Buick LeSabre - 1994 Fuse Box Diagram

Buick LeSabre - 1994 Fuse Box Diagram

Your vehicle is equipped with the [email protected]
(Personalized Automotive Security System) theft
deterrent system. [email protected] is a passive theft
deterrent system. This means you don’t have to do
anything different to arm or disarm the system. It works
when
you insert or remove the
key
from
the ignition.
PASS-Key(%
uses
a
resistor pellet
in
the ignition key
that matches a decoder
in
your vehicle.
When
the PASS-Key’II
system senses that someone is
using
the
wrong key, it shuts down the vehicle’s starter
and fuel systems. For about three minutes, the starter
won’t
work and fuel won’t go
to
the engine. If someone
tries to start your vehicle again or uses another key
during this time, the vehicle will
not start. This
discourages someone from randomly trying different
keys
with different resistor pellets
in
an attempt to make
a match.
The ignition key
must
be clean and dry before it’s
inserted
in
the ignition or the engine may
not start. If the
engine
doesnot start and the “SECURITY” light comes
on, the
key
may
be dirty or wet. Turn the ignition off.
Clean and dry the key.
Wait about three minutes and try
again. The security light may remain on during this
time. If the starter still won’t work, and the key appears
to be clean and dry,
wait about three minutes and try the
other ignition key.
At this time, you
may also want to
check the fuse
(see “Fuses and Circuit Breakers”
in
the
Index). If the starter won’t
work
with
the
other key, your
vehicle needs service.
If
your vehicle does
start, the first
ignition key may be faulty. See your
Buick dealer or a
locksmith who can service the PASS-Key%.
72
Turn
Signal and Lane Change Indicator
A
green arrow on the
instrument panel will flash
in the direction
of
the turn
or lane change.
The
turn
signal has two upward (for Right) and
two
downward (for
Left) positions. These positions allow
you
to
signal a turn or
a lane change.
To
signal a turn, move
the
lever all
the
way
up
or
down.
When the turn is finished, the lever will return
automatically.
To signal a
lane
change,
just
raise or lower the lever
until the green arrow starts to flash.
Hold
it there until
you complete your lane change. The lever will return by
itself when
you release it.
As
you signal a turn or
a lane change,
if
the arrows don’t
flash but just stay on,
a signal bulb may
be burned out
and other drivers
won’t
see your turn signal.
If a bulb is burned out, replace
it
to help avoid an
accident. If the green arrows don’t go
or1
at all when
you
signal a turn, check the fuse (see “Fuses” in the Index)
and
.for
burned-out bulbs.
Your vehicle has an air bag system. Before attempting to
add anything electrical
to
your Buick, see “Servicing
Your Air Bag-Equipped Buick”
in
the Index.
Fuses
and
Circuit
Breakers
-
I
The wiring circuits
in
your car
are protected from short
circuits by a combination of fuses and circuit breakers
The
fuse panel
is
located under the instrument panel,
next to the parking brake.
Remove the cover to access the fuses. To
put the cover
on, insert the tabs into the lower part
of
the
fuse panel
and snap
it
in
place.
257
Look at the silver-colored band inside the fuse. If the
band
is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one
of
the identical size
and rating.
There
are additional fuses located behind
the
right sound
insulator panel
on the passenger side. If these require
service, see your
Buick dealer.
258
Maxifuse/Relay Center
To
check the
fuses in
this
underhood
fuse
center,
turn
the two knobs
1/4
turn counterclockwise and remove the
cover. The
inside of
the
cover has a chart that explains
the features and
controls governed by each
fuse and
relay.
The PASS-Key fuse is located in the right side relay
center.
Headlights
The headlight wiring
is
protected by a circuit breaker
in
the light switch. An electrical overload will cause the
lights
to
go on and
off,
or in some cases
to
remain off. If
this happens, have your headlight wiring checked right
away.
Windshield
Wipers
The windshield wiper motor is protected by a circuit
breaker and a
fuse.
If the motor overheats due to heavy
snow, etc., the wiper will stop until
the
motor cools. If
the overload is caused by some electrical problem and
not snow, etc.,
be
sure
to get it fixed.
Power Windows and Other Power Options
Circuit breakers
in
the fuse panel protect the power
windows and
other power accessories. When the current
load
is too heavy, the circuit breaker opens and closes,
protecting
the
circuit until the problem is fixed or goes
away.
259
~
___
Fuse
Usage
Amp
Description
1
2
3
4
5
1A
1B
1c
1D
1E
2A
2B
2 c
2D
2E
3A
3B
3 c
3D
3E
4A
4B
4 c
4D
4E
30
25
10
20
10
15
10
15
20
25
10
BRKR
-
Power
Window
Not
Used
BRKR
-
Power
Seats
Not
Used
Not
Used
SIR
DERM/Crank
Signal/Comering/Back-up Lamps
SIR
Cluster/Telltale/Chime
Not
Used
Spare
Spare
Spare
Spare
Not
Used
Not
Used
Not
Used
Not
Used
Not
Used
Not
Used
Interior Illumination
Not
Used
Not
Used
Not
Used
Not
Used
Fuse
Usage
Amp
Description
5A
5B
5c
5D
5E
6A
6B
6C
6D
6E
7A
7B
7 c
7D
7E
8A
8B
8C
8D
8E
9A
9B
9 c
9D
9E
10
10
10
25
15
20
15
10
25
15
20
10
30
Uplevel
HVAC/Oil
Level/Low
Coolant
ABS
Transmission/Cooling
Fans
Base HVAC
Not
Used
Courtesy
Lamps/Power Mirrors
Brake
&
Hazard
Lamps
Park
Lamps
Nor
Used
Nor
Used
Not
Used
Not
Used
Not
Used
Not
Used
Not
Used
Not
Used
Not
Used
Not
Used
Radio
Wiper/Washer
Ash
Tray Cigar Lighter
Electronic
Level
Control
Radioflgnition
Nor Used
Rear
Window
Defog
260