Pontiac Torrent - 2007 Fuse Box Diagram

Pontiac Torrent - 2007 Fuse Box Diagram

PASS-Key
®
III+ Operation
Your vehicle has PASS-Key
®
III+ (Personalized
Automotive Security System) theft-deterrent
system. PASS-Key
®
III+ is a passive
theft-deterrent system. This means you do not
have to do anything special to arm or disarm the
system. It works when you transition the key
to RUN, ACC or START from the LOCK position.
When the PASS-Key
®
III+ system senses that
someone is using the wrong key, it prevents the
vehicle from starting. Anyone using a trial-and-error
method to start the vehicle will be discouraged
because of the high number of electrical key codes.
If the engine does not start and the security light
on the instrument panel comes on when trying
to start the vehicle, the key may have a damaged
transponder. Turn the ignition off and try again.
If the engine still does not start, and the key
appears to be undamaged, try another ignition
key. At this time, you may also want to check the
fuse, see
Fuses and Circuit Breakers on
page 431
. If the engine still does not start with the
other key, your vehicle needs service. If your
vehicle does start, the first key may be faulty. See
your dealer who can service the PASS-Key
®
III+
to have a new key made. In an emergency,
contact Roadside Assistance.
It is possible for the PASS-Key
®
III+ decoder to
“learn” the transponder value of a new or
replacement key. Up to nine additional keys may
be programmed for the vehicle. The following
procedure is for programming additional keys only.
If all the currently programmed keys are lost or
do not operate, you must see your dealer or
a locksmith who can service PASS-Key
®
III+ to
have keys made and programmed to the system.
See your dealer or a locksmith who can service
PASS-Key
®
III+ to get a new key blank that is cut
exactly as the ignition key that operates the
system.
113
Turn and Lane-Change Signals
The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
An arrow on the
instrument panel cluster
will flash in the
direction of the turn or
lane change.
To signal a lane change, raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete the lane change. The lever will return
by itself when you release it.
As you signal a turn or a lane change, if the
arrows flash rapidly, a signal bulb may be burned
out and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows do not go on at all when you
signal a turn, check the fuse, see
Fuses and Circuit
Breakers on page 431
and for burned-out bulbs.
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to
high, push the turn signal lever away from you. To
change from high beam to low beam, pull the
turn signal lever towards you. To flash the
high beams from low beam, pull the turn signal
lever all the way towards you. Then release it.
When the high beams
are on, this light on the
instrument panel
cluster will also be on.
152
Battery Run-Down Protection
Your vehicle has a battery saver feature designed
to protect the vehicle’s battery.
When any interior lamp is left on and the ignition
is turned off, the battery rundown protection
system will automatically turn the lamp off after
20 minutes. This will avoid draining the battery.
This vehicle also has a retained accessory power
feature. If the radio is on, it will turn off after
10 minutes or if any door on the vehicle is opened.
See
Retained Accessory Power (RAP) on
page 116
.
Accessory Power Outlet(s)
The accessory power outlets can be used to
connect electrical equipment such as a cellular
phone or CB radio.
The accessory power outlets located in front of the
center console storage area, at the rear of the
center console, and the vehicle may have
one located in the rear cargo area.
To use the outlets, remove the cover. When not in
use, always cover the outlet with the protective cap.
Notice:
If electrical devices are left plugged
into a power outlet, the battery may drain
causing your vehicle not to start or damage to
the battery. This would not be covered by
the warranty. Always unplug all electrical
devices when turning off your vehicle.
Certain electrical accessories may not be
compatible with the accessory power outlets and
could result in blown vehicle or adapter fuses.
If you experience a problem, see your dealer for
additional information on the accessory power
outlet.
164
Notice:
Adding any electrical equipment to
your vehicle may damage it or keep other
components from working as they should.
The repairs would not be covered by your
warranty. Do not use equipment exceeding
maximum amperage rating of 20 amperes.
Check with your dealer before adding electrical
equipment.
When adding electrical equipment, be sure to
follow the installation instructions included with the
equipment.
Notice:
Improper use of the power outlet can
cause damage not covered by your warranty.
Do not hang any type of accessory or
accessory bracket from the plug because the
power outlets are designed for accessory
power plugs only.
Ashtray(s) and Cigarette Lighter
Your vehicle may have a removable ashtray and
cigarette lighter. The ashtray can be placed
into the front console cupholders.
To use the lighter, push it in all the way and let
go. When it is ready, it will pop back out by itself.
