Toyota Land Cruiser V8 200 - 2016 Fuse Box Diagram

Toyota Land Cruiser V8 200 - 2016 Fuse Box Diagram

638
LC200_OM_OM60M95E_(EE)
6-4. Using the other interior features
Luggage compartment
The power outlet can be used when
12 V DC: The engine switch is in ACCESSORY or IGNITION ON mode.
220 V AC: The engine switch is in IGNITION ON mode.
X
Type A (12 V DC)
X
Type B (220 V AC)
NOTICE
To avoid damaging the power outlet
Close the power outlet lid when the power outlet is not in use.
Foreign objects or liquids that enter the power outlet may cause a short cir-
cuit.
To prevent blown fuse
12 V DC: Do not use an accessory that uses more than 12 V 10 A.
220 V AC: Do not use a 220 V AC appliance that requires more than 100 W.
If a 220 V AC appliance that consumes more than 100 W is used, the pro-
tection circuit will cut the power supply.
To prevent battery discharge
Do not use the power outlet longer than necessary when the engine is not
running.
Appliances that may not operate properly (220 V AC)
The following 220 V AC appliances may not operate properly even if their
power consumption is under 100 W:
Appliances with high initial peak wattage
Measuring devices that process precise data
Other appliances that require an extremely stable power supply
662
7-3. Do-it-yourself maintenance
LC200_OM_OM60M95E_(EE)
Do-it-yourself service precautions
If you perform maintenance yourself, be sure to follow the cor-
rect procedures as given in these sections.
Items
Parts and tools
Battery condition
(
P. 676)
Warm water
Baking soda
• Grease
Conventional wrench (for terminal clamp bolts)
Distilled water
Electric winch
(
P. 682)
• Grease
Automatic transmission fluid
Engine coolant
level (
P. 673)
• “Toyota Super Long Life Coolant” or similar high
quality ethylene glycol-based non-silicate, non-
amine, non-nitrite and non-borate coolant with long-
life hybrid organic acid technology. “Toyota Super
Long Life Coolant” is pre-mixed with 50% coolant
and 50% deionized water.
Funnel (used only for adding coolant)
Engine oil level
(→
P. 670)
“Toyota Genuine Motor Oil” or equivalent
Rag or paper towel
Funnel (used only for adding engine oil)
Fuses (
P. 707)
Fuse with same amperage rating as original
Light bulbs
(
P. 712)
Bulb with same number and wattage rating as origi-
nal
Phillips-head screwdriver
Flathead screwdriver
• Wrench
Radiator,
condenser and
intercooler
(
P. 675)
Tire inflation
pressure
(
P. 696)
Tire pressure gauge
Compressed air source
Washer fluid
(
P. 680)
Water or washer fluid containing antifreeze (for win-
ter use)
Funnel (used only for adding water or washer fluid)
666
7-3. Do-it-yourself maintenance
LC200_OM_OM60M95E_(EE)
Engine compartment
X
1UR-FE engine
Engine oil level dipstick
(
P. 670)
Engine coolant reservoir
(
P. 673)
Cooling fans
(
P. 675)
Engine oil filler cap(
P. 671)
Fuse box
(
P. 707)
Washer fluid tank
(
P. 680)
Battery
(
P. 676)
Condenser
(
P. 675)
Radiator
(
P. 675)
1
2
3
4
5
6
7
8
9
667
7-3. Do-it-yourself maintenance
LC200_OM_OM60M95E_(EE)
7
Maintenance and care
X
1GR-FE
Engine oil level dipstick
(
P. 670)
Engine coolant reservoir
(
P. 673)
Cooling fans
(
P. 675)
Engine oil filler cap(
P. 671)
Fuse box
(
P. 707)
Washer fluid tank
(
P. 680)
Battery
(
P. 676)
Condenser
(
P. 675)
Radiator
(
P. 675)
1
2
3
4
5
6
7
8
9
668
7-3. Do-it-yourself maintenance
LC200_OM_OM60M95E_(EE)
X
1VD-FTV engine
Engine coolant reservoir
(
P. 673)
Engine oil level dipstick
(
P. 670)
Engine oil filler cap(
P. 671)
Cooling fans
(
P. 675)
Intercooler
(
P. 675)
Fuse box
(
P. 707)
Fuel filter
(
P. 681, 802)
Washer fluid tank
(
P. 680)
Battery
(
P. 675)
Condenser
(
P. 675)
Radiator
(
P. 675)
1
2
3
4
5
6
7
8
9
10
11
707
7-3. Do-it-yourself maintenance
LC200_OM_OM60M95E_(EE)
7
Maintenance and care
Checking and replacing fuses
Turn the engine switch off.
