Pontiac G5 - 2008 Fuse Box Diagram

Pontiac G5 - 2008 Fuse Box Diagram

PASS-Key
®
III+ Operation
Your vehicle has PASS-Key
®
III+ (Personalized
Automotive Security System) theft-deterrent system.
PASS-Key
®
III+ is a passive theft-deterrent system.
The system is automatically armed when the key
is removed from the ignition.
You do not have to manually arm or disarm the system.
The security light will come on if there is a problem
with arming or disarming the theft-deterrent system.
When the PASS-Key
®
III+ system senses that someone
is using the wrong key, it prevents the vehicle from
starting. Anyone using a trial-and-error method to start
the vehicle will be discouraged because of the high
number of electrical key codes.
When trying to start the vehicle if the engine does not
start and the security light comes on, there may be
a problem with your theft-deterrent system. Turn
the ignition off and try again.
If the engine still does not start, and the key appears to
be undamaged, try another ignition key. At this time,
you may also want to check the fuse, see
Fuses
and Circuit Breakers on page 5-97
. If the engine still
does not start with the other key, your vehicle needs
service. If your vehicle does start, the first key may be
faulty. See your dealer/retailer who can service the
PASS-Key
®
III+ to have a new key made. In an
emergency, contact Roadside Assistance. See
Roadside
Assistance Program on page 7-7
, for more information.
It may be possible for the PASS-Key
®
III+ decoder
to “learn” the transponder value of a new or replacement
key. Up to 10 keys may be programmed for the
vehicle. The following procedure is for programming
additional keys only. If all the currently programmed
keys are lost or do not operate, you must see your
dealer/retailer or a locksmith who can service
PASS-Key
®
III+ to have keys made and programmed to
the system.
See your dealer/retailer or a locksmith who can service
PASS-Key
®
III+ to get a new key blank that is cut
exactly as the ignition key that operates the system.
To program the new key:
1. Verify that the new key has a
1
stamped on it.
2. Insert the already programmed key in the ignition
and start the engine. If the engine will not start, see
your dealer/retailer for service.
3. After the engine has started, turn the key to
LOCK/OFF, and remove the key.
2-19
Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions allow
you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.
To signal a lane change, raise or lower the lever until
the arrow starts to flash. Hold it there until you complete
your lane change. The lever will return by itself when
you release it.
As you signal a turn or a lane change, if the arrows
flash rapidly, a signal bulb may be burned out and other
drivers will not see your turn signal. If a bulb is burned
out, replace it to help avoid an accident.
If the arrows do not go on at all when you signal a turn,
check the fuse. See
Fuses and Circuit Breakers on
page 5-97
.
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to high
beam, push the turn signal lever away from you.
When the high beams are
on, this light on the
instrument panel cluster
will also be on.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.
Flash-to-Pass
This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high-beam headlamps come on, then
release the lever to turn them off.
3-8
Battery Run-Down Protection
Your vehicle has a battery saver feature designed to
protect the vehicle’s battery.
When any interior lamp is left on and the ignition is
turned off, the battery rundown protection system
automatically turns the lamp off after 20 minutes.
This prevents draining of the battery.
Accessory Power Outlet(s)
Accessory power outlets can be used to connect
electrical equipment such as a cellular phone or
CB radio.
The accessory power outlet is located in the center
console, rearward of the shift lever.
To use the accessory power outlet, remove the cover.
When not in use, always cover the accessory power
outlet with the protective cap.
Notice:
Leaving electrical equipment on for
extended periods will drain the battery. Always turn
off electrical equipment when not in use and do
not plug in equipment that exceeds the maximum
amperage rating of 20 amperes.
Certain electrical accessories may not be compatible
with the accessory power outlet and could result
in blown vehicle or adapter fuses. If you experience a
problem, see your dealer/retailer for additional
information on the accessory power outlet.
Notice:
Adding any electrical equipment to your
vehicle may damage it or keep other components
from working as they should. The repairs would not
be covered by your warranty. Do not use equipment
exceeding maximum amperage rating of 20 amperes.
Check with your dealer/retailer before adding
electrical equipment.
When adding electrical equipment, be sure to follow the
installation instructions included with the equipment.
