Acura TSX - 2006 Fuse Box Diagram

Acura TSX - 2006 Fuse Box Diagram

ʵ
If the driver’s
window senses any obstacle while it
is closing automatically, it will
reverse direction, and then stop. To
close the window, remove the
obstacle, then use the window switch
again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
before closing it.
If your vehicle’s battery is
disconnected or goes dead, or the
driver’s window fuse is removed, the
AUTO function will be disabled. The
power window system needs to be
reset after reconnecting the battery
or installing the fuse.
Start the engine. Push down and
hold the driver’s window switch
until the window is fully open.
Pull and hold the driver’s window
switch to close the window
completely, then hold the switch
for about 2 seconds.
If the power windows do not operate
properly after resetting, have your
vehicle checked by your dealer.
The power window system has a key-
off delay function. The windows will
still operate for up to 10 minutes
after you turn off the ignition switch.
Opening either front door cancels
the delay function. You must turn
the ignition switch to the ON (II)
position again before you can raise
or lower the windows.
1.
2.
AUTO REVERSE
Power Windows
148
ʵ
ʵ
ʵ
CONTINUED
The preset frequencies will be lost if
your vehicle’s battery goes dead, is
disconnected, or the radio fuse is
removed.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
Pick the preset number (1
6)
you want for that station. Press
the button or icon and hold it until
you hear a beep.
Each preset button or icon
can store one frequency on AM, and
two frequencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two frequencies with each preset
button or icon.
To use the SCAN, preset and A.SEL
function, press the AUDIO DISPLAY
button to view these icons.
The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button, or
touch the SCAN icon (models with
navigation system), then release it.
You will see SCAN in the display.
The system will scan for a station
with a strong signal. When it finds
one, it will stop and play that station
for about 5 seconds.
If you do nothing, the system will
then scan for the next strong station
and play it for 5 seconds. When it
plays a station you want to listen to,
press the SCAN button or touch the
SCAN icon again.
Use the TUNE, SEEK, or SCAN
function to tune the radio to a
desired station.
3.
4.
1.
2.
On vehicles with navigation system
Playing the AM/FM Radio
Preset
SCAN
Features
173
When you turn the ignition switch to
the START (III) position, you do not
hear the normal noise of the engine
trying to start. You may hear a
clicking sound or series of clicks, or
nothing at all.
Check these things:
Check the transmission interlock.
If you have a manual transmission,
the clutch pedal must be pushed
all the way to the floor or the
starter will not operate. With an
automatic transmission, it must be
in Park or neutral.
Turn the ignition switch to the ON
(II) position. Turn on the
headlights, and check their
brightness. If the headlights are
very dim or do not come on at all,
the battery is discharged. See
on page
.
Diagnosing why the engine won’t
start falls into two areas, depending
on what you hear when you turn the
ignition switch to the START (III)
position:
You hear nothing, or almost
nothing. The engine’s starter
motor does not operate at all, or
operates very slowly.
You can hear the starter motor
operating normally, or the starter
motor sounds like it is spinning
faster than normal, but the engine
does not start up and run.
Turn the ignition switch to the
START (III) position. If the
headlights do not dim, check the
condition of the fuses. If the fuses
are OK, there is probably something
wrong with the electrical circuit for
the ignition switch or starter motor.
You will need a qualified technician
to determine the problem (see
on page
).
If the headlights dim noticeably or
go out when you try to start the
engine, either the battery is dis-
charged or the connections are
corroded. Check the condition of the
battery connections (see page
).
You can then try jump starting the
vehicle from a booster battery (see
page
).
319
328
319
309
Nothing Happens or the Starter
Motor Operates Very Slowly
Jump Starting
Emergency Towing
If the Engine Won’t Start
Taking Care of the Unexpected
317
In this case, the starter motor’s
speed sounds normal, or even faster
than normal, when you turn the
ignition switch to the START (III)
position, but the engine does not run.
Do you have fuel? Check the fuel
gauge; the low fuel indicator may
not be working.
