Toyota Rav4h Hybrid - 2015 Fuse Box Diagram

Toyota Rav4h Hybrid - 2015 Fuse Box Diagram

368
6-3. Do-it-yourself maintenance
RAV4-HV_OM_OM42A57E_(EE)
Do-it-yourself service precautions
If you perform maintenance by yourself, be sure to follow the
correct procedure as given in these sections.
Items
Parts and tools
12-volt battery
condition
(
P. 381)
Conventional wrench (for terminal clamp bolts)
Engine/power
control unit
coolant level
(
P. 377)
• “Toyota Super Long Life Coolant” or a similar high
quality ethylene glycol-based non-silicate, non-
amine, non-nitrite and non-borate coolant with long-
life hybrid organic acid technology
“Toyota Super Long Life Coolant” is pre-mixed with
50% coolant and 50% deionized water.
Funnel (used only for adding coolant)
Engine oil level
(
P. 374)
“Toyota Genuine Motor Oil” or equivalent
Rag or paper towel
Funnel (used only for adding engine oil)
Fuses (
P. 410)
Fuse with same amperage rating as original
Light bulbs
(
P. 414)
Bulb with same number and wattage rating as origi-
nal
Phillips-head screwdriver
Flathead screwdriver
• Wrench
Radiator and
condenser
(
P. 378)
Tire inflation pres-
sure (
P. 400)
Tire pressure gauge
Compressed air source
Washer fluid
(
P. 379)
Water or washer fluid containing antifreeze (for win-
ter use)
Funnel (used only for adding water or washer fluid)
373
6-3. Do-it-yourself maintenance
RAV4-HV_OM_OM42A57E_(EE)
6
Maintenance and care
Engine compartment
12-volt battery
P. 381
Fuse boxes
(
P. 410)
Engine coolant reservoir
(
P. 377)
Engine oil filler cap
(
P. 375)
Power control unit coolant
reservoir
(
P. 377)
Radiator
(
P. 378)
Condenser
(
P. 378)
Electric cooling fans
Engine oil level dipstick
(
P. 374)
Washer fluid tank (
P. 379)
1
2
3
4
5
6
7
8
9
410
6-3. Do-it-yourself maintenance
RAV4-HV_OM_OM42A57E_(EE)
Checking and replacing fuses
Turn the power switch off.
Open the fuse box cover or instrument panel.
X
Under the instrument panel (left-hand drive vehicles)
Remove the cover.
If any of the electrical components do not operate, a fuse may
have blown. If this happens, check and replace the fuses as nec-
essary.
1
2
X
Engine compartment type A
X
Engine compartment type B
Push the tabs in and lift the cover
off.
Push the tabs in and lift the cover
off.
412
6-3. Do-it-yourself maintenance
RAV4-HV_OM_OM42A57E_(EE)
Remove the fuse with the pull-
out tool.
Only type A fuse can be removed
using the pullout tool.
Check if the fuse is blown.
Normal fuse
Blown fuse
Type A and B:
Replace the blown fuse with a new fuse of an appropriate amperage rat-
ing. The amperage rating can be found on the fuse box lid.
Type C and D:
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional.
3
4
1
2
X
Type A
X
Type B
X
Type C
X
Type D
413
6-3. Do-it-yourself maintenance
RAV4-HV_OM_OM42A57E_(EE)
6
Maintenance and care
After a fuse is replaced
If the lights do not turn on even after the fuse has been replaced, a bulb may
need replacement. (
P. 414)
If the replaced fuse blows again, have the vehicle inspected by any autho-
rized Toyota dealer or repairer, or another duly qualified and equipped pro-
fessional.
If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
When replacing light bulbs
Toyota recommends that you use genuine Toyota products designed for this
vehicle. Because certain bulbs are connected to circuits designed to prevent
overload, non-genuine parts or parts not designed for this vehicle may be
unusable.
WARNING
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle, and possibly a fire or
injury.
Never use a fuse of a higher amperage rating than that indicated, or use
any other object in place of a fuse.
Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
Do not modify the fuses or fuse boxes.
Fuse box near the power control unit
Never check or replace the fuses as there are high voltage parts and wiring
near the fuse box.
Doing so may cause electric shock, resulting in death or serious injury.
NOTICE
Before replacing fuses
Have the cause of electrical overload determined and repaired by any
authorized Toyota dealer or repairer, or another duly qualified and equipped
professional as soon as possible.
