Pontiac Bonneville - 2004 Fuse Box Diagram

Pontiac Bonneville - 2004 Fuse Box Diagram

These are some examples of symbols you may find on your vehicle:
v
Remember, the theft-deterrent system will not activate if
you lock the doors with a key or manual door lock. It
activates only if you use a power door lock switch while
the door is open, or the remote keyless entry
transmitter.
Avoid setting off the alarm by accident.
Always unlock a door with a key, or use the remote
keyless entry transmitter. Unlocking a door any
other way will set off the alarm.
If you set off the alarm by accident, unlock the driver’s
door with your key. You can also turn off the alarm
by pressing the button with the unlock symbol on the
remote keyless entry transmitter. The alarm will not stop
if you try to unlock a door any other way.
Testing the Alarm
1. From inside the vehicle, roll down the window.
2. Activate the system by locking the doors with the
power door lock switch while the door is open, or
with the remote keyless entry transmitter (if
equipped).
3. Get out of the vehicle, close the door and wait for
the SECURITY light to go out.
4. Then, reach in through the window, unlock the door
with the manual door lock and open the door. This
should set off the alarm.
If the alarm does not sound when it should, check to
see if the horn works. The horn fuse may be blown. To
replace the fuse, see
Fuses and Circuit Breakers on
page 5-101
.
If the alarm does not sound, or the exterior lamps do
not flash, see your dealer.
Content Theft-Deterrent
If your vehicle has this option, it has a content
theft-deterrent alarm system.
A light located in your Twilight Sentinel
®
cluster, above
the fog lamp button, will begin to flash 30 seconds
after the vehicle ignition is turned off to let you know the
system has been armed.
While armed, the doors will not unlock with the power
door lock switch.
Once armed, the alarm will go off if someone tries to
enter the vehicle without using the remote keyless entry
transmitter or a key, breaks a window, tries to damage
the vehicle or turns the ignition to ON. If any of these do
occur, the horn will sound and the parking lamps will
flash for up to two minutes.
2-22
When trying to start the vehicle, if the engine does not
start and the SECURITY light comes on, the key
may have a damaged transponder. Turn the ignition off
and try again.
If the engine still does not start, and the key appears to
be undamaged, try another ignition key. At this time,
you may also want to check the fuse. See
Fuses
and Circuit Breakers on page 5-101
. If the engine still
does not start with the other key, your vehicle needs
service. If your vehicle does start, the first key may be
faulty. See your dealer who can service the
PASS-Key
®
III to have a new key made.
It is possible for the PASS-Key
®
III decoder to learn the
transponder value of a new or replacement key. Up
to 10 keys may be programmed for the vehicle.
This procedure is for programming additional keys only.
Canadian Owners:
If you lose or damage your keys,
only a GM dealer can service PASS-Key
®
III to
have new keys made. To program additional keys you
will require two current driver’s keys. You must add
a step to the following procedure. After Step 2 repeat
Steps 1 and 2 with the second current driver’s key. Then
continue with Step 3.
To program the new key, do the following:
1. Verify that the new key has PK3 stamped on it.
2. Insert the current driver’s key in the ignition
and start the engine. If the engine will not start, see
your dealer for service.
3. After the engine has started, turn the key to OFF,
and remove the key.
4. Insert the key to be programmed and turn it to ON
within 10 seconds of removing the previous key.
2-24
Turn and Lane-Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return
automatically.
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by itself
when you release it.
If the arrows flash very fast as you signal a turn or a
lane change, a signal bulb may be burned out and other
drivers will not see your turn signal. If a bulb is burned
out, replace it to help avoid an accident. See
Bulb
Replacement on page 5-52
.
If the arrows do not go on at all when you signal a turn,
check the fuse. See
Fuses and Circuit Breakers on
page 5-101
.
Turn Signal On Chime
If your turn signal is left on for more than 3/4 of a mile
(1.2 km), a chime will sound at each flash of the
turn signal. To turn off the chime, move the turn signal
lever to the off position.
3-8
Accessory Power Outlets
With the accessory power outlet you can plug in
auxiliary electrical equipment such as a cellular
telephone or CB radio.
If your vehicle has a front console, the accessory power
outlet (12-volt ) is located at the rear of the front
console. If your vehicle has a floor console, the outlet is
located at the rear of the floor console.
