lincoln Mercury dealer.
Modifying or adding equipment to the front end of the vehicle
(including frame, bumper, front end body structure and tow
hooks) may affect the performance of the air bag system, increasing
the risk of injury. Do not modify the front end of the vehicle.
Additional equipment may affect the performance of the air bag
sensors increasing the risk of injury. Please refer to the Body
Builders Layout Book for instructions about the appropriate installation
of additional equipment.
Seating and Safety Restraints
175
Safety Canopy
Y
system
Do not place objects or
mount equipment on or
near the headliner at the siderail
that may come into contact with a
deploying Safety Canopy
y
. Failure
to follow these instructions may
increase the risk of personal injury
in the event of a collision.
Do not lean your head on the door. The Safety Canopy
y
could
injure you as it deploys from the headliner.
Do not attempt to service, repair, or modify the Safety Canopy
y
system, its fuses, the A, B, or C pillar trim, or the headliner on a
vehicle containing a Safety Canopy
y
. See your Ford or Lincoln
Mercury dealer.
All occupants of the vehicle including the driver should always
wear their safety belts even when an air bag SRS and Safety
Canopy
y
system is provided.
To reduce risk of injury, do not obstruct or place objects in the
deployment path of the inflatable Safety Canopy
y
.
Seating and Safety Restraints
178
2. Locate the access panel on the
driver side of the floor console.
Using a screwdriver (or equivalent),
pry the access panel off the floor
console.
3. Using the screwdriver (or
equivalent), push the white plastic
override mechanism (located behind
the bracket) toward the roof of the
vehicle as shown in the illustration.
4. Move the gearshift lever back to N (Neutral) (two places from P
[Park]).
5. Start the vehicle and release the parking brake.
If it is necessary to use the above procedure to move the gearshift lever,
it is possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to
Fuses and relays
in the
Roadside
emergencies
chapter.
Driving
205
The fuel pump shut-off switch is
located in the passenger’s foot well,
by the kick panel.
Use the following procedure to reset the fuel pump shut-off switch.
1. Turn the ignition to the OFF position.
2. Check the fuel system for leaks.
3. If no fuel leak is apparent, reset the fuel pump shut-off switch by
pushing in on the reset button.
4. Turn the ignition to the ON position. Pause for a few seconds and
return the key to the OFF position.
5. Make a further check for leaks in the fuel system.
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
15
Roadside Emergencies
233
Note:
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause severe wire
damage and could start a fire.
Standard fuse amperage rating and color
COLOR
Fuse
rating
Mini
fuses
Standard
fuses
Maxi
fuses
Cartridge
maxi
fuses
Fuse link
cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
Pink
40A
Orange
Green
Green
50A
Red
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
Passenger compartment fuse panel
The fuse panel is located below the
instrument panel on the driver’s
side.
Roadside Emergencies
234
The fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
1
30A
Moonroof motor, Driver seat
switch
2
10A
VAPS module, Memory seat
module, Body security module,
Tire Pressure Monitor System
(TPMS), Sunload/Autolamp sensor
(SecuriLock
y
LED)
3
20A
Radio, Navigation
4
5A
Front wiper module
5
15A
Flasher relay (turn/hazards)
Roadside Emergencies
235
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
6
5A
Electronic Hidden Antenna
Module (EHAM) (antenna
amplifier), Radio, Moonroof motor,
Driver window motor, Navigation
7
15A
Heated mirrors, DEATC module
8
5A
Daytime Running Lamps (DRL)
module, Heated PCV valve
9
10A
Back-up lamps (DTRS),
Electrochromatic mirror
10
10A
Heated backlight relay coil,
Climate seat modules, Auxiliary
A/C temperature blend/mode
actuator, A/C clutch relay contact
11
20A
Not used (spare)
12
15A
Restraints module
13
10A
Brake shift interlock
14
5A
Not used (spare)
15
5A
Instrument cluster, Rear wiper
module, TPMS
16
15A
Cigar lighter, OBD II
17
15A
Delayed accessory relay coil,
Battery saver relay coil and
contacts
18
5A
Not used (spare)
19
15A
Washer pump
20
5A
Shifter, Clock, Power mirror
switch, DVD
21
10A
Brake pressure switch (ABS), IVD
switch, Flasher relay
22
10A
ABS module
23
7.5A
Liftgate release relay coil and
contacts
Roadside Emergencies
236
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
24
30A
Subwoofer, Navigation
25
5A
Trailer tow battery charge relay
coil
26
5A
SecuriLock
y
transceiver
27
5A
Rear park assist, VAPS module
28
5A
Radio, Navigation
29
10A
DTRS, Feed to Fuse 28
30
5A
Instrument cluster, Compass
module, Auxiliary A/C relay coil
The relays are located on the reverse side of the passenger compartment
fuse panel. To access the relays, you must remove the fuse panel.
