Pontiac Grand Am - 2002 Fuse Box Diagram

Pontiac Grand Am - 2002 Fuse Box Diagram

2-37
Turn and Lane-Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return automatically.
An arrow on the instrument
panel cluster will flash in
the direction of the turn or
lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change, if the arrows flash
rapidly, a signal bulb may be burned out and other
drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a turn, check for burned
-
out bulbs and then check
the fuse (see “Fuses and Circuit Breakers” in the Index).
Lamps On Reminder
If you open the driver’s door and turn off the
ignition while leaving the lamps on, you will hear a
warning chime.
Headlamp High/Low-Beam Changer
To change the headlamps from low beam to high beam,
push the turn signal/multifunction lever away from you.
When the high beams are
on, a light on the instrument
panel cluster also will be on
if the ignition is in ON.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.
Flash-to-Pass
This feature lets you use your high
-
beam headlamps to
signal a driver in front of you that you want to pass.
To use it, pull the turn signal/multifunction lever toward
you until the high
-
beam headlamps come on, then
release the lever to turn them off.
2-53
The main components of your instrument panel are the following:
A.
Fog Lamp Button
B.
Instrument Panel Brightness Thumbwheel
C.
Turn Signal/Multifunction Lever
D. Horn
E.
Instrument Panel Cluster
F.
Windshield Wiper/Washer Lever
G.
Ignition Switch
H.
Enhanced Traction System Button
I.
Hazard Warning Flashers Button
J.
Instrument Panel Fuse Blocks
K.
Hood Release Handle
L.
Tilt Wheel Lever
M. Audio System Steering Wheel Controls
(If Equipped)
N.
Cruise Control Buttons (If Equipped)
O.
Shift Lever
P.
Cigarette Lighter
Q.
Climate Control System
R.
Audio System
2-66
Oil Pressure Light
If you have a low engine oil
pressure problem, this light
will stay on after you start
your engine, or come on
and you will hear a chime
when you are driving.
This indicates that your engine is not receiving enough
oil. The engine could be low on oil, or could have some
other oil problem. Have it fixed immediately.
When the ignition is on but the engine is not running,
the light will come on as a test to show you it is
working, but the light will go out when the engine is
running. If it doesn’t come on with the ignition on, you
may have a problem with the fuse or bulb. Have it fixed
right away.
CAUTION:
Don’t keep driving if the oil pressure is low. If
you do, your engine can become so hot that it
catches fire. You or others could be burned.
Check your oil as soon as possible and have
your vehicle serviced.
NOTICE:
Damage to your engine from neglected oil
problems can be costly and is not covered by
your warranty.
4-31
Dinghy Towing
To tow your vehicle with all four wheels on the ground,
follow these steps:
1.
Position the vehicle to tow and then secure it.
2.
Turn the ignition switch to OFF.
3.
Set the parking brake.
4.
To prevent your battery from draining while towing,
remove the following fuses from the left side
instrument panel fuse block: WIPER, PCM ACC
and IPC/BFC ACC. See “Instrument Panel Fuse
Block
-
Driver’s Side” in the Index for the location
of these fuses.
5.
Turn the ignition switch to ACCESSORY.
6.
Shift your transaxle to NEUTRAL (N).
7.
Release the parking brake.
4-32
Remember to reinstall the fuses once you reach your
destination. To reinstall a fuse do the following:
1.
Set the parking brake.
2.
Remove the key from the ignition switch.
3.
Put the fuse back in.
NOTICE:
Make sure that the towing speed does not exceed
65 mph (110 km/h), or your vehicle could be
badly damaged.
NOTICE:
Do not tow your vehicle from the rear. Your
vehicle could be badly damaged and the repairs
would not be covered by your warranty.
6-11
Engine Compartment Overview
When you open the hood on the 2.2L L4 ECOTEC
t
Engine, you’ll see the following:
A.
Engine Coolant Surge Tank
B.
Engine Oil Dipstick
C.
Engine Oil Fill Cap
D.
Brake Fluid Reservoir
E.
Power Steering Fluid Reservoir
F.
Engine Compartment
Fuse Block
G.
Engine Air Cleaner/Filter
H. Battery
I.
Windshield Washer
Fluid Reservoir
6-19
How to Reset the Change Oil Light
The GM Oil Life System
t
calculates when to change
your engine oil and filter based on vehicle use. Anytime
your oil is changed, reset the system so it can calculate
when the next oil change is required. If a situation
occurs where you change your oil prior to a CHANGE
OIL light being turned on, reset the system.
After changing the engine oil, the system must be reset.
To reset the oil life indicator, do the following steps:
1.
With the ignition key in ON (a short time
after turning off the engine), press the RESET
button located in the driver’s side instrument
panel fuse block.
2.
When the CHANGE OIL light starts to flash, press
and hold the RESET button again.
The reset is complete when you hear the chimes and the
CHANGE OIL light goes out.
If your vehicle is equipped with a 2.2L L4 ECOTEC
engine, it has a unique oil filter element. When reinstalling
the filter cap do not exceed 18 lb
-
ft (25 N·m). Inspect the
condition of the O
-
ring and replace if damaged.
See your dealer for additional information.
What to Do with Used Oil
Used engine oil contains certain elements that may be
unhealthy for your skin and could even cause cancer.
Don’t let used oil stay on your skin for very long. Clean
your skin and nails with soap and water, or a good hand
cleaner. Wash or properly throw away clothing or rags
containing used engine oil. See the manufacturer’s
warnings about the use and disposal of oil products.