Notice:
Holding a cigarette lighter in while
it is heating will not allow the lighter to
back away from the heating element when it is
hot. Damage from overheating may occur to
the lighter or heating element, or a fuse could
be blown. Do not hold a cigarette lighter in
while it is heating. Do not use equipment
exceeding maximum amperage rating of
15 amperes.
Notice:
If you put papers, pins, or other
flammable items in the ashtray, hot cigarettes
or other smoking materials could ignite
them and possibly damage your vehicle. Never
put flammable items in the ashtray.
165
Emissions Inspection and Maintenance
Programs
Some state/provincial and local governments have
or may begin programs to inspect the emission
control equipment on your vehicle. Failure to pass
this inspection could prevent you from getting a
vehicle registration.
Here are some things you need to know to help
your vehicle pass an inspection:
Your vehicle will not pass this inspection if the
check engine light is on or not working properly.
Your vehicle will not pass this inspection if
the OBD (on-board diagnostic) system determines
that critical emission control systems have not
been completely diagnosed by the system.
The vehicle would be considered not ready for
inspection. This can happen if you have recently
replaced your battery or if your battery has
run down. The diagnostic system is designed to
evaluate critical emission control systems
during normal driving. This may take several days
of routine driving. If you have done this and
your vehicle still does not pass the inspection for
lack of OBD system readiness, your dealer
can prepare the vehicle for inspection.
Oil Pressure Light
If you have a low engine
oil pressure problem,
this light will stay on after
you start your engine, or
come on when you are
driving.
This indicates that your engine is not receiving
enough oil.
The engine could be low on oil, or could have
some other oil problem. Have it fixed immediately.
The oil light could also come on in three other
situations:
When the ignition is on but the engine is not
running, the light will come on as a test to
show you it is working, but the light will go out
when you turn the ignition to START. If it
does not come on with the ignition on,
you may have a problem with the fuse or bulb.
Have it fixed right away.
187
Engine Compartment Overview
When you open the hood you will see the following:
348
A. Engine Air Cleaner/Filter. See
Engine Air
Cleaner/Filter on page 354
.
B. Engine Oil Fill Cap. See “When to Add Engine
Oil” under
Engine Oil on page 349
.
C. Engine Oil Dipstick. See “Checking Engine Oil”
under
Engine Oil on page 349
.
D. Brake Fluid Reservoir. See
Brakes on
page 369
.
E. Engine Compartment Fuse Block. See
Fuses
and Circuit Breakers on page 431
.
F. Remote Positive (+) Terminal. See
Jump
Starting on page 373
.
G. Engine Coolant Surge Tank. See
Engine
Coolant on page 357
.
H. Windshield Washer Fluid Reservoir. See
Windshield Washer Fluid on page 368
.
Engine Oil
Checking Engine Oil
It is a good idea to check the engine oil every time
you get fuel. In order to get an accurate reading,
the oil must be warm and the vehicle must be
on level ground.
The engine oil dipstick handle is a yellow loop.
See
Engine Compartment Overview on page 348
for the location of the engine oil dipstick.
1. Turn off the engine and give the oil
several minutes to drain back into the oil pan.
If you do not do this, the oil dipstick might
not show the actual level.
2. Pull out the dipstick and clean it with a paper
towel or cloth, then push it back in all the
way. Remove it again, keeping the tip down,
and check the level.
349
Notice:
If you leave your radio or other
accessories on during the jump starting
procedure, they could be damaged. The repairs
would not be covered by your warranty.
Always turn off your radio and other
accessories when jump starting your vehicle.
3. Turn off the ignition on both vehicles. Unplug
unnecessary accessories plugged into the
cigarette lighter or the accessory power outlet.
Turn off the radio and all lamps that are not
needed. This will avoid sparks and help save
both batteries. And it could save your radio!
4. Open the hoods and locate the positive (+)
and negative (
) terminal locations on each
vehicle.
You will not need to access your battery for
jump starting. Your vehicle has a remote
positive (+) and a remote negative (
) jump
starting terminal for that purpose.
The remote positive (+)
terminal is located
under the engine
compartment fuse block
cover, and is marked
with a plus (+) symbol
on the cover. To access
the terminal, remove
the fuse block cover.
The remote negative (
)
terminal is located in the
front of the engine
compartment, near the
engine oil dipstick.
See
Engine Compartment Overview on
page 348
for more information on the location
of the remote positive (+) terminal and the
engine oil dipstick.