487
7-2. Steps to take in an emergency
RAV4-HV_OM_OM42A57E_(EE)
7
When trouble arises
If the hybrid system will not start
One of the following may be the cause of the problem:
The electronic key may not be functioning properly. (
P. 490)
There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle. (
P. 82)
There may be a malfunction in the immobilizer system. (
P. 85)
There may be a malfunction in the steering lock system.
The hybrid system may be malfunctioning due to an electrical prob-
lem such as electronic key battery depletion or a blown fuse. How-
ever, depending on the type of malfunction, an interim measure is
available to start the hybrid system. (
P. 488)
One of the following may be the cause of the problem:
The 12-volt battery may be discharged. (
P. 493)
The 12-volt battery terminal connections may be loose or corroded.
(
P. 381)
Reasons for the hybrid system not starting vary depending on
the situation. Check the following and perform the appropriate
procedure:
The hybrid system will not start even though the correct starting
procedure is being followed. (
P. 197)
The interior lights and headlights are dim, or the horn does not
sound or sounds at a low volume.
493
7-2. Steps to take in an emergency
RAV4-HV_OM_OM42A57E_(EE)
7
When trouble arises
If the 12-volt battery is discharged
If you have a set of jumper (or booster) cables and a second vehicle
with a 12-volt battery, you can jump start your vehicle by following the
steps below.
Confirm that the electronic key
is being carried.
When connecting the jumper (or
booster) cables, depending on the
situation, the alarm may activate
and doors locked. (
P. 92)
Open the hood (
P. 370) and
fuse box cover.
Open the exclusive jump start-
ing terminal cover.
The following procedures may be used to start the hybrid sys-
tem if the vehicle’s 12-volt battery is discharged.
You can also call any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional.
1
2
3
495
7-2. Steps to take in an emergency
RAV4-HV_OM_OM42A57E_(EE)
7
When trouble arises
Make sure the “READY” indicator comes on. If the indicator light
does not come on, contact any authorized Toyota dealer or repairer,
or another duly qualified and equipped professional.
Once the hybrid system has started, remove the jumper cables in
the exact reverse order from which they were connected.
Close the exclusive jump starting terminal cover, and reinstall the
fuse box cover to its original position.
When installing, first hook the fuse box cover onto the two rear tabs.
Once the hybrid system starts, have the vehicle inspected at any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional as soon as possible.
Starting the hybrid system when the 12-volt battery is discharged
The hybrid system cannot be started by push-starting.
To prevent 12-volt battery discharge
Turn off the headlights and the audio system while the hybrid system is off.
Turn off any unnecessary electrical components when the vehicle is running
at a low speed for an extended period, such as in heavy traffic.
Charging the 12-volt battery
The electricity stored in the 12-volt battery will discharge gradually even when
the vehicle is not in use, due to natural discharge and the draining effects of
certain electrical appliances. If the vehicle is left for a long time, the 12-volt
battery may discharge, and the hybrid system may be unable to start. (The
12-volt battery recharges automatically while the hybrid system is operating.)
When recharging or replacing the 12-volt battery
In some cases, it may not be possible to unlock the doors using the smart
entry & start system when the 12-volt battery is discharged. Use the wire-
less remote control or the mechanical key to lock or unlock the doors.
The hybrid system may not start on the first attempt after the 12-volt battery
has recharged but will start normally after the second attempt. This is not a
malfunction.
The power switch mode is memorized by the vehicle. When the 12-volt bat-
tery is reconnected, the system will return to the mode it was in before the
12-volt battery was discharged. Before disconnecting the 12-volt battery,
turn the power switch off.
If you are unsure what mode the power switch was in before the 12-volt bat-
tery discharged, be especially careful when reconnecting the 12-volt battery.
Some systems may require initialization. (
P. 527)
8
9
10
527
8-3. Initialization
RAV4-HV_OM_OM42A57E_(EE)
8
Vehicle specifications
Items to initialize
The following items must be initialized for normal system opera-
tion after such cases as the 12-volt battery being reconnected,
or maintenance being performed on the vehicle:
Item
When to initialize
Reference
Power back door
(if equipped)
After reconnecting or chang-
ing the 12-volt battery
After changing a fuse
P. 129
Moon roof
(if equipped)
After reconnecting or chang-
ing the 12-volt battery
After changing a fuse
P. 170
Tire pressure warning
system (if equipped)
When changing the tire size
P. 388
Toyota parking assist
monitor (if equipped)
After reconnecting or chang-
ing the 12-volt battery
After changing a fuse
Refer to
“Navigation
and multi-
media sys-
tem
Owner’s
manual”
Panoramic view monitor
(if equipped)