Polaris Victory Vision - 2009 Fuse Box Diagram

Polaris Victory Vision - 2009 Fuse Box Diagram

84
INSTRUMENTS, FEATURES, & CONTROLS
Controls
Tool Kit
The tool kit can be used to perform most of
the basic maintenance items and some of the
general repairs.
1.
4mm Ball Drive Allen Wrench
2.
4mm / 6mm Open End Wrench
3.
6mm Ball Drive Allen Wrench
4.
8mm / 10mm Open End Wrench
5.
Combination Phillips / Slot Screw Driver
6.
Rear Shock Absorber / Tire Pressure
Gauge
7.
Fuse Puller
2
1
3
4
5
6
7
visionownersmanual.book
Page 84
Wednesday, February 13, 2008
4:31 PM
127
OPERATION
Operation
Reverse
NOTICE:
Do not attempt to engage or disengage the reverse system when the motorcycle is
moving.
NOTE:
The starter system will not function if the reverse lever is
engaged
. If the reverse system
fuse blows, the starter button will not function even if the reverse lever is
disengaged
. The
fuse must be replaced. See “Fuse Replacement” on page 186.
BEFORE operating in reverse
NEVER operate in reverse
always sit on the motorcycle with legs astride
and both feet on the ground.
always check for obstacles or people behind
the motorcycle.
always retract the sidestand fully.
always make sure the motorcycle is not
moving.
when you are not seated in a normal
operating position
when in an area where obstacles or
bystanders are present.
with a passenger on board. A passenger can
obstruct your view and maneuverability.
on loose or slippery surfaces. Loss of foot
traction could cause a tip-over.
when the motorcycle is moving.
on a grade or uneven surfaces.
visionownersmanual.book
Page 127
Wednesday, February 13, 2008
4:31 PM
179
MAINTENANCE
Maintenance
Battery Precautions
The motorcycle uses a permanently sealed, maintenance-free battery. Do not remove the
battery cap strip for any reason. Keep the battery connections clean and tight at all times.
NOTICE:
If your VICTORY motorcycle will not be used for a period of 6 weeks or longer, a
maintenance charger should be connected to the battery. A fused maintenance charger
connection is provided. The connector is designed for use with the VICTORY accessory
maintenance charger available at your authorized VICTORY dealer.
WARNING
The battery contains sulfuric acid, which can cause severe burns. Do not allow sulfuric
acid to contact skin, eyes, or clothing.
ANTIDOTES:
EXTERNAL
- Flush with water.
INTERNAL
- drink large quantities of water or milk. Follow with milk of magnesia, beaten
eggs, or vegetable oil. Call a physician immediately.
EYES
: Flush with water immediately and get medical attention.
visionownersmanual.book
Page 179
Wednesday, February 13, 2008
4:31 PM
184
MAINTENANCE
Maintenance
Windshield Trim Panel
To remove the panel:
1.
Release corners of panel by lifting straight
upward at each end (1).
2.
Carefully slide panel toward windshield to
disengage lower tabs (2) and remove the panel.
3.
Unplug the antenna.
4.
To install, reverse the above steps.
With the trim panel removed, you can access:
Fuse boxes
Windshield adjustment mechanism (manual)
Headlamp adjustment knob
Front turn signal bulbs
1
2
visionownersmanual.book
Page 184
Wednesday, February 13, 2008
4:31 PM
185
MAINTENANCE
Maintenance
Fuse Box
There are two fuse boxes under the windshield trim panel. Remove the trim panel
(page 184) to access the fuses, auto-reset circuit breakers, and relays. Use the fuse puller
provided in the tool kit to remove a fuse if necessary.
.
LEFT FUSE BOX
RIGHT FUSE BOX
(Decal P/N 7174111)
(Decal P/N 7175380)
visionownersmanual.book
Page 185
Wednesday, February 13, 2008
4:31 PM
186
MAINTENANCE
Maintenance
Fuse Replacement
1.
Remove the windshield trim panel (page 184).
NOTE:
The reverse system fuse is located on the left
rear side of the motorcycle, under the seat
.
2.
Push center of darts upward and remove the
fuse box cover panel(s).
3.
Pull the tabs to release the cover(s).
NOTICE:
Use only the recommended fuse to prevent
electrical system damage. Fuse application
and size is printed on the cover label.
Push Center UP
Right Fuse Box
Left Fuse Box
Reverse System
25 amp mini fuse
visionownersmanual.book
Page 186
Wednesday, February 13, 2008
4:31 PM
244
SPECIFICATIONS
Specifications
Wheels And Tires
Front Wheel Type / Size
Cast or Billet 18 x 3.0 inch
Front Tire Type / Size
Dunlop Elite 3 - 130/70R18 63H
Radial
Rear Wheel Type / Size
Cast or Billet 16 x 5.0 inch
Rear Tire Type / Size
Dunlop Elite 3 - 180/60R16 74H
Radial
Electrical
Alternator
50 Amp Maximum Output
Battery
12 Volt / 18 Amp Hour / 310 CCA / Yuasa YTX20HL
Fuses
/ Circuit Breakers
(Left Fuse Box) (See page 185)
Ignition
10A Breaker
Headlight
20A Breaker
Gauges
5A
Dimensions and specifications may vary with features, options and accessories. Specifications subject to
change without notice or obligation.
2009
VICTORY VISION
visionownersmanual.book
Page 244
Wednesday, February 13, 2008
4:31 PM
245
SPECIFICATIONS
Specifications
Light & Fuses (Continued)
Fuses
(Left Fuse Box, Continued)
Radio
25A
Secondary Lights
20A
Horn
20A
Turn Signal / Brake
20A
(Right Fuse Box) (See page 185)
Engine
15A Breaker
Windshield (Electric)
20A
Fuel Pump / Ignition Coil
15A
Chassis
20A
Dimensions and specifications may vary with features, options and accessories. Specifications subject to
change without notice or obligation.
2009
VICTORY VISION
visionownersmanual.book
Page 245
Wednesday, February 13, 2008
4:31 PM