Toyota Tacoma - 2017 Fuse Box Diagram

Toyota Tacoma - 2017 Fuse Box Diagram

417
6-4. Other interior features
6
Interior features
NOTICE
To avoid damaging the power outlet and the plug
Close the power outlet lid when not in use.
Do not allow foreign objects or liquids to enter the power outlet, as this
may cause a short circuit.
Do not use plug adaptors to connect too many plugs to the power outlet.
After removing a plug, gently close the power outlet lid.
To prevent the fuse from being blown
Do not use a 120 V AC appliance that requires more than the maximum
capacity of the power outlet. If a 120 V AC appliance that consumes more
than the maximum capacity is used, the protection circuit will cut the power
supply.
Appliances that may not operate properly (120 V AC)
The following 120 V AC appliances may not operate even if their power con-
sumption is under maximum capacity.
Appliances with high initial peak wattage
Measuring devices that process precise data.
Other appliances that require an extremely stable power supply
To prevent battery discharge
Turn off all the vehicle’s electronic equipment and accessories, such as the
headlights and air conditioning, when electrical appliances that consume in
excess of 100 W are used continuously for long periods of time.
To prevent any damage caused by heat
Do not use any electrical appliances that give off intense heat, such as
toasters, in any locations including the internal or external trim, seats and
deck.
Do not use any electrical appliances that are easily affected by vibration or
heat inside the vehicle. Vibration while driving, or the heat of the sun while
parking, may result in damage to those electrical appliances.
If any electrical appliances are to be used while driving
Securely fasten both the appliances and their cables to prevent them from
falling or getting caught in any of the power train components.
If the power outlet is loose when an electrical appliance plug is con-
nected
Replace the outlet. Contact your Toyota dealer for any necessary replace-
ments.
If the power outlet gets dirty
Turn the main switch off and use a soft, clean cloth to wipe it gently. Do not
use any cleansing materials, such as organic solvents, wax, or compound
cleaners, as these may damage the power outlet or cause it to malfunction.
450
7-3. Do-it-yourself maintenance
Do-it-yourself service precautions
If you perform maintenance by yourself, be sure to follow the
correct procedure as given in these sections.
Items
Parts and tools
Battery condition
(
P. 463)
Warm water
Baking soda
• Grease
Conventional wrench (for terminal clamp bolts)
Brake fluid level
(
P. 460)
FMVSS No.116 DOT 3 or SAE J1703 brake fluid
Rag or paper towel
Funnel (used only for adding brake fluid)
Engine coolant
level (
P. 458)
• “Toyota Super Long Life Coolant” or a similar high
quality ethylene glycol-based non-silicate, non-
amine, non-nitrite and non-borate coolant with long-
life hybrid organic acid technology
For the U.S.A.:
“Toyota Super Long Life Coolant” is pre-mixed with
50% coolant and 50% deionized water.
For Canada:
“Toyota Super Long Life Coolant” is pre-mixed with
55% coolant and 45% deionized water.
Funnel (used only for adding coolant)
Engine oil level
(
P. 456)
“Toyota Genuine Motor Oil” or equivalent
Rag or paper towel
Funnel (used only for adding engine oil)
Fuses
(
P. 488)
Fuse with same amperage rating as original
Light bulbs
(
P. 491)
Bulb with same number and wattage rating as origi-
nal
Phillips-head screwdriver
Flathead screwdriver
• Wrench
Power steering
fluid level
(
P. 461
)
Automatic transmission fluid DEXRON
®
II or III
Rag or paper towel
Funnel (used only for adding power steering fluid)
Radiator and
condenser
(
P. 460)
Tire inflation
pressure
(
P. 476)
Tire pressure gauge
Compressed air source
Washer fluid
(
P. 465)
Water or washer fluid containing antifreeze (for win-
ter use)
Funnel (used only for adding water or washer fluid)
454
7-3. Do-it-yourself maintenance
Engine compartment
2TR-FE engine
Washer fluid tank
(
P. 465)
Radiator cap
Engine coolant reservoir
(
P. 458)
Engine oil filler cap(
P. 457)
Power steering fluid reservoir
(
P. 461)
Engine oil level dipstick
(
P. 456)
Brake fluid reservoir
(
P. 460)
Fuse box
(
P. 488)
Battery
(
P. 463)
Condenser
(
P. 460)
Radiator
(
P. 460)
1
2
3
4
5
6
7
8
9
10
11
455
7-3. Do-it-yourself maintenance
7
Maintenance and care
2GR-FKS engine
Washer fluid tank
(
P. 465)
Power steering fluid reservoir
(
P. 461)
Radiator cap
Engine oil level dipstick
(
P. 456)
Engine coolant reservoir
(
P. 458)
Engine oil filler cap (
P. 457)
Brake fluid reservoir
(
P. 460)
Fuse box
(
P. 488)
Battery
(
P. 463)
Condenser
(
P. 460)
Radiator
(
P. 460)
1
2
3
4
5
6
7
8
9
10
11
488
7-3. Do-it-yourself maintenance
Checking and replacing fuses
Turn the engine switch off.
