Polaris Universal Watercraft - 2004 Fuse Box Diagram

Polaris Universal Watercraft - 2004 Fuse Box Diagram

34
FEATURES
Engine Components
Engine Compartment
1.
Spark plugs
2.
Air intake cover
3.
Exhaust pipe
4.
Water temperature sensor
5.
Exhaust cooling hose
6.
Exhaust silencer
7.
Engine water outlet hose (underneath thermostat assembly)
8.
Water manifold
9.
Thermostat assembly
10.
Electrical box (circuit breaker and fuses)
11.
Fuel/water separator
12.
Exhaust coolant filter
13.
Air filter
14. Battery
15. Bilge pump
16.
Starter solenoid
94
MAINTENANCE AND LUBRICATION
Choke Cable Inspection
Pull the choke knob out to fully close the
choke valve (1).
Make sure the choke cable is
operating smoothly. In this position, the choke
is on.
Reverse the procedure to
open the choke valve (turn the
choke off)(2).
There should be minimal choke
cable slack. If the choke is not
functioning properly, have it
serviced by your authorized
Polaris dealer.
Circuit Breaker (Virage/Freedom)
The electrical system is protected with a 15
amp circuit breaker. To reset the circuit
breaker, locate and push the reset buttons (A)
on top of the electrical box.
Fuses
Carb Models
The MFI is protected by a 1/4 amp fuse (B)
and the bilge pump is protected by a 3 amp
fuse (C).
Inspect the fuses every season to ensure
fuses are not blown. There are spare fuses
in the electrical box.
DI Models
The MFI is protected by a 2 amp fuse and
the bilge pump is protected by a 3 amp
fuse.
NOTE:
DI models have two 15 amp in-line fuses located on the
chassis harness.
1
2
A
C
B