Roadside Emergencies
237
Fuse/Relay Location
Description
Relay 1
Flasher relay
Relay 2
Heated backlight relay
Relay 3
Delayed accessory relay
Relay 4
Open
Relay 5
Battery saver relay
Relay 6
Open
Relay 7
Open
Power distribution box
The power distribution box is located in the engine compartment. The
power distribution box contains high-current fuses that protect your
vehicle’s main electrical systems from overloads.
Always disconnect the battery before servicing high current
fuses.
Always replace the cover to the power distribution box before
reconnecting the battery or refilling fluid reservoirs
If the battery has been disconnected and reconnected, refer to the
Battery
section of the
Maintenance and specifications
chapter.
Roadside Emergencies
238
The high-current fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
1
60A**
Power Junction Box (PJB)
2
30A**
Door locks (BSM)
3
Not used
4
40A**
Heated backlight/mirrors
5
40A**
Anti-lock Brake System (ABS)
module (pump)
6
60A**
Delayed accessory
7
20A**
Daytime Running Lamps (DRL)
module
8
20A**
Electric cooling fan
9
20A**
Headlamp switch
10
30A**
ABS module (valves)
11
40A**
PTEC relay contacts
12
50A**
Ignition/Starter relay
13
40A**
Trailer tow relays
14
15A*
Brake lamp feed
15
10A*
Keep alive power
(PTEC/cluster/DEATC)
16
20A*
Power point #3
17
20A*
Rear wiper module
18
20A*
4x4 module
19
30A**
Driver window motor
20
30A**
Electric trailer brakes
21
30A**
Memory seat module
22
20A**
Main exterior lamps (low beam
headlamps, high beam headlamps,
fog lamps)
23
30A**
Ignition switch
24
20A*
Horn relay
25
20A*
Power point #1
26
20A*
Fuel pump relay contacts
27
20A*
Trailer tow lamps
Roadside Emergencies
239
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
28
20A*
Power point #2
29
60A**
PJB
30
30A**
Front wiper module
31
30A**
Climate-controlled seats modules
32
30A**
Passenger seat switch
33
30A**
Auxiliary blower motor
34
20A**
Right HID relay
35
20A**
Left HID relay
36
40A**
Blower motor
37
15A*
A/C clutch relay, TXV,
Transmission, Speed control
38
15A*
HEGO, VMV, Canister vent,
IMCC-LSRC, EGR module
39
15A*
Injectors
40
15A*
PTEC, Mass Air Flow (MAF)
sensor, Fuel pump relay
41
25A*
Coil on plug, PTEC relay
42
10A*
Right low beam (halogen)
43
10A*
Left low beam (halogen)
44
2A*
Heated PCV valve (w/DRL only)
45
2A*
Brake Pressure Switch
46
20A*
High beams/Fog lamps
47
Horn relay
48
Fuel pump relay
49
High beam relay
50
Fog lamp relay
51
Not used
52
A/C clutch relay
53
Trailer tow right turn relay
54
Trailer tow left turn relay
55
Blower motor relay
Roadside Emergencies
240
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
56
Starter motor relay
57
PTEC relay
58
Ignition relay
59
Driver brake applied relay
60
PCM diode
61
A/C clutch diode
62
30A***
Power windows
* Mini Fuses ** Maxi Cartridge Fuses *** Circuit breaker
Auxiliary relay box
The relay box is located on the front
right fender well underneath the
speed control module.
The relays are coded as follows:
Fuse/Relay Location
Description
Relay 1
Left HID relay (
1
±
2
ISO)
Relay 2
Right HID relay (
1
±
2
ISO)
Relay 3
Open
Relay 4
EDF relay (Full ISO)
Roadside Emergencies
241
Rear relay box
The relay box is located on the rear passenger side quarter trim panel.
See your dealer or a certified technician for service of this relay box.
The relays are coded as follows:
Fuse/Relay Location
Description
Relay 1
Liftgate release solenoid
Relay 2
Open
Relay 3
Open
Relay 4
Trailer tow back-up lamps
Relay 5
Open
Relay 6
Open
Relay 7
Trailer tow battery charge
Relay 8
Trailer tow park lamps
Relay 9
Open
Relay 10
Open
Diode 11
Open
Diode 12
Open
Roadside Emergencies
242