374
To disconnect the jumper cables from both
vehicles, do the following:
1. Disconnect the black negative (
) cable from
the vehicle that had the dead battery.
2. Disconnect the black negative (
) cable from
the vehicle with the good battery.
3. Disconnect the red positive (+) cable from the
vehicle with the good battery.
4. Disconnect the red positive (+) cable from the
other vehicle.
5. Return the fuse block cover to its original
position.
All-Wheel Drive
If you have an all-wheel-drive vehicle, be sure to
perform the lubricant checks described in this
section. However, there are two additional systems
that need lubrication.
Transfer Case (Power Transfer Unit)
When to Check Lubricant
Refer to the Maintenance Schedule to determine
how often to check the lubricant. See
Scheduled
Maintenance on page 440
.
378
Electrical System
Add-On Electrical Equipment
Notice:
Do not add anything electrical to your
vehicle unless you check with your dealer
first. Some electrical equipment can damage
your vehicle and the damage would not
be covered by your warranty. Some add-on
electrical equipment can keep other
components from working as they should.
Add-on equipment can drain your vehicle’s battery,
even if your vehicle is not operating.
Your vehicle has an airbag system. Before
attempting to add anything electrical to your
vehicle, see
Servicing Your Airbag-Equipped
Vehicle on page 88
.
Windshield Wiper Fuses
The windshield wiper motor is protected by a
circuit breaker and a fuse. If the motor overheats
due to heavy snow or ice, the wiper will stop
until the motor cools. If the overload is caused by
some electrical problem, have it fixed.
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected
from short circuits by fuses and circuit breakers.
This greatly reduces the chance of circuit overload
and fire caused by electrical problems.
Your vehicle has an underhood fuse block and an
instrument panel fuse block.
To identify and check fuses, circuit breakers, and
relays, refer to the Fuse Usage Chart on the
inside surface of the fuse panel door.
431
Instrument Panel Fuse Block
The instrument panel fuse block is located on the
passenger’s side of the center console, to the
left of the glove box near the floor.
Remove the console cover to access the fuse
block.
Fuses
Usage
1
Sunroof
2
Rear Seat Entertainment
3
Rear Wiper
4
Liftgate
5
Airbags
6
Heated Seats
432
Fuses
Usage
7
Driver’s Side Turn Signal
8
Door Locks
9
Automatic Occupant Sensing
Module
10
Power Mirrors
11
Passenger’s Side Turn Signal
12
Amplifier
13
Steering Wheel Illumination
SPARE
Spare
SPARE
Spare
SPARE
Spare
SPARE
Spare
SPARE
Spare
14
Infotainment
15
Climate Control System, Remote
Function Actuator
16
Canister Vent
17
Radio
18
Cluster
Fuses
Usage
19
Ignition Switch
20
Body Control Module
21
OnStar
®
22
Center High-Mounted Stoplamp,
Dimmer
23
Interior Lights
Relays
Usage
RAP RLY
Retained Accessory Power Relay
REAR DEFOG
RLY
Rear Defogger Relay
Circuit
Breakers
Usage
PWR WNDW
Power Windows
PWR SEATS
Power Seats
EMPTY
Empty
Misc.
Usage
PLR
Fuse Puller
433
Fuses
Usage
26
Spare
27
Stoplamp
28
Passenger’s Side Low-Beam
29
Driver’s Side High-Beam
30
Battery Main 3
32
Spare
33
Engine Control Module, Battery
34
Transmission Control Module,
Battery
35
Trailer Park Lamp
36
Front Wiper
37
Driver’s Side Trailer Stoplamp,
Turn Signal
38
Spare
39
Fuel Pump
40
Not Used
41
All-Wheel Drive
42
Regulated Voltage Control
43
Passenger’s Side Trailer
Stoplamp, Turn Signal
44
Spare
45
Front, Rear Washer
48
Rear Defogger
Fuses
Usage
49
Anti-lock Brake System Motor
50
Battery Main 2
52
Daytime Running Lamps
53
Fog Lamps
54
Climate Control System Blower
57
Battery Main 1
63
Megafuse
Relays
Usage
31
Ignition Main
46
Air Conditioning Compressor Clutch
47
Powertrain
51
Spare
55
Crank
56
Fan 1
58
Passenger’s Side Trailer
Stoplamp, Turn Signal
59
Driver’s Side Trailer Stoplamp,
Turn Signal
60
Fan 3
61
Fan 2
62
Fuel Pump
435