There may be an electrical
problem, such as no power to the
fuel pump. Check all the fuses
(see page
).
If you find nothing wrong, you will
need a qualified technician to find
the problem. See
on page
.
Are you using the proper starting
procedure? Refer to
on page
.
Are you using a properly coded
key? An improperly coded key will
cause the immobilizer system
indicator in the instrument panel
to blink rapidly (see page
).
330
328
126
241
If the Engine Won’t Start
The Starter Operates Normally
Emergency
Towing
Starting the
Engine
318
Use a screwdriver or coin to
remove the round plug in the
center of the headliner.
Insert the moonroof wrench into
the socket behind this plug. Turn
the wrench until the moonroof is
fully closed.
Remove the wrench. Reinstall the
round plug.
If you need to close the moonroof
manually, it means the moonroof
opening/closing function is
developing a problem. Have your
vehicle checked by your dealer.
If the electric motor will not close
the moonroof, do the following:
Check the fuse for the moonroof
motor (see page
). If the fuse
is blown, replace it with one of the
same or lower rating.
Try closing the moonroof. If the
new fuse blows immediately or the
moonroof motor still does not
operate, you can close the
moonroof manually.
Get the moonroof wrench out of
the tool kit in the trunk.
5.
6.
4.
3.
1.
2.
334
Closing the Moonroof
Taking Care of the Unexpected
327
SOCKET
ROUND PLUG
MOONROOF WRENCH
The interior fuse box is on the
driver’s lower left side. To remove
the fuse box lid, pull it toward you
and take it out of its hinges.
The under-hood fuse box is located
near the back of the engine compart-
ment on the driver’s side. To open it,
push the tabs as shown.
If something electrical in your
vehicle stops working, the first thing
you should check for is a blown fuse.
Determine from the chart on pages
and
, or the diagram on the
fuse box lid, which fuse or fuses
control that component. Check those
fuses first, but check all the fuses
before deciding that a blown fuse is
not the cause. Replace any blown
fuses and check if the device works.
Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are off.
Remove the cover from the fuse
box.
1.
2.
333
334
Checking and Replacing Fuses
Fuses
330
INTERIOR
UNDER-HOOD
NOTCH
TAB
Check each of the large fuses in
the under-hood fuse box by
looking at the wire inside.
Removing these fuses requires a
Phillips-head screwdriver.
Check the smaller fuses in the
under-hood fuse box and all the
fuses in the interior fuse box by
pulling out each one with the fuse
puller provided in the under-hood
fuse box.
Look for a burned wire inside the
fuse. If it is burned out, replace it
with one of the spare fuses of the
same rating or lower.
3.
4.
5.
CONTINUED
Fuses
Taking Care of the Unexpected
331
BLOWN
BLOWN
BLOWN
If you cannot drive the vehicle
without fixing the problem, and you
do not have a spare fuse, take a fuse
of the same rating or a lower rating
from one of the other circuits with
the fuse puller provided in the under-
hood fuse box. Make sure you can
do without that circuit temporarily
(such as the accessory power socket
or radio).
If you replace the blown fuse with a
spare fuse that has a lower rating, it
might blow out again. This does not
indicate anything wrong. Replace the
fuse with one of the correct rating as
soon as you can.
If the replacement fuse of the
same rating blows in a short time,
there is probably a serious
electrical problem with your
vehicle. Leave the blown fuse in
that circuit, and have your vehicle
checked by a qualified mechanic.
If the driver’s power window fuse is
removed, the AUTO function of the
driver’s window will be disabled. You
should reset the AUTO feature, (see
page
).
If the radio fuse is removed, the
audio system will disable itself. The
next time you turn on the radio you
will see ‘‘CODE’’ in the frequency
display. Use the preset buttons to
enter the five-digit code (see page
).
6.
148
201
Fuses
332
FUSE PULLER
Replacing a fuse with one that has a
higher rating greatly increases the
chances of damaging the electrical
system. If you do not have a
replacement fuse with the proper rating
for the circuit, install one with a lower
rating.
ʵ
ʵ
ʴ
No.
