Toyota Tacoma - 2015 Fuse Box Diagram

Toyota Tacoma - 2015 Fuse Box Diagram

357
3-5. Other interior features
3
Interior and exterior features
NOTICE
To avoid damaging the power outlet and the plug
Close the power outlet lid when not in use.
Foreign objects or liquids that enter the power outlet may cause a short
circuit.
Do not use plug adaptors to connect too many plugs to the power outlet.
After inserting a plug, gently close the power outlet lid.
To prevent the fuse from being blown
Do not use a 120 VAC appliance that requires more than maximum capacity.
If a 120 VAC appliance that consumes more than maximum capacity is
used, the protection circuit will cut the power supply.
Appliances that may not operate properly (120 VAC)
The following 120 VAC appliances may not operate even if their power con-
sumption is under maximum capacity.
Appliances with high initial peak wattage
Measuring devices that process precise data
Other appliances that require an extremely stable power supply
To prevent the battery from being discharged
Turn off all the vehicle’s electronic equipment and accessories, such as the
headlights and air conditioning, when electrical appliances that consume in
excess of 100W are used continuously for long periods of time.
To prevent any damage caused by heat
Do not use any electrical appliances that give off intense heat such as
toasters, in any locations including the internal or external trim, seats and
deck.
Do not use any electrical appliances, which are easily affected by vibration
or heat, inside the vehicle.
Vibration while driving, or the heat of the sun while parking, may result in
damage to those electrical appliances.
400
4-3. Do-it-yourself maintenance
Do-it-yourself service precautions
If you perform maintenance yourself, be sure to follow the correct
procedures as given in these sections.
Items
Parts and tools
Battery condition
(
P. 418)
• Warm water
• Baking soda
• Grease
• Conventional wrench
(for terminal clamp bolts)
Brake fluid level
(
P. 414)
• FMVSS No.116 DOT 3 or SAE
J1703 brake fluid
• Rag or paper towel
Engine coolant level
(
P. 412)
• “Toyota Super Long Life Coolant”
or similar high quality ethylene
glycol based non-silicate, non-
amine, non-nitrite and non-borate
coolant with long-life hybrid
organic acid technology.
U.S.A.:
“Toyota Super Long Life Coolant”
is pre-mixed with 50% coolant
and 50% deionized water.
Canada:
“Toyota Super Long Life Coolant”
is pre-mixed with 55% coolant
and 45% deionized water.
Engine oil level
(→
P. 408)
• Toyota Genuine Motor Oil or
equivalent
• Rag or paper towel
• Funnel (used only for adding oil)
Fuses
(
P. 444)
Fuse with same amperage rating
as original
406
4-3. Do-it-yourself maintenance
Engine compartment
2.7 L 4-cylinder (2TR-FE) engine
Washer fluid tank (
P. 420)
Radiator cap
Engine coolant reservoir
(
P. 412)
Engine oil filler cap
(
P. 409)
Power steering fluid reservoir
(
P. 416)
Engine oil level dipstick
(
P. 408)
Brake fluid reservoir
(
P. 414)
Fuse box
(
P. 444)
Battery
(
P. 418)
Condenser
(
P. 414)
Radiator
(
P. 414)
407
4-3. Do-it-yourself maintenance
4
Maintenance and care
4.0 L V6 (1GR-FE) engine
Washer fluid tank (
P. 420)
Power steering fluid reservoir
(
P. 416)
Radiator cap
Engine oil level dipstick
(
P. 408)
Engine coolant reservoir
(
P. 412)
Engine oil filler cap
(
P. 409)
Brake fluid reservoir
(
P. 414)
Fuse box
(
P. 444)
Battery
(
P. 418)
Condenser
(
P. 414)
Radiator
(
P. 414)
444
4-3. Do-it-yourself maintenance
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have
blown. If this happens, check and replace the fuses as necessary.
Turn the engine switch to the LOCK position.
The fuses are located in the following places. To check the
fuses, follow the instructions below.
Engine compartment
Push the tab in and lift the lid
off.
Under the instrument panel
1.Open the auxiliary box.
2.Pull up the box and disen-
gage the claws. Remove the
stoppers from the cutouts
and remove the box.
445
4-3. Do-it-yourself maintenance
4
Maintenance and care
After a system failure, see “Fuse layout and amperage
ratings” (
P. 447) for details about which fuse to check.
Remove the fuse with the pull-
out tool.
Check if the fuse has blown.
Type A
Normal fuse
Blown fuse
Replace it with one of an
appropriate amperage rating.
The amperage rating can be
found on the fuse box lid.
446
4-3. Do-it-yourself maintenance
Type B
Normal fuse
Blown fuse
Replace it with one of an
appropriate amperage rating.
The amperage rating can be
found on the fuse box lid.
Type C
Normal fuse
Blown fuse
Replace it with one of an
appropriate amperage rating.
The amperage rating can be
found on the fuse box lid.
Type D
Normal fuse
Blown fuse
Replace it with one of an
appropriate amperage rating.
The amperage rating can be
found on the fuse box lid.