Notice:
Improper use of the power outlet can cause
damage not covered by your warranty. Do not
hang any type of accessory or accessory bracket
from the plug because the power outlets are
designed for accessory power plugs only.
3-18
Ashtray(s) and Cigarette Lighter
Your vehicle may have an ashtray and cigarette lighter.
To use the lighter, located on the instrument panel
below the climate controls, push it in all the way and let
go. When it is ready, it will pop back out by itself.
Notice:
Holding a cigarette lighter in while it is
heating will not allow the lighter to back away from
the heating element when it is hot. Damage from
overheating may occur to the lighter or heating
element, or a fuse could be blown. Do not hold a
cigarette lighter in while it is heating. Do not
use equipment exceeding maximum amperage rating
of 15 amperes.
To clean the center console ashtray, remove the entire
ashtray and empty it.
Notice:
If you put papers, pins, or other flammable
items in the ashtray, hot cigarettes or other
smoking materials could ignite them and possibly
damage your vehicle. Never put flammable items in
the ashtray.
Climate Controls
Climate Control System
The heating, cooling, and ventilation for the vehicle can
be controlled with this system.
Vehicles with Air Conditioning shown,
without Air Conditioning similar
3-19
A. Engine Air Cleaner/Filter. See
Engine Air
Cleaner/Filter on page 5-17
.
B. Engine Oil Fill Cap. See “When to Add Engine Oil”
under
Engine Oil on page 5-13
.
C. Engine Oil Dipstick (Out of View). See “Checking
Engine Oil” under
Engine Oil on page 5-13
.
D. Brake Master Cylinder Reservoir. See “Brake Fluid”
under
Brakes on page 5-30
and
Hydraulic Clutch
on page 5-19
.
E. Engine Compartment Fuse Block. See
Engine
Compartment Fuse Block on page 5-99
.
F. Remote Positive (+) Terminal. See
Jump Starting on
page 5-34
.
G. Remote Negative (
) Terminal. See
Jump Starting
on page 5-34
.
H. Engine Coolant Surge Tank. See
Cooling System on
page 5-24
.
I. Windshield Washer Fluid Reservoir. See “Adding
Washer Fluid” under
Windshield Washer Fluid
on page 5-29
.
Engine Oil
Checking Engine Oil
It is a good idea to check the engine oil every time you
get fuel. In order to get an accurate reading, the oil
must be warm and the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop. See
Engine Compartment Overview on page 5-12
for
the location of the engine oil dipstick.
1. Turn off the engine and give the oil several minutes
to drain back into the oil pan. If you do not do this,
the oil dipstick might not show the actual level.
2. Pull the dipstick and clean it with a paper towel or
cloth, then push it back in all the way. Remove it
again, keeping the tip down and check the level.
5-13
Electrical System
Add-On Electrical Equipment
Notice:
Do not add anything electrical to your
vehicle unless you check with your dealer/retailer
first. Some electrical equipment can damage your
vehicle and the damage would not be covered by
your warranty. Some add-on electrical equipment can
keep other components from working as they should.
Add-on equipment can drain your vehicle’s battery, even
if your vehicle is not operating.
Your vehicle has an airbag system. Before attempting to
add anything electrical to your vehicle, see
Servicing
Your Airbag-Equipped Vehicle on page 1-64
.
Headlamp Wiring
The headlamp wiring is protected by fuses. Should your
headlamps fail to function, have your headlamp
system checked right away.
Windshield Wiper Fuses
The windshield wiper motor is protected by a circuit
breaker and a fuse. If the motor overheats due to heavy
snow, etc., the wiper will stop until the motor cools.
If the overload is caused by some electrical problem,
have it fixed.
Power Windows and Other Power
Options
Fuses in the fuse block protect the power windows.
When the current load is too heavy, the fuse opens
protecting the circuit until the problem is fixed.
5-96
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by a combination of fuses, circuit breakers
and fusible thermal links. This greatly reduces the
chance of damage caused by electrical problems.
Look at the silver-colored band inside the fuse. If the
band is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the identical
size and rating.
If you ever have a problem on the road and do not have
a spare fuse, you can “borrow” one that has the same
amperage. Just pick some feature of your vehicle that
you can get along without — like the radio or cigarette
lighter — and use its fuse if it is the correct amperage.
Replace it as soon as you can.
There are two fuse blocks in your vehicle: the floor
console fuse block and the engine compartment
fuse block.