Open the fuse box cover.
Engine compartment
Push the tabs in and lift the
cover off.
Under the instrument panel
Remove the cover.
Remove the fuse with the pull-
out tool.
Only type A fuse can be removed
using the pullout tool.
If any of the electrical components do not operate, a fuse may
have blown. If this happens, check and replace the fuses as nec-
essary.
1
2
3
489
7-3. Do-it-yourself maintenance
7
Maintenance and care
Check if the fuse is blown.
Normal fuse
Blown fuse
Type A and B:
Replace the blown fuse with a new fuse of an appropriate amperage rat-
ing. The amperage rating can be found on the fuse box cover.
Type C:
Contact your Toyota dealer.
After a fuse is replaced
If the lights do not turn on even after the fuse has been replaced, a bulb may
need replacement. (
P. 491)
If the replaced fuse blows again, have the vehicle inspected by your Toyota
dealer.
If there is an overload in a circuit
The fuses are designed to blow, protecting the wiring harness from damage.
4
1
2
Type A
Type B
Type C
490
7-3. Do-it-yourself maintenance
WARNING
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failure to do so may cause damage to the vehicle, and possibly a fire or
injury.
Never use a fuse of a higher amperage rating than that indicated, or use
any other object in place of a fuse.
Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
Do not modify the fuses or fuse boxes.
NOTICE
Before replacing fuses
Have the cause of electrical overload determined and repaired by your Toy-
ota dealer as soon as possible.
555
8
When trouble arises
8-2. Steps to take in an emergency
If the engine will not start
One of the following may be the cause of the problem:
There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
The engine may be flooded.
Try to restart the engine again following correct starting procedures.
(
P. 189, 192)
There may be a malfunction in the engine immobilizer system.
(if equipped) (
P. 69)
One of the following may be the cause of the problem:
The battery may be discharged. (
P. 559)
The battery terminal connections may be loose or corroded.
The engine starting system may be malfunctioning due to an electrical
problem such as an open circuit or a blown fuse. However, an interim
measure is available to start the engine. (
P. 556)
If the engine will not start even though correct starting proce-
dures are being followed (
P. 189, 192), consider each of the fol-
lowing points.
The engine will not start even though the starter motor operates
normally.
The starter motor turns over slowly, the interior lights and head-
lights are dim, or the horn does not sound or sounds at a low
volume.
The starter motor does not turn over (vehicles with a smart key
system)
602
9-3. Items to initialize
Items to initialize
*
1
: If equipped
*
2
: For U.S.A. only
The following items must be initialized for normal system opera-
tion after such cases as the battery being reconnected, or main-
tenance being performed on the vehicle:
Item
When to initialize
Reference
Moon roof
*
1
After reconnecting or chang-
ing the battery
After changing a fuse
P. 154
Maintenance
required
reminder
light
(vehicles
without a multi-information
display) or message indicat-
ing maintenance is required
(vehicles with a multi-infor-
mation display)
*
2
After the maintenance is per-
formed
P. 445
Tire pressure warning sys-
tem
*
1
When rotating the tires.
When changing the tire size.
P. 468