447
4-3. Do-it-yourself maintenance
4
Maintenance and care
Fuse layout and amperage ratings
Engine compartment
Type A
Type B
448
4-3. Do-it-yourself maintenance
Fuse
Ampere
Circuit
1
A/C
10 A
Air conditioning system
2
TOWING TAIL
30 A
Trailer lights (tail lights)
3
FOG FR
15 A
Front fog lights
4
STOP
10 A
Stop lights, high mounted stop-
light, vehicle stability control sys-
tem, anti-lock brake system, shift
lock system, multiport fuel injection
system/sequential multiport fuel
injection system, towing lights
5
TOWING BRK
30 A
Trailer brake controller
6
EFI
10 A
Multiport fuel injection system/
sequential multiport fuel injection
system
7
S/HTR NO.2
30 A
Seat heaters
8
OBD
7.5 A
On-board diagnosis system
9
BATT CHG
30 A
Trailer sub battery
10
AIR PMP HTR
10 A
AI system
11
TOWING
30 A
Towing lights
12
TURN & HAZ
15 A
Turn signal lights, emergency
flashers, meter and gauge
13
RADIO NO.2
30 A
Audio system
14
H-LP RH-LO
10 A
Right-hand headlight (low beam),
front fog lights
15
H-LP LH-LO
10 A
Left-hand headlight (low beam)
16
H-LP RH-HI
10 A
Right-hand headlight (high beam)
17
H-LP LH-HI
10 A
Left-hand headlight (high beam),
meter and gauge
18
ETCS
10 A
Multiport fuel injection system/
sequential multiport fuel injection
system, electronic throttle control
system
449
4-3. Do-it-yourself maintenance
4
Maintenance and care
19
ALT-S
7.5 A
Charging system
20
EFI-MAIN
20 A
Multiport fuel injection system/
sequential multiport fuel injection
system
21
HORN
10 A
Horn
22
A/F HTR
15 A
Multiport fuel injection system/
sequential multiport fuel injection
system
23
ECU-B
7.5 A
Wireless remote control system, air
conditioning system, multiplex
communication system, meter and
gauge, front passenger occupant
classification system, garage door
opener
24
DOME
7.5 A
Interior light, personal lights, vanity
lights
25
RADIO NO.1
20 A
Audio system
26
STA
7.5 A
Starting system, multiport fuel
injection system/sequential multi-
port fuel injection system, meter
and gauge, clutch start cancel
switch
27
Spare
10 A
Spare fuse
28
Spare
15 A
Spare fuse
29
S/HTR NO.1
50 A
Seat heaters
30
J/B
50 A
TAIL, AC SKT, DR LCK, D FR P/W,
D RR P/W, P FR P/W and P RR
P/W fuses
31
AM1
50 A
ACC, IG1, IG1 NO.2, WIP, WSH,
4WD, BKUP LP and STA fuses
32
HTR
50 A
A/C fuse, air conditioning system
33
ABS NO.1
50 A
Anti-lock brake system, vehicle sta-
bility control system
Fuse
Ampere
Circuit
450
4-3. Do-it-yourself maintenance
*
: Replace the fuse with one of the same ampere rating as the original
34
AM2
30 A
IGN and GAUGE fuses, multiport
fuel injection system/sequential
multiport fuel injection system
35
AIR PMP
50 A
Multiport fuel injection system/
sequential multiport fuel injection
system
36
ABS NO.2
30 A
Anti-lock brake system, vehicle sta-
bility control system
37
INV
100 A
Power outlets
38
ALT
120 A*
AM1, AC SKT, HEATER, FR FOG,
STOP, OBD, J/B, TOWING TAIL,
TOWING BRK and BATT CHG
fuses
140 A*
Fuse
Ampere
Circuit
451
4-3. Do-it-yourself maintenance
4
Maintenance and care
Under the instrument panel
Fuse
Ampere
Circuit
1
IGN
15 A
Multiport fuel injection system/
sequential multiport fuel injection
system, anti-lock brake system,
traction control system, vehicle sta-
bility control system, SRS airbag
system, front passenger occupant
classification system
2
GAUGE
7.5 A
Meter and gauge, emergency
flashers
3
TAIL
10 A
Tail lights, license plate lights, park-
ing lights, multiport fuel injection
system/sequential multiport fuel
injection system, instrument panel
light control, illuminations
4
ACC
7.5 A
Shift lock system, outside rear view
mirrors, audio system, power out-
lets
5
PWR OUTLET
15 A
Power outlets
6
DR LCK
20 A
Door lock system
452
4-3. Do-it-yourself maintenance
7
IG1 NO.2
10 A
Anti-lock brake system, vehicle sta-
bility control system, stop lights,
charging system, multiport fuel
injection system/sequential multi-
port fuel injection system, air condi-
tioning system, instrument panel
light control, anti-glare inside rear
view mirror, back monitor, clutch
start cancel switch, rear differential
lock system, power outlets, tire
pressure warning system
8
BKUP LP
10 A
Trailer lights (back-up lights)
9
IG1
10 A
Anti-lock brake system, traction
control system, vehicle stability
control system, back-up lights, air
conditioning system, shift lock sys-
tem, audio system
10
P RR P/W
20 A
Rear passenger’s power window
(right side)
11
P FR P/W
20 A
Front passenger’s power window
12
WSH
10 A
Wipers and washer
13
D RR P/W
20 A
Rear passenger’s power window
(left side)
14
4WD
20 A
Four-wheel drive system, rear dif-
ferential lock system
15
WIP
30 A
Wipers and washer
16
D FR P/W
30 A
Power windows
Fuse
Ampere
Circuit
453
4-3. Do-it-yourself maintenance
4
Maintenance and care
After a fuse is replaced
If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (
P. 454)
If the replaced fuse blows again, have the vehicle inspected by your
Toyota dealer.
If there is an overload in the circuits
The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage to the vehicle, and possibly a fire or
injury.
Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
Always use a genuine Toyota fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
Do not modify the fuse or the fuse box.
NOTICE
Before replacing fuses
Have the cause of electrical overload determined and repaired by your Toy-
ota dealer as soon as possible.