Buick Envision - 2016 Fuse Box Diagram

Buick Envision - 2016 Fuse Box Diagram

108
Instruments and Controls
3.
Touch
}
to go back to the
previous menu.
To set the clock display:
1.
Touch SETTINGS and touch
Time and Date.
2.
Touch Clock Display and touch
OFF or ON to turn the clock
display off or on.
3.
Touch
}
to go back to the
previous menu.
Setting the Analog Clock
The clock on the center stack is not
connected to any other vehicle
system. To adjust the time:
1.
Press and hold the button next
to the clock to quickly advance
the time.
2.
Press and release the button to
increase the time by
one-minute intervals.
Power Outlets
The vehicle has four 12-volt
accessory power outlets, which can
be used to plug in electrical
equipment, such as a cell phone or
MP3 player.
There are power outlets:
.
On the center floor console.
.
Inside the center floor console.
.
On the rear of the center floor
console.
.
In the rear cargo area.
To use the outlet, remove the cover.
Caution
Leaving electrical equipment
plugged in for an extended period
of time while the vehicle is off will
drain the battery. Always unplug
electrical equipment when not in
use and do not plug in equipment
that exceeds the maximum
20 amp rating.
{
Warning
Power is always supplied to the
rear cargo power outlet. Do not
leave electrical equipment
plugged in when the vehicle is not
in use because the vehicle could
catch fire and cause injury or
death.
Certain accessory plugs may not be
compatible with the accessory
power outlet and could overload
vehicle and adapter fuses. If a
problem is experienced, see your
dealer.
When adding electrical equipment,
be sure to follow the proper
installation instructions included with
the equipment. See
Add-On
Electrical Equipment
0
308
or
Add-On Electrical Equipment
0
308
.
Lighting
159
Hazard Warning Flashers
|
:
Press this button to make the
front and rear turn signal lamps
flash on and off. Press again to turn
the flashers off.
The hazard warning flashers turn on
automatically if the airbags deploy.
Turn and Lane-Change
Signals
Move the lever all the way up or
down to signal a turn.
An arrow on the instrument cluster
flashes in the direction of the turn or
lane change.
Raise or lower the lever until the
arrow starts to flash to signal a lane
change. Hold it there until the lane
change is completed. If the lever is
briefly pressed and released, the
turn signal flashes three times.
The turn and lane-change signal
can be turned off manually by
moving the lever back to its original
position.
If after signaling a turn or lane
change, the arrow flashes rapidly or
does not come on, a signal bulb
may be burned out.
Replace any burned out bulbs. If a
bulb is not burned out, check the
fuse. See
Fuses and Circuit
Breakers
0
333
.
314
Vehicle Care
1.
Engine Air Cleaner/Filter
0
318
.
2.
Engine Duct.
3.
Engine Oil Fill Cap. See
Engine Oil
0
314
.
4.
Engine Oil Dipstick. See
Engine Oil
0
314
.
5.
Engine Cover.
6.
Brake Fluid Reservoir. See
Brake Fluid
0
325
.
7.
Engine Coolant Surge Tank
and Pressure Cap. See
Engine
Coolant
0
320
.
8.
Battery - North America
0
326
.
9.
Windshield Washer Fluid
Reservoir. See
Washer
Fluid
0
324
.
10.
Engine Compartment Fuse
Block
0
334
.
Engine Oil
To ensure proper engine
performance and long life, careful
attention must be paid to engine oil.
Following these simple, but
important steps will help protect
your investment:
.
Use engine oil approved to the
proper specification and of the
proper viscosity grade. See
Selecting the Right Engine Oil
in this section.
.
Check the engine oil level
regularly and maintain the
proper oil level. See
Checking
Engine Oil
and
When to Add
Engine Oil
in this section.
.
Change the engine oil at the
appropriate time. See
Engine Oil
Life System
0
316
.
.
Always dispose of engine oil
properly. See
What to Do with
Used Oil
in this section.
Checking Engine Oil
It is a good idea to check the engine
oil level at each fuel fill. In order to
get an accurate reading, the vehicle
must be on level ground. The
engine oil dipstick handle is a loop.
See
Engine Compartment Overview
0
313
for the location of the engine
oil dipstick.
1.
If the engine has been running
recently, turn off the engine and
allow several minutes for the oil
to drain back into the oil pan.
