Oldsmobile Bravada - 2001 Fuse Box Diagram

Oldsmobile Bravada - 2001 Fuse Box Diagram

2-17
Testing the Alarm
The alarm can be tested by following these steps:
1.
From inside the vehicle, lower the driver’s window
and open the driver’s door.
2.
Activate the system by locking the doors with the
power door lock switch (with the door open), or with
the remote keyless entry transmitter (door can be
open or closed).
3.
Wait for the SECURITY light to go out.
4.
Then reach in through the window, unlock the
door with the manual door lock and open the door.
This should set off the alarm.
If the alarm does not sound when it should but the
vehicle’s headlamps flash, check to see if the horn
works. The horn fuse may be blown. To replace the fuse,
see “Fuses and Circuit Breakers” in the Index.
If the alarm does not sound or the vehicle’s headlamps
do not flash, the vehicle should be serviced by an
authorized service center.
Passlock
R
Your vehicle is equipped with the Passlock
theft
-
deterrent system.
Passlock is a passive theft
-
deterrent system. Passlock
enables fuel if the ignition lock cylinder is turned with a
valid key. If a correct key is not used or the ignition lock
cylinder is tampered with, fuel is disabled.
During normal operation, the SECURITY light will go off
approximately five seconds after the key is turned to RUN.
If the engine stalls and the SECURITY light flashes,
wait about 10 minutes until the light stops flashing
before trying to restart the engine. Remember to release
the key from START as soon as the engine starts.
If the engine does not start after three tries, the vehicle
needs service.
If the engine is running and the SECURITY light comes
on, you will be able to restart the engine if you turn the
engine off. However, your Passlock system is not working
properly and must be serviced by your dealer. Your vehicle
is not protected by Passlock at this time. You may also
want to check the fuse (see “Fuses and Circuit Breakers”
in the Index). See your dealer for service.
In an emergency, call the Roadside Assistance Center.
See “Roadside Assistance” in the Index.
2-21
3.
If your engine still won’t start (or starts but then
stops), wait 15 seconds and start over.
When the engine starts, let go of the key and the
accelerator pedal.
NOTICE:
Your engine is designed to work with the
electronics in your vehicle. If you add electrical
parts or accessories, you could change the way
the engine operates. Before adding electrical
equipment, check with your dealer. If you don’t,
your engine might not perform properly.
Engine Coolant Heater (If Equipped)
In very cold weather, 0
_
F (
-
18
_
C) or colder, the engine
coolant heater can help. You’ll get easier starting and
better fuel economy during engine warm
-
up. Usually,
the coolant heater should be plugged in a minimum of
four hours prior to starting your vehicle.
To Use the Engine Coolant Heater
1.
Turn off the engine.
2.
Open the hood and unwrap the electrical cord.
The cord is located on the driver’s side of the engine
compartment, behind the underhood fuse block.
3.
Plug it into a normal, grounded 110
-
volt AC outlet.
CAUTION:
Plugging the cord into an ungrounded outlet
could cause an electrical shock. Also, the wrong
kind of extension cord could overheat and cause
a fire. You could be seriously injured. Plug the
cord into a properly grounded three
-
prong
110
-
volt AC outlet. If the cord won’t reach, use a
heavy
-
duty three
-
prong extension cord rated for
at least 15 amps.
4.
Before starting the engine, be sure to unplug
and store the cord as it was before to keep it
away from moving engine parts. If you don’t,
it could be damaged.
2-32
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
D
Turn and Lane Change Signals
D
Headlamp High/Low
-
Beam Changer
D
Flash
-
to
-
Pass
D
Windshield Wipers
D
Windshield Washer
D
Cruise Control
Turn and Lane Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the lever all the way up or down.
When the turn is finished, the lever will return automatically.
An arrow on the instrument
panel cluster will flash in
the direction of the turn or
lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
As you signal a turn or a lane change, if the arrows flash
more quickly than normal, a signal bulb may be burned
out and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a turn, check the fuse (see “Fuses and Circuit
Breakers” in the Index) and for burned
-
out bulbs.
