Toyota C-hr Hv Hybrid - 2017 Fuse Box Diagram

Toyota C-hr Hv Hybrid - 2017 Fuse Box Diagram

523
7-3. Do-it-yourself maintenance
C-HR_HV_OM_Europe_OM10538E
7
Maintenance and care
Do-it-yourself service precautions
If you perform maintenance by yourself, be sure to follow the
correct procedure as given in these sections.
Items
Parts and tools
12-volt battery
condition
(
P. 536)
Warm water
Baking soda
• Grease
Conventional wrench (for terminal clamp bolts)
Engine/power
control unit
coolant level
(
P. 533)
• “Toyota Super Long Life Coolant” or a similar high
quality ethylene glycol-based non-silicate, non-
amine, non-nitrite and non-borate coolant with long-
life hybrid organic acid technology
“Toyota Super Long Life Coolant” is pre-mixed with
50% coolant and 50% deionized water.
Funnel (used only for adding coolant)
Engine oil level
(
P. 530)
“Toyota Genuine Motor Oil” or equivalent
Rag or paper towel
Funnel (used only for adding engine oil)
Fuses (
P. 564)
Fuse with same amperage rating as original
Light bulbs
(
P. 568)
Bulb with same number and wattage rating as origi-
nal
Phillips-head screwdriver
Flathead screwdriver
• Wrench
Radiator and
condenser
(
P. 535)
Tire inflation
pressure
(
P. 553)
Tire pressure gauge
Compressed air source
Washer fluid
(
P. 539)
Water or washer fluid containing antifreeze (for win-
ter use)
Funnel (used only for adding water or washer fluid)
529
7-3. Do-it-yourself maintenance
C-HR_HV_OM_Europe_OM10538E
7
Maintenance and care
Engine compartment
Washer fluid tank
(
P. 539)
Engine coolant reservoir
(
P. 533)
Fuse boxes
(
P. 564)
Engine oil level dipstick
(
P. 530)
Engine oil filler cap
(
P. 531)
Power control unit coolant
reservoir
(
P. 533)
12-volt battery
(
P. 536)
Radiator
(
P. 535)
Condenser
(
P. 535)
Electric cooling fans
1
2
3
4
5
6
7
8
9
10
564
7-3. Do-it-yourself maintenance
C-HR_HV_OM_Europe_OM10538E
Checking and replacing fuses
Turn the power switch off.
Open the fuse box cover.
Engine compartment type A fuse box
While pushing the 2 claws, lift up
the cover.
When closing the cover, make sure
to attach the 2 claws.
Engine compartment type B fuse box
While pushing the 3 claws, lift up
the cover.
When closing the cover, make sure
to attach the 3 claws.
Engine compartment type C fuse box
Remove the cover.
When installing the cover, make
sure to attach the claw.
If any of the electrical components do not operate, a fuse may
have blown. If this happens, check and replace the fuses as nec-
essary.
1
2
565
7-3. Do-it-yourself maintenance
C-HR_HV_OM_Europe_OM10538E
7
Maintenance and care
Left side instrument panel (left-hand drive vehicles)
Remove the lid.
Make sure to press the claw during
removal or installation.
Left side instrument panel (right-hand drive vehicles)
Remove the cover and the lid.
Push the tab in and remove
the cover.
Remove the lid.
Make sure to press the claw
during removal or installation.
Remove the fuse with the pull-
out tool.
Only type A fuses can be removed
using the pullout tool.
1
2
3
566
7-3. Do-it-yourself maintenance
C-HR_HV_OM_Europe_OM10538E
Check if the fuse is blown.
Normal fuse
Blown fuse
Except for Type E:
Replace the blown fuse with a new fuse of an appropriate amperage rat-
ing. The amperage rating can be found on the fuse box lid.
Type E:
Contact any authorized Toyota retailer or Toyota authorized repairer, or any
reliable repairer.
4
1
2
Type A
Type B
Type C
Type D
Type E
567
7-3. Do-it-yourself maintenance
C-HR_HV_OM_Europe_OM10538E
7
Maintenance and care
After a fuse is replaced
If the lights do not turn on even after the fuse has been replaced, a bulb may
need replacement. (
P. 568)
If the replaced fuse blows again, have the vehicle inspected by any autho-
rized Toyota retailer or Toyota authorized repairer, or any reliable repairer.
If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
When replacing light bulbs
Toyota recommends that you use genuine Toyota products designed for this
vehicle. Because certain bulbs are connected to circuits designed to prevent
overload, non-genuine parts or parts not designed for this vehicle may be
unusable.
WARNING
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle, and possibly a fire or
injury.
Never use a fuse of a higher amperage rating than that indicated, or use
any other object in place of a fuse.
Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
Do not modify the fuses or fuse boxes.
NOTICE
Before replacing fuses
Have the cause of electrical overload determined and repaired by any
authorized Toyota retailer or Toyota authorized repairer, or any reliable
repairer as soon as possible.
646
8-2. Steps to take in an emergency
C-HR_HV_OM_Europe_OM10538E
If the hybrid system will not start
One of the following may be the cause of the problem:
The electronic key may not be functioning properly. (
P. 648)
There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle. (
P. 94)
There may be a malfunction in the immobilizer system. (
P. 99)
There may be a malfunction in the steering lock system.
The hybrid system may be malfunctioning due to an electrical prob-
lem such as electronic key battery depletion or a blown fuse. How-
ever, depending on the type of malfunction, an interim measure is
available to start the hybrid system. (
P. 647)
One of the following may be the cause of the problem:
The 12-volt battery may be discharged. (
P. 651)
The 12-volt battery terminal connections may be loose or corroded.
(
P. 536)
Reasons for the hybrid system not starting vary depending on
the situation. Check the following and perform the appropriate
procedure:
The hybrid system will not start even though the correct starting
procedure is being followed. (
P. 221)
The interior lights and headlights are dim, or the horn does not
sound or sounds at a low volume.