To use the outlet, remove the protective cap which
covers it. When not using it, always cover the outlet with
the protective cap.
The accessory power outlet will only operate when the
ignition key is in ON and for 10 minutes after turning
the ignition OFF. If you would like the accessory power
outlet to operate regardless of ignition position, and
for extended periods of time, see “Engine Compartment
Fuse Block” under
Fuses and Circuit Breakers on
page 5-101
or see your dealer for more information.
Notice:
Leaving electrical equipment on for
extended periods will drain the battery. Always turn
off electrical equipment when not in use and do
not plug in equipment that exceeds the maximum
amperage rating.
Certain electrical accessories may not be compatible
with the accessory power outlet and could result
in blown vehicle or adapter fuses. If you experience a
problem, see your dealer for additional information
on accessory power outlets.
Notice:
Adding any electrical equipment to your
vehicle may damage it or keep other components
from working as they should. The repairs would not
be covered by your warranty. Check with your
dealer before adding electrical equipment.
When adding electrical equipment, be sure to follow the
proper installation instructions included with the
equipment.
Notice:
Improper use of the power outlet can cause
damage not covered by your warranty. Do not
hang any type of accessory or accessory bracket
from the plug because the power outlets are
designed for accessory power plugs only.
3-25
A. Engine Compartment Fuse Block. See “Engine
Compartment Fuse Block” under
Fuses and Circuit
Breakers on page 5-101
.
B. Windshield Washer Fluid Reservoir. See “Adding
Washer Fluid” under
Windshield Washer Fluid
on page 5-40
.
C. Engine Coolant Recovery Tank. See “Checking
Coolant” under
Engine Coolant on page 5-26
.
D. Radiator Pressure Cap. See
Radiator Pressure Cap
on page 5-28
.
E. Power Steering Fluid Reservoir. See
Power Steering
Fluid on page 5-39
.
F. Engine Oil Dipstick. See “Checking Engine Oil”
under
Engine Oil on page 5-16
.
G. Engine Oil Fill Cap. See “When to Add Engine Oil”
under
Engine Oil on page 5-16
.
H. Automatic Transaxle Fluid Dipstick. See “Checking
the Fluid Level” under
Automatic Transaxle Fluid
on page 5-23
.
I. Brake Master Cylinder. See “Brake Fluid” under
Brakes on page 5-42
.
J. Engine Air Cleaner/Filter. See
Engine Air
Cleaner/Filter on page 5-21
.
5-15
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by a combination of fuses and circuit
breakers. This greatly reduces the chance of damage
caused by electrical problems.
Look at the silver-colored band inside the fuse. If the
band is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the identical
size and rating.
The MaxiFuses are located in two fuse blocks, one in
the engine compartment and the other under the
rear seat. If a MaxiFuse should blow, have your vehicle
serviced by your dealer immediately.
Removing Fuses
You will find a fuse puller attached in both of the fuse
blocks. Snap the wide end of the fuse puller on to
the fuse at the side indentations, then hold the puller
and pull the fuse out.
Engine Compartment Fuse Block
The engine compartment
fuse block is located in the
front of the engine
compartment on the
passenger’s side of the
vehicle. See
Engine
Compartment Overview on
page 5-14
for more
information on location. Lift
the cover to gain access.
Fuse 22 or 23 can be moved to the outer position to
enable the accessory power outlet or cigarette lighter
when the ignition is not on. See your dealer for
additional assistance, if needed.
5-101
Fuses
Usage
1
Not Used
2
Accessory
3
Windshield Wipers
4
Not Used
5
Headlamp Low-Beam Left
6
Headlamp Low-Beam Right
7
Spare
8
Powertrain Control Module Battery
9
Headlamp High-Beam Right
Fuses
Usage
10
Headlamp High-Beam Left
11
Ignition 1
12
Not Used
13
Transaxle
14
Cruise Control
15
Direct Ignition System
16
Injector Bank #2
17
Not Used
18
Not Used
19
Powertrain Control Module Ignition
20
Oxygen Sensor
21
Injector Bank #1
22
Auxiliary Power
23
Cigar Lighter
24
Fog Lamps/Daytime Running Lamps
25
Horn
26
Air Conditioning Clutch
5-102
Relays
Usage
27
Headlamp High Beam
28
Headlamp Low Beam
29
Fog Lamps
30
Daytime Running Lamps
31
Horn
32
Air Conditioning Clutch
33
HVAC Solenoid
34
Accessory
35
Not Used
36
Starter 1
37
Cooling Fan 1
38
Ignition 1
39
Cooling Fan Series/Parallel
40
Cooling Fan 2
Circuit
Breakers
Usage
41
Starter
Fuses
Usage
42
Not Used
43
Not Used
44
Antilock Brake System
45
Not Used
46
Cooling Fan 1
47
Cooling Fan 2
48
Spare
49
Spare
50
Spare
51
Spare
52
Spare
53
Fuse Puller
5-103
Removing the Rear Seat Cushion
Notice:
If you touch the exposed wires with the
metal on the seat cushion, you could cause a short
that could damage the battery and or wires. Avoid
contact between the rear seat and the fuse center
whenever you remove or reinstall the rear seat. Do
not remove covers from any of the covered parts, and
do not store anything under the seats.