2-55
Accessory Power Outlets
With the accessory power outlets, you can plug in
auxiliary electrical equipment. The accessory power outlets
are located near the center of the vehicle on the lower part
of the instrument panel. Just remove the plug from the
outlet and follow the proper installation instructions that
are included with any electrical equipment you install.
Certain accessory power plugs may not be compatible
to the accessory power outlets and could result in blown
vehicle or adaptor fuses. If you experience a problem
see your dealer for additional information on the power
accessory plugs.
These circuits are protected by a fuse and have
maximum current levels.
NOTICE:
Adding some electrical equipment to your vehicle
can damage it or keep other things from working
as they should. This wouldn’t be covered by your
warranty. Check with your dealer before adding
electrical equipment, and never use anything that
exceeds the fuse rating.
OnStar
R
System (If Equipped)
OnStar is a vehicle communications system that
offers a variety of services and provides a hands
-
free
communication link between you and the OnStar Center.
A service subscription agreement and fee are required in
order to receive OnStar service. Services are available
24 hours a day, 7 days a week. For more information,
call 1
-
888
-
ONSTAR
-
7 (1
-
888
-
667
-
8277).
OnStar Services Button:
Press this button once
to contact an advisor who will be able to assist you with
these services. If you are not quickly connected, the
system will automatically reset and redial. This ensures
connection to the center; there is no additional action
required. Press the Call Answer/End button to cancel
the automatic redial.
4-51
Maintenance When Trailer Towing
Your vehicle will need service more often when you’re
pulling a trailer. See the Maintenance Schedule for
more on this. Things that are especially important
in trailer operation are automatic transmission fluid
(don’t overfill), engine oil, axle lubricant, belt, cooling
system and brake system. Each of these is covered
in this manual, and the Index will help you find them
quickly. If you’re trailering, it’s a good idea to review
these sections before you start your trip.
Check periodically to see that all hitch nuts and
bolts are tight.
Trailer Wiring Harness
The trailer wiring harness is an eight
-
wire harness
assembly. The harness is stored under the vehicle,
on the driver’s side corner frame crossmember.
The harness is fused in the engine compartment fuse
block. See “Fuses and Circuit Breakers” in the
Index. The harness does not have a connector and
should be wired by a qualified electrical technician.
The technician can use the following color code chart
when connecting the wiring harness to your trailer.
D
Dark Blue: Use for electric trailer brakes or
auxiliary wiring.
D
Red: Use for battery charging; it connects to the
starter solenoid.
D
Light Green: Back
-
up lamps.
D
Brown: Taillamps and parking lamps.
D
Yellow: Left stoplamp and turn signal.
D
Dark Green: Right stoplamp and turn signal.
D
White: Ground wire.
D
Light Blue: Auxiliary stoplamp.
Securely attach the harness to the trailer, then tape or
strap it to your vehicle’s frame rail. Be sure you leave
it loose enough so the wiring doesn’t bend or break,
but not so loose that it drags on the ground. Store the
harness in its original place. Wrap the harness together
and tie it neatly so it won’t be damaged.
6-9
Engine Compartment Overview
When you lift the hood, you’ll see these items:
A. Battery
B.
Coolant Recovery Tank
C.
Engine Oil Dipstick
D.
Engine Oil Fill
E.
Transmission Dipstick
F.
Power Steering Reservoir
G.
Brake Master Cylinder
H.
Engine Air Cleaner/Filter
I.
Engine Compartment
Fuse Block
J.
Windshield Washer
Fluid Reservoir
6-54
Electrical System
Add-On Electrical Equipment
NOTICE:
Don’t add anything electrical to your vehicle
unless you check with your dealer first. Some
electrical equipment can damage your vehicle
and the damage wouldn’t be covered by your
warranty. Some add
-
on electrical equipment
can keep other components from working as
they should.
Your vehicle has an air bag system. Before attempting to
add anything electrical to your vehicle, see “Servicing
Your Air Bag
-
Equipped Vehicle” in the Index.