Used oil can be a threat to the environment. If you
change your own oil, be sure to drain all the oil from
the filter before disposal. Never dispose of oil by putting
it in the trash, pouring it on the ground, into sewers,
or into streams or bodies of water. Instead, recycle it
by taking it to a place that collects used oil. If you
have a problem properly disposing of your used oil,
ask your dealer, a service station or a local recycling
center for help.
6-58
Electrical System
Add-On Electrical Equipment
NOTICE:
Don’t add anything electrical to your vehicle
unless you check with your dealer first. Some
electrical equipment can damage your vehicle
and the damage wouldn’t be covered by your
warranty. Some add
-
on electrical equipment
can keep other components from working as
they should.
Your vehicle has an air bag system. Before attempting to
add anything electrical to your vehicle, see “Servicing
Your Air Bag
-
Equipped Vehicle” in the Index.
Windshield Wipers
The windshield wiper motor is protected by a circuit
breaker and a fuse. If the motor overheats due to heavy
snow, etc., the wiper will stop until the motor cools. If
the overload is caused by some electrical problem, have
it fixed.
Power Windows
A circuit breaker in the fuse panel protects the power
windows. When the current load is too heavy, the circuit
breaker opens and closes, protecting the circuit until the
problem is fixed.
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by a combination of fuses, circuit breakers
and fusible links. This greatly reduces the chance of
damage caused by electrical problems.
Look at the silver
-
colored band inside the fuse. If the
band is broken or melted, replace the fuse. Be sure to
replace a bad fuse with a new one of the identical size
and rating.
There are three fuse blocks in your vehicle: two
instrument panel fuse blocks and the engine
compartment fuse block.
Instrument Panel Fuse Blocks
There are two fuse panels for your vehicle. One is
located on the driver’s side of the instrument panel and
the other is located on the passenger’s side.
6-59
Instrument Panel Fuse Block
--
Driver’s Side
Fuse
Usage
WIPER
Windshield Wiper Motor,
Washer Pump
TRUNK REL/
RADIO AMP
Trunk Release Relay/Motor,
Audio Amplifier/RFA
TURN LPS
Turn Signal Lamps
PWR MIRROR
Power Mirrors
Fuse
Usage
AIR BAG
Air Bags
BFC BATT
Body Computer (BFC)
PCM ACC
PCM
DR LOCK
Door Lock Motors
IPC/BFC ACC
Cluster, Body Computer (BFC)
STOP LPS
Stop Lamps
HAZARD LPS
Hazard Lamps
IPC/
HVAC BATT
HVAC Head, Cluster, Data
Link Connector
Circuit Breaker
Usage
PWR SEAT
Power Seats
Relay
Usage
TRUN REL
Trunk Relay
DR UNLOCK
Door Unlock Relay
DR LOCK
Door Lock Relay
DRIVER
DR UNLOCK
Driver’s Door Unlock Relay
6-60
Instrument Panel Fuse Block
--
Passenger’s Side
Fuse
Usage
INST LPS
Interior Lamp Dimming
CRUISE
SW LPS
Steering Wheel Cruise Control
Switch Lamps
CRUISE SW
Steering Wheel Cruise
Control Switches
HVAC
BLOWER
HVAC Blower Motor
CRUISE
Cruise Control
FOG LPS
Fog Lamps
INT LPS
Interior Courtesy Lamps
RADIO BATT
Radio
SUNROOF
Power Sunroof
Circuit Breaker
Usage
PWR WNDW
Power Windows
Relay
Usage
FOG LPS
Fog Lamps
6-61
Engine Compartment Fuse Block
The engine compartment fuse block is located near the
battery in the engine compartment on the driver’s side of
the vehicle.
Maxifuses
Usage
1
Ignition Switch
2
Right Electrical Center
-
Fog
Lamps, Radio, Body Function
Control Module, Interior Lamps
Maxifuses
Usage
3
Left Electrical Center
-
Stop
Lamps, Hazard Lamps, Body
Function Control Module, Cluster,
Climate Control System
4
Anti
-
Lock Brakes
5
Ignition Switch
6
Not Used
7
Left Electrical Center
-
Power
Seats, Power Mirrors, Door Locks,
Trunk Release, Audio Amplifier,
Remote Lock Control
8
Cooling Fan #1
Mini Relays
Usage
9
Rear Defog
10
Not Used
11
Not Used
12
Cooling Fan #1
13
HVAC Blower (Climate Control)
14
Cooling Fan #2
15
Cooling Fan
6-62
Micro Relays
Usage
16
Air Conditioning Compressor
17
Not Used
18
Fuel Pump
19
Automatic Light Control
20
Automatic Light Control
21
Horn
22
Daytime Running Lamps (DRL)
Minifuses
Usage
23
-
32
Spare Fuse Holder
33
Rear Defog
34
Accessory Power Outlets,
Cigarette Lighter
35
Not Used
36
Not Used
37
Air Conditioning Compressor,
Body Function Control Module
Minifuses
Usage
38
Automatic Transaxle
39
Powertrain Control
Module (PCM)
40
Anti
-
Lock Brakes (ABS), Variable
Effort Steering
41
Ignition System
42
Back
-
Up Lamps,
Automatic Transaxle Shift
Lock Control System
43
Horn
44
Powertrain Control Module
45
Parking Lamps
46
Climate Control System,
Air Conditioning
47
Canister Vent Valve, Exhaust
Oxygen Sensors
48
Fuel Pump, Injectors