Open the fuse box cover.
X
Driver’s side instrument panel (left-hand drive vehicles)
Remove the lid.
If any of the electrical components do not operate, a fuse may
have blown. If this happens, check and replace the fuses as nec-
essary.
1
2
X
Engine compartment (fuse
box on the left side)
X
Engine
compartment
(fuse
box on the right side) (if
equipped)
Push the tab in and lift the lid
off.
Push the tab in and lift the lid off.
709
7-3. Do-it-yourself maintenance
LC200_OM_OM60M95E_(EE)
7
Maintenance and care
X
Passenger’s side instrument panel (right-hand drive vehicles)
Remove the cover.
Remove the lid.
Remove the fuse with the pull-
out tool.
Only type A fuse can be
removed using the pullout tool.
1
2
3
710
7-3. Do-it-yourself maintenance
LC200_OM_OM60M95E_(EE)
Check if the fuse is blown.
Normal fuse
Blown fuse
Type A and B:
Replace the blown fuse with one of an appropriate amperage rat-
ing. The amperage rating can be found on the fuse box lid.
Type C and D:
Contact any authorized Toyota dealer or repairer, or another duly
qualified and equipped professional.
4
1
2
X
Type A
X
Type B
X
Type C
X
Type D
711
7-3. Do-it-yourself maintenance
LC200_OM_OM60M95E_(EE)
7
Maintenance and care
After a fuse is replaced
If the lights do not turn on even after the fuse has been replaced, a bulb may
need replacement. (
P. 712)
If the replaced fuse blows again, have the vehicle inspected by any autho-
rized Toyota dealer or repairer, or another duly qualified and equipped pro-
fessional.
If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
When replacing light bulbs
Toyota recommends that you use genuine Toyota products designed for this
vehicle. Because certain bulbs are connected to circuits designed to prevent
overload, non-genuine parts or parts not designed for this vehicle may be
unusable.
WARNING
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle, and possibly a fire or
injury.
Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
Do not modify the fuses or fuse boxes.
NOTICE
Before replacing fuses
Have the cause of electrical overload determined and repaired by any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional as soon as possible.
791
8-2. Steps to take in an emergency
LC200_OM_OM60M95E_(EE)
8
When trouble arises
One of the following may be the cause of the problem.
The starter motor may be protected due to extremely low tempera-
tures. (diesel engine for Russia only)
If the starter motor disengages before the engine starts, turn the
engine switch off, and then restart the engine following the proper
procedure.(
P. 253)
The engine starting system may be malfunctioning due to an elec-
trical problem such as an open circuit or a blown fuse. However, an
interim measure is available to start the engine. (
P. 791)
One of the following may be the cause of the problem:
One or both of the battery terminals may be disconnected.
The battery may be discharged. (
P. 796)
There may be a malfunction in the steering lock system.
Contact any authorized Toyota dealer or repairer, or another duly qualified
and equipped professional if the problem cannot be repaired, or if repair
procedures are unknown.
When the engine does not start, the following steps can be used as an
interim measure to start the engine if the engine switch is functioning
normally.
Set the parking brake.
Put the shift lever in P.
Set the engine switch to the ACCESSORY mode.
Push and hold the engine switch for about 15 seconds while
depressing the brake pedal.
Even if the engine can be started using the above steps, the system
may be malfunctioning. Have the vehicle checked by any authorized
Toyota dealer or repairer, or another duly qualified and equipped pro-
fessional.
The starter motor does not turn over
The starter motor does not turn over, the interior lights and head-
lights do not turn on, or the horn does not sound.
Emergency start function
1
2
3
4
851
9
9-3. Initialization
Vehicle specifications
LC200_OM_OM60M95E_(EE)
Items to initialize
*
: If equipped
The following item must be initialized for normal system opera-
tion after such cases as the battery being reconnected, or main-
tenance being performed on the vehicle:
Item
When to initialize
Reference
Tire pressure warning sys-
tem
*
• When rotating the tires on
vehicles differing with front
and rear tire inflation pres-
sures.
When changing the tire infla-
tion pressure by changing
traveling
speed
or
load
weight, etc.
When changing the tire size.
P. 684
Engine oil maintenance
data
*
After changing engine oil
P. 670
Power back door
*
After reconnecting or chang-
ing the battery with power
back door opened
• After changing a fuse with
power back door opened
P. 150
Multi-terrain Monitor
*
After reconnecting or chang-
ing the battery
P. 397
Toyota parking assist moni-
tor
*
After reconnecting or chang-
ing the battery
P. 397