There is one additional fuse located in the back of the
vehicle near the battery.
Floor Console Fuse Block
The floor console fuse block is located on the passenger
side of the floor console behind the forward panel.
The panel has three clips. Pull the panel to disconnect
the three clips, and access the fuses. Use the fuse
puller to remove fuses.
5-97
Fuses
Usage
1
Fuse Puller
2
Empty
3
Empty
4
Empty
5
Empty
6
Amplifier
7
Cluster
8
Ignition Switch, PASS-Key
®
III
+
9
Stoplamp
10
Heating, Ventilation, Air
Conditioning, PASS-Key
®
III
+
11
Empty
12
Spare
13
Airbag
14
Spare
15
Windshield Wiper
16
Climate Control System, Ignition
17
Window Retained Accessory Power
5-98
Fuses
Usage
18
Empty
19
Electric Power Steering, Steering
Wheel Control
20
Sunroof
21
Spare
22
Empty
23
Audio System
24
XM Radio™, OnStar™
25
Engine Control Module,
Transmission Control Module
26
Door Locks
27
Interior Lights
28
Steering Wheel Control Illumination
29
Power Windows
Relays
Usage
30
Climate Control System
31
Empty
32
Retained Accessory Power (RAP)
Engine Compartment Fuse Block
The engine compartment fuse block is located on the
driver side of the vehicle. Lift off the cover to check the
fuses. See
Engine Compartment Overview on
page 5-12
for more information on location.
Notice:
Spilling liquid on any electrical components
on your vehicle may damage it. Always keep the
covers on any electrical component.
5-99
Fuses
Usage
SPARES
Spares
Blank
Blank
Blank
Blank
REAR DEFOG
Rear Defogger
COOL FAN2
Engine Cooling Fan High Speed
CRNK
Starter
COOL FAN 1
Engine Cooling Fan Low Speed
BCM3
Body Control Module 3
BCM2
Body Control Module 2
FOG LAMP
Fog Lamps
HORN
Horn
RT HI BEAM
Passenger Side High Beam Lamp
LT HI BEAM
Driver Side High Beam Lamp
RT LO BEAM
Passenger Side Low Beam Lamp
LT LO BEAM
Driver Side Low Beam Lamp
DRL
Daytime Running Lamps
FUEL PUMP
Fuel Pump
EXH
Exhaust Emissions
ENG VLV SOL
Engine Valve Solenoid
INJ
Injectors
AIR SOL
Air Solenoid
Blank
Blank
PCM/ECM
Powertrain Control Module/Engine
Control Module
5-100
Fuses
Usage
EPS
Electric Power Steering
AIR PUMP
AIR Pump
PRK LAMP
Parking Lamps
WPR
Windshield Wiper
IP IGN
Ignition
A/C CLTCH
Air Conditioning Clutch
CHMSL
Center High Mount Stop Lamp
ABS2
Antilock Brake System 2
Blank
Blank
ECM/TRANS
Engine Control Module,
Transmission
BCK UP
Back-Up Lamps
TRUNK/HTD
SEATS
Trunk, Heated Seats
Blank
Blank
Blank
Blank
SDM
Sensing Diagnostic Module
(Airbags)
ABS3
Antilock Brake System 3
OUTLET
Auxiliary Power Outlet
MIR
Mirrors
DLC
Data Link Connector
CNSTR VENT
Canister Vent
Relays
Usage
REAR DEFOG
Rear Defogger
AIR SOL
(TURBO:
COOL FAN 2)
Air Solenoid (L61)/Engine Cooling
Fan 2 (LNF)
WPR HI/LO
Windshield Wiper High/Low Speed
CRNK
Starter
COOL FAN 2
(TURBO:
COOL FANS)
Engine Cooling Fan (L61, LE5)/
Engine Cooling Fans (LNF)
FUEL PUMP
Fuel Pump
WPR ON/OFF
Windshield Wiper On/Off
COOL FAN1
Engine Cooling Fans
PWR/TRN
Powertrain
AIR PUMP
AIR Pump
A/C CLTCH
Air Conditioning Clutch
CHMSL
Center High Mount Stop Lamp
RUN/CRNK
Run, Crank
Misc.
Usage
PLR
Fuse Puller
5-101