Checking the oil level too soon
after engine shutoff will not
provide an accurate oil level
reading.
{
Warning
The engine oil dipstick handle
may be hot; it could burn you.
Use a towel or glove to touch the
dipstick handle.
2.
Pull out the dipstick and wipe it
with a clean paper towel or
cloth, then push it back in all
the way. Remove it again,
keeping the tip down, and
check the level.
Vehicle Care
333
Electrical System
Electrical System
Overload
The vehicle has fuses and circuit
breakers to protect against an
electrical system overload.
When the current electrical load is
too heavy, the circuit breaker opens
and closes, protecting the circuit
until the current load returns to
normal or the problem is fixed. This
greatly reduces the chance of circuit
overload and fire caused by
electrical problems.
Replace a bad fuse with a new one
of the identical size and rating.
If there is a problem on the road and
a fuse needs to be replaced, the
same amperage fuse can be
borrowed. Choose some feature of
the vehicle that is not needed to use
and replace it as soon as possible.
Headlamp Wiring
An electrical overload may cause
the lamps to go on and off, or in
some cases to remain off. Have the
headlamp wiring checked right away
if the lamps go on and off or
remain off.
Windshield Wipers
If the wiper motor overheats due to
heavy snow or ice, the windshield
wipers will stop until the motor cools
and will then restart.
Although the circuit is protected
from electrical overload, overload
due to heavy snow or ice may
cause wiper linkage damage.
Always clear ice and heavy snow
from the windshield before using the
windshield wipers.
If the overload is caused by an
electrical problem and not snow or
ice, be sure to get it fixed.
Fuses and Circuit
Breakers
The wiring circuits in the vehicle are
protected from short circuits by a
combination of fuses and circuit
breakers. This greatly reduces the
chance of damage caused by
electrical problems.
To check a fuse, look at the
silver-colored band inside the fuse.
If the band is broken or melted,
replace the fuse. Be sure to replace
a bad fuse with a new one of the
identical size and rating.
Fuses of the same amperage can
be temporarily borrowed from
another fuse location, if a fuse goes
out. Replace the fuse as soon as
possible.
To identify and check fuses, circuit
breakers, and relays, see
Engine
Compartment Fuse Block
0
334
,
Instrument Panel Fuse Block
0
336
,
and
Rear Compartment Fuse
Block
0
337
.
334
Vehicle Care
Engine Compartment
Fuse Block
To remove the fuse block cover,
squeeze the clips on the cover and
lift it straight up. See
Engine
Compartment Overview
0
313
.
Caution
Spilling liquid on any electrical
component on the vehicle may
damage it. Always keep the
covers on any electrical
component.
The vehicle may not be equipped
with all of the fuses, relays, and
features shown.
Fuse
Usage
F01
Starter 1
F02
Starter 2
F03
Non walk
F04
Engine control
module
Fuse
Usage
F05
Flex fuel
F06
/Transmission
control module
F07
F08
Engine control
module
F09
A/C
Vehicle Care
335
Fuse
Usage
F10
Canister vent
solenoid
F11
Fuel pump
F12
Heated seats
F13
Engine
coolant pump
F14
F15
O2 sensor
F16
Ignition coils
odd
F17
Ignition coils
even
F18
F19
F20
DC DC/Transmission
F21
Liftgate
F22
ABS
F23
Washer pump
F24
Headlamp washer
F25
F26
Transmission
oil pump
F27
ABS
Fuse
Usage
F28
F29
Rear window
defogger
F30
Mirror defogger
F31
F32
Various low current
functions/Circuit 39
splice
F33
F34
Horn
F35
F36
Right high-beam
headlamp
F37
Left high-beam
headlamp
F38
Automatic headlamp
leveling
F39
Front fog lamps
F40
Transmission
oil pump
F41
Passenger seat
ventilation
F42
Headlamp position
Fuse
Usage
F43
F44
Interior rearview
mirror
F45
F46
Driver seat
ventilation
F47
Electric steering
column lock
F48
Rear wiper
F49
F50
F51
Right daytime
running lamp
F52
Engine control
module/
Transmission control
module
F53
F54
F55
Front wiper
F56
F57
Left daytime
running lamp
336
Vehicle Care
Fuse
Usage
K01
Start/Stop
K02
A/C clutch
K03
Engine control
module
K04
Wiper
K05
Start solenoid
K06
K07
K08
Transmission
oil pump
K09
Wiper speed
K10
Starter
K11
Headlamp washers
K12
High-beam
headlamps
K13
Daytime running
lamps
K14
Run/Crank
K15
Rear window/Mirror
defogger
Instrument Panel Fuse
Block
The instrument panel fuse block is
in the glove box. To access the
fuses, open the fuse panel door
from the passenger side by pulling
it out.