Headlamps
The headlamp wiring is protected by an internal circuit
breaker. An electrical overload will cause the lamps
to go on and off, or in some cases to remain off.
If this happens, have your headlamp wiring checked
right away.
Windshield Wipers
The windshield wiper motor is protected by a circuit
breaker and a fuse. If the motor overheats due to heavy
snow or ice the wiper will stop until the motor cools.
If the overload is caused by some electrical problem,
be sure to get it fixed.
Power Windows and Other Power Options
Circuit breakers protect the power windows and other
power accessories. When the current load is too heavy,
the circuit breaker opens and closes, protecting the
circuit until the problem is fixed or goes away.
6-55
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by a combination of fuses and circuit
breakers. This greatly reduces the chance of fires caused
by electrical problems.
Look at the silver
-
colored band inside the fuse. If the
band is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the identical size
and rating.
If you ever have a problem on the road and don’t have
a spare fuse, you can borrow one that has the same
amperage. Just pick some feature of your vehicle that
you can get along without
--
like the radio or cigarette
lighter
--
and use its fuse, if it is the correct amperage.
Replace it as soon as you can.
Instrument Panel Fuse Block
The fuse block is located
at the driver’s end of the
instrument panel.
Remove the cover by turning the fastener
counterclockwise. Extra fuses and the fuse extractor
are provided in the cover. To reinstall the fuse panel
cover, push in and turn the fastener clockwise.
6-56
Fuse/Circuit
Breaker
Usage
A
Not Used
B
Not Used
1
Not Used
2
Cigarette Lighter,
Data Link Connector
Fuse/Circuit
Breaker
Usage
3
Cruise Control Module and
Switch, Body Control Module,
Heated Seats
4
Gages, Body Control Module,
Instrument Panel Cluster
5
Parking Lamps, Power Window
Switch, Body Control Module,
Ashtray Lamp
6
Steering Wheel Radio Controls
7
Headlamp Switch, Body Control
Module, Headlamp Relay
8
Courtesy Lamps, Battery
Run
-
Down Protection
9
Not Used
10
Turn Signal
11
Cluster, Engine Control Module
12
Interior Lights
13
Auxiliary Power
14
Power Locks Motor
6-57
Fuse/Circuit
Breaker
Usage
15
4WD Switch, Engine Controls
(VCM, PCM, Transmission)
16
Supplemental Inflatable Restraint
17
Front Wiper
18
Steering Wheel Radio Controls
19
Radio, Battery
20
Amplifier
21
HVAC I (Automatic),
HVAC Sensors (Automatic)
22
Anti
-
Lock Brakes
23
Rear Wiper
24
Radio, Ignition
Engine Compartment Fuse Block
The fuse block is located under the hood on the
driver’s side of the engine compartment. See “Engine
Compartment Overview” in the Index for more
information on location.
Remove the cover by turning the fastener
counterclockwise. To reinstall the fuse panel cover,
push in and turn the fastener clockwise.
6-58
Name
Usage
TRL TRN
Trailer Left Turn
TRR TRN
Trailer Right Turn
TRL B/U
Trailer Back
-
Up Lamps
VEH B/U
Vehicle Back
-
Up Lamps
RT TURN
Right Turn Signal Front
Name
Usage
LT TURN
Left Turn Signal Front
HDLP W/W
Not Used
LT TRN
Left Turn Signal Rear
RT TRN
Right Turn Signal Rear
RR PRK
Right Rear Parking Lamps
TRL PRK
Trailer Parking Lamps
LT HDLP
Left Headlamp
RT HDLP
Right Headlamp
FR PRK
Front Parking Lamps
INT BAT
I/P Fuse Block Feed
ENG I
Engine Sensors/Solenoids, MAF,
CAM, PURGE, VENT
ECM B
Engine Control Module, Fuel
Pump Module, Oil Pressure
ABS
Anti
-
Lock Brake System
ECM I
Engine Control Module Injectors
A/C
Air Conditioning
W/W PMP
Not Used
HORN
Horn