Circuits Protected
No.
No.
Amps.
Circuits Protected
CONTINUED
Amps.
Amps.
Circuits Protected
1
2
3
4
5
Left Headlight Low
(Rear Defroster Coil)
Left Headlight Hi
Small Light
Right Headlight Hi
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
20 A
20 A
40 A
40 A
15 A
30 A
40 A
40 A
40 A
40 A
100 A
50 A
50 A
Cooling Fan
Not Used
Horn, Stop
Rear Defroster
Back Up, ACC
Hazard
VSA Motor
VSA
OP 1
OP 2
Heater Motor
Battery
Not Used
B IG1 Main
Power Window Main
15 A
(30 A)
10 A
15 A
10 A
15 A
7.5 A
15 A
20 A
(20 A)
Right Headlight Low
Back Up
FI ECU (ECM/PCM)
Condenser fan
(FR Fog Light)
Fuses
Taking Care of the Unexpected
333
UNDER-HOOD FUSE/RELAY BOX
ʵ
ʵ
ʵ
ʵ
ˎ
ˎ
No.
Amps.
No.
Amps.
Circuits Protected
Circuits Protected
Circuits Protected
No.
Amps.
1
2
3
4
5
6
(15 A)
15 A
(10 A)
10 A
20 A
10 A
7
8
9
10
11
12
10 A
20 A
15 A
7.5 A
30 A
Back-Up Lights
Door Lock
Front Accessory Sockets
OPDS
Wiper
Not Used
DBW
Ignition Coil
Daytime Running Light
LAF
Audio Amp
Interior Light
Passenger’s Power Seat
Reclining
Driver’s Power Seat Sliding
Heated Seat
Driver’s Power Seat Reclining
Passenger’s Power Seat Sliding
ACG
Fuel Pump
Washer
Meter
SRS
IGP (PGM-FI ECU)
Left Rear Power Window
Right Rear Power Window
Passenger’s Power Window
Driver’s Power Window
Moonroof
Not Used
A/C
Not Used
ACC
Not Used
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
20 A
20 A
(20 A)
20 A
(20 A)
15 A
15 A
10 A
7.5 A
10 A
7.5 A
20 A
20 A
20 A
20 A
20 A
7.5 A
7.5 A
: On Canadian models
Fuses
334
INTERIOR FUSE BOX
ʵ
ˎ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ʵ
ˎ
CONTINUED
Specifications
Technical Information
339
Lights
Battery
Alignment
Fuses
Engine
55 W
35 W
12 V
12 V
12 V
12 V
3 CP
21 W
12 V
55 W
Headlights
Front fog lights
Front turn signal
Front parking lights/
Side marker lights
Rear turn signal lights
Stop/Taillights
Taillights
High-mount brake light
Back-up lights
Rear side marker lights
License plate light
Ceiling light
Spotlights/Front ceiling lights
Trunk light
Door courtesy lights
Vanity mirror lights
12 V
1.1 W
2 CP
12 V
12 V
5 W
8 W
12 V
8 W
12 V
12 V
3 CP
3 CP
12 V
12 V
21 W
21 W
12 V
5 W
12 V
12 V
21/5 W
21 W
12 V
Capacity
12 V
36 AH/5 HR
On vehicles with high voltage discharge type headlights,
replacement of a headlight bulb should be performed by your dealer.
Toe-in
Camber
Caster
3°13’
0.08 in (2.0 mm)
0.00 in (0.0 mm)
Interior
Under-hood
Type
Bore x Stroke
Displacement
Compression ratio
Spark plugs
SKJ20DR-M11
IZFR6K-11
10.5 : 1
144 cu-in (2,354 cm
)
3.43 x 3.90 in (87.0 x 99.0 mm)
Water cooled 4-stroke, DOHC
i-VTEC 4-cylinder, gasoline engine
See page
333
or the fuse box
cover.
See page
334
or the fuse label
attached to the inside of the fuse
box door on each side of the
dashboard.
Front
Rear
Front
Rear
Front
High
Low
NGK:
DENSO:
: