Polaris MSX - 2003 Fuse Box Diagram

Polaris MSX - 2003 Fuse Box Diagram

85
MAINTENANCE AND LUBRICATION
Steering Cable Inspection
1.
The handlebars and steering nozzle should operate
smoothly. If movement is stiff, see your authorized
Polaris dealer for service.
2.
Turn the handlebars from lock to lock and check to
be sure that the clearances between the steering
nozzle and the rear hull are even on both sides. If
the alignment is not even, see your authorized
Polaris dealer for service.
Throttle Cable Inspection
1.
Depress and release the throttle lever. It should
return to its initial position smoothly. If it doesn
t,
see your authorized Polaris dealer for service.
2.
Throttle lever free-play should not exceed
.020
-.060
(.5-1.5 mm). If it does, see your
authorized Polaris dealer for service.
Fuses
The NGI is protected by
a 2 amp fuse.
There are
also two 15 amp inline
fuses on the chassis
harness for the fuel
pump and any battery
powered accessories.
After changing a fuse, always reinstall the weathertight
cover to keep the fuses dry.
.020-.060
(.5-1.5 mm)
Battery
Fuel Pump
NGI
15AMP
F
A
15AMP
2AMP
96
ENGINE TROUBLESHOOTING
Engine Doesn
t Turn Over
Possible Cause
Solution
Blown fuse
Replace the fuse
Low battery voltage
Recharge battery to 12.5 VDC
Loose battery connections or ground
Check all connections and tighten as needed
Hydrolock (water in engine)
See your Polaris dealer
Loose starter relay (solenoid) connections
Check all connections and tighten
Lanyard lock plate not in place
Install lock plate under shut-off switch
Engine Turns Over But Doesn
t Start
Possible Cause
Solution
Out of fuel
Refuel
Old or non-recommended fuel
Replace with new fuel
Fouled or defective spark plugs
Inspect plugs, replace as needed
Crankcase filled with water or fuel
See your Polaris dealer
Clogged fuel filter
Replace the filter
Low battery voltage
Recharge battery to 12.5 VDC
Mechanical failure
See your Polaris dealer