To reinstall the door, insert the tabs
on the top of the door into the
console first, then push the door
back into its original location.
The vehicle may not be equipped
with all of the fuses, relays, and
features shown.
Fuses
Usage
F1
F2
Front HVAC blower
F3
Power seat
F4
Lighter (China only)
F5
F6
Front power
windows
F7
F8
Accessory power
outlet
F9
Body control
module 8
Vehicle Care
337
Fuses
Usage
F10
Rear power windows
F11
F12
Sunroof
F13
Front heated seats
F14
Exterior rearview
mirror
F15
Body control
module 3
F16
F17
Body control
module 6
F18
Body control
module 7
F19
Data link connector
F20
SDM
F21
HVAC
F22
Liftgate release
F23
Passive entry/
Passive start
F24
OCC sensor
F25
Steering wheel
controls
Fuses
Usage
F26
Ignition
F27
Body control
module 4
F28
Transmission control
module
F29
Body control
module 2
F30
USB
F31
Rear HVAC blower
F32
Body control
module 1
F33
Universal remote
system
F34
Parking assist
F35
OnStar
F36
Display
F37
Radio
Rear Compartment Fuse
Block
The rear compartment fuse block is
behind a cover on the left side of
the rear compartment. To access
the fuses, remove the cover.
The vehicle may not be equipped
with all of the fuses, relays, and
features shown.
Fuses
Usage
F1
F2
DC AC
F3
338
Vehicle Care
Fuses
Usage
F4
Passenger
power seat
F5
Memory seat
module
F6
F7
Amplifier
F8
Rear accessory
power outlet
F9
Rear heated seat
F10
Logistics relay
F11
Rear HVAC
F12
Power liftgate HF
sensor
F13
Parking/Trailer
lamps
F14
Side blind zone alert
F15
Left parking lamp
F16
Right parking lamp
F17
Body control
module 6
F18
Heated steering
wheel
Fuses
Usage
F19
AWD
F20
Lumbar seat
F21
Rear heated seat
F22
Rear drive control
module
F23
Trailer left turn
signal lamp
F24
Trailer right turn
signal lamp
K1
Parking lamps
K2
K3
Ignition
K4
Logistics
K5
DC AC
K6
K7
Parking assist
K8
Right turn
K9
Left turn
K10
Wheels and Tires
Tires
Every new GM vehicle has
high-quality tires made by a
leading tire manufacturer. See
the warranty manual for
information regarding the tire
warranty and where to get
service. For additional
information refer to the tire
manufacturer.
{
Warning
.
Poorly maintained and
improperly used tires are
dangerous.
.
Overloading the tires can
cause overheating as a
result of too much
flexing. There could be a
blowout and a serious
crash. See
Vehicle Load
Limits
0
255
.
(Continued)
370
Vehicle Care
.
Is the proper towing equipment
going to be used? See your
dealer or trailering professional
for additional advice and
equipment recommendations.
.
Is the vehicle ready to be
towed? Just as preparing the
vehicle for a long trip, make sure
the vehicle is prepared to be
towed.
Caution
Use of a shield mounted in front
of the vehicle grille could restrict
airflow and cause damage to the
transmission. The repairs would
not be covered by the vehicle
warranty. If using a shield, only
use one that attaches to the
towing vehicle.
Dinghy Towing
To dinghy tow the vehicle from the
front with all four wheels on the
ground:
1.
Position the vehicle to tow and
then secure it to the towing
vehicle.
2.
Turn the ignition on, and shift
the transmission to N (Neutral).
3.
With the transmission in
N (Neutral), turn the ignition off.
4.
To prevent the battery from
draining while the vehicle is
being towed, remove fuses
F29 and F32 (Body Control
Module) from the instrument
panel fuse block. See
Instrument Panel Fuse Block
0
336
. Remember to reinstall
the fuses once the destination
has been reached.
Dolly Towing
Do not tow this vehicle with two
wheels on the ground.