Geo Tracker - 1995 Fuse Box Diagram

Geo Tracker - 1995 Fuse Box Diagram

4
L
A
green arrow on the instrument panel will flash in the
direction of the turn or
lane change.
To
signal
a
lane change, just
raise
or
lower the lever
until the green arrow starts
to
flash. Hold it there until
you complete your lane change. The
leverwill return by
itself when you release it.
As
you signal
a
turn
or
a lane
change, if the
arrows
don’t
flash but just stay on, a signal bulb may be burned out
and other drivers won’t see your turn signal.
If
a
bulb is burned out,
replace
it
to
help avoid an
accident.
If
the green arrows don’t
go
on
at all when you
signal
a
turn, check the fuse (see “Fuses and Circuit
Breakers’’
in the Index) and
for
burned-out bulbs.
0
0
Turn the outside part
of
the lever to control the lamps.
There
are
three
positions for the lamp switch.
OFF:
All lamps are off.
0
-loo:
:
The parking lamps, taillamps, license plate
lamp and the instrument panel lighting come on. The
headlamps
are
off.
-:g-
:
The headlamps and all other operating lamps
come on.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
Air Vent
Side
Defroster Vent
Turn SignalLamps ControlM[eadlamp Beam Lever
Instrument
Cluster
Hazard Warning Flasher
Windshield WiperNasher Lever
Rear Window
Wiper Switch
Comfort
Controls
Audio
System
Cigarette
Lighter
Assist
Grip
Glove Box
13. Transmission Shift
Lever
14.
Coinholder and Bin
15.
Transfer Case Shift Lever
16. Parking Brake Lever
17.
Ashtray
18.
Rear Window
Washer Switch
19.
Ignition Switch
20.
Horn
2
1.
Fuse Block
22.
Rear Window Defogger Switch
23.
Brightness Control
Engine
Oil
Pressure
Light
If
you have
a problem with
your oil, this red light may
stay on after you start your
engine,
or
come
on when
you are driving. This
indicates that there
is not
enough
pressure
to keep
your engine properly
lubricated and cool.
The
engine could be low on oil,
or
have
some
other
oil
related problem. Have
it
fixed right away.
The
oil light could also come on in three other
situations.
When
the ignition is on but
the
engine
is not running,
the light will come on as
a
test to show
you it
is
working, but the light will go out when you turn
the
engine to START.
If
it
doesn’t
come
on with the
ignition on, you
may have
aproblem with the
fuse
or
bulb. Have
it
fixed right away.
Sometimes when the
engine is idling at
a
stop, the
If you make
a
hard stop, the light may come on
for
a
light may blink on and
off.
This
is
normal.
moment. This is normal.
I
NOTICE:
Damage
to
your
engine
from
neglected
oil
problems
can
be
costly
and
is
not
covered by
your
warranty.
When
you
open the
hood, you’ll see
the
following
on
the
8-valve engine:
1.
Battery
2.
Automatic Transmission Dipstick (if equipped)
3.
Oil Fill Cap
4.
Brake Fluid Reservoir
5.
Air Cleaner
6.
Engine
Coolant
Reservoir
7.
Power
Steering
Reservoir
8.
Radiator
Pressure
Cap
9.
Electric Engine
Fan
10.
Engine Oil Dipstick
1
1.
Windshield Washer Reservoir
12.
Main Fuse
Box
Before closing
the hood, be sure all the filler caps are
on.
6-9
When you open
the
hood,
you’ll
see
the
following
on
the
16-valve
engine:
1.
Battery
2.
Automatic Transmission Dipstick (if equipped)
3.
Oil
Fill
Cap
4.
Brake
muid
Reservoir
5.
Air Cleaner
6. Engine
Coolant
Reservoir
7.
Power Steering
Reservoir
8.
Radiator
Pressure
Cap
9.
Electric Engine Fan
10.
Windshield Washer Reservoir
11.
Main Fuse Box
Before closing the
hood,
be
sure
all the
filler
caps
are
on.
Then lift
the hood to relieve pressure on the hood prop.
Remove
the hood prop
from
the
slot in the hood and
return the
prop
to its retainer. Then
just
let the hood
down
and
close
it
firmly.
6-11
Fuses
and
Circuit
Breakers
The wiring
circuits
in
your vehicle are protected from
short circuits by fuses, circuit breakers
and
thermal
links
in
the
wiring
itself. This greatly reduces the chance of
fires caused by
electrical
problems.
The main fuse box
in
your engine compartment is
on
the
right
side. It protects all electrical loads.
For access to the
main fuses, pull
off
the
cover.
A
spare
fuse
is
also inside the fuse box.
Another
fuse
box
is
under
the
left side of
the
instrument
panel.
The
fuses here
protect each separate circuit
including
headlamps.
If
you have electrical failure,
check here first.
Look at the
silver-colored band inside the fuse. If the
band
is broken
or
melted,
replace
the
fuse. Be sure you
replace
a bad fuse with a
new
one of the correct size.
If you ever
have
a
problem
on the road and don’t have a
spare fuse, you can borrow one.
Just pick some
feature
of your vehicle that you can get along without
--
like the
radio
or cigarette lighter
--
and use its
fuse,
if it is the
size you need. Replace it as soon
as
you can.
Before replacing
a
fuse, turn every vehicle electrical
switch
off.
Fuse
Usage
I
1
Main
Fuse
Block
Fuse
1
2
3
4
Usage
Generator
to
Battery
Circuit
Circuits
Only
Active
When
Ignition
Switch
is
in
ACC,
ON
or
START
Circuits
Always
Active
Circuits
Always
Active
Instrument
Panel
Fuse
Block
Fuse
1
2
3
4
5
6
Usage
Right
Headlamp
Left
Headlamp;
High
Beam
Indicator
Light
Taillamps;
Interior
Lamp;
Sidemarker
Lamps;
Instrument
Cluster
Lights
Stop
Lamps;
Horn
Hazard
Lamps
Door
Lock
(Option)