To remove the rear seat cushion, do the following:
1. Pull up on the front of the cushion to release the
front hooks.
2. Pull the cushion up and out toward the front of the
vehicle.
To reinstall the rear seat cushion, do the following:
{
CAUTION:
A safety belt that isn’t properly routed through
the seat cushion or is twisted won’t provide
the protection needed in a crash. If the safety
belt hasn’t been routed through the seat
cushion at all, it won’t be there to work for the
next passenger. The person sitting in that
position could be badly injured. After
reinstalling the seat cushion, always check to
be sure that the safety belts are properly
routed and are not twisted.
5-104
1. Buckle the center passenger position safety belt,
then route the safety belts through the proper slots
in the seat cushion. Do not let the safety belts
get twisted.
2. Slide the rear of the cushion up and under the
seatback so the rear locating guides hook into
the wire loops on the back frame.
3. With the seat cushion lowered, push rearward and
then press down on the seat cushion until the
spring locks on both ends engage.
4. Check to make sure the safety belts are properly
routed and that no portion of any safety belt is
trapped under the seat. Also make sure the seat
cushion is secured.
Rear Underseat Fuse Block
The rear fuse block is
located below the rear seat
on the driver’s side of the
vehicle. The rear seat
cushion must be removed
to access the fuse block.
See
Removing the Rear
Seat Cushion on
page 5-104
.
5-105
Fuses
Usage
1
Fuel Pump
2
Heater, Ventilation, Air Conditioning
Blower
3
Memory Seat
4
Assembly Line Diagnostic Link
5
Not Used
6
Compact Disc (CD)
7
Driver Door Module
8
Supplemental Inflatable Restraint
9
Not Used
Fuses
Usage
10
Lamps Park Right
11
Ventilation Solenoid
12
Ignition 1
13
Lamps Park Left
14
Interior Lamp Dimmer Module
15
Satellite Digital Radio
16
Heated Seat Left Front
17
Not Used
18
Rear Door Modules
19
Stoplamps
20
PARK (P) / REVERSE (R)
21
Audio
22
Retained Accessory Power
23
Not Used
24
Not Used
25
Passenger Door Module
26
Body
5-106
Fuses
Usage
27
Interior Lamps
28
Not Used
29
Ignition Switch
30
Instrument Panel
31
Heated Seat Right Front
32
Not Used
33
Heating, Ventilation, Air Conditioning
34
Ignition 3 Rear
35
Antilock Brake System
36
Turn Signal/Hazard
37
HVAC Battery
38
Dash Integration Module
Relays
Usage
39
Fuel Pump
40
Parking Lamps
41
Ignition 1
42
Rear Fog Lamps
43
Not Used
44
Park Brake
45
Reverse Lamps
46
Retained Accessory Power
48
Not Used
49
Ignition 3
51
Interior Lamps
52
Trunk Release
53
Front Courtesy Lamps
54
Not Used
55
Electronic Level Control Compressor
5-107
Circuit
Breakers
Usage
56
Power Seats
57
Power Windows
Relays
Usage
58
Cigarette Lighter
59
Rear Defog
Fuses
Usage
60
Not Used
61
Rear Defog
62
Not Used
63
Audio Amplifier
Fuses
Usage
64
Electronic Level Control
Compressor/Exhaust
65
Cigarette Lighter
66
Not Used
67
Not Used
68
Not Used
69
Spare
70
Spare
71
Spare
72
Spare
73
Spare
74
Spare
75
Fuse Puller
5-108