Polaris Vegas Eight Ball - 2007 Fuse Box Diagram

Polaris Vegas Eight Ball - 2007 Fuse Box Diagram

26
SAFETY
Location of Safety and Vehicle Information Labels (All Models)
Location F
FUSE and RELAY LOCATION
(Under side cover, on side of fuse box cover)
FUSE BOX REMOVAL
(on base of fuse box)
32
COMPONENT IDENTIFICATION
RIGHT SIDE -- VEGAS / VEGAS EIGHT BALL
1.
Drive Belt (under guard)
2.
Passenger Seat (except VEGAS EIGHT BALL)
3.
Seat Strap
4.
Operator’s Seat
5.
Side Cover
6.
Rear Shock Absorber (access through RH side cover)
7.
Front Turn Signal
8.
Front Fork
9.
Oil Cooler
10. Rear Brake Pedal
11. Operator Foot Rest
12. Engine Oil Fill Cap/Dipstick
13. Rear Brake Fluid Reservoir (under side cover)
14. Drive Sprocket (under cover)
15. Fuses (under side cover)
16. Passenger Foot Rest (except VEGAS EIGHT BALL)
17. Exhaust Muffler (2)
1
2
4
5
6
7
8
9
10
11
12
13
14
15
16
3
17
35
COMPONENT IDENTIFICATION
RIGHT SIDE -- KINGPIN
1.
Passenger’s Seat
2.
Seat Strap
3.
Operator’s Seat
4.
Rear Shock Absorber
(access through RH side cover)
5.
Side Cover
6.
Engine Oil Fill Cap/Dipstick
7.
Front Brake Lever
8.
Front Turn Signal
9.
Horn
10. Front Fork
11. Rear Brake Pedal
12. Operator’s Foot Rest
13. Rear Brake Fluid Reservoir
14. Drive Sprocket (under cover)
15. Fuses (under side cover)
16. Passenger Foot Rest
17. Drive Belt (under guard)
18. Exhaust Muffler (2)
1
2
3
5
6
4
7
8
10
9
11
12
13
14
15
16
17
18
50
INSTRUMENTS, FEATURES AND CONTROLS
Side Covers
Your motorcycle is equipped with two removable side covers.
Remove the left side cover to access the battery. Remove the right
side cover to access the fuses and the rear brake fluid reservoir.
To remove either side cover, pull the rear corner of the side cover
out slightly until tab (A) is disengaged. Pull lower edge (B) out and
then front edge (C) to disengage remaining tabs and remove cover.
Be sure rubber grommets are in place before reversing the above
procedure to install the side covers. A solution of dish soap and
water can be used as a lubricant if required for installation.
Sidestand
The sidestand is located on the left side of the motorcycle.
Correctly retract the sidestand before operating the motorcycle. An improperly retracted sidestand
could come into contact with the ground and cause loss of control.
WARNING
To extend the sidestand, swing it out from the end until it is fully extended. Lean the motorcycle toward the
sidestand until the sidestand firmly supports the motorcycle.
To retract the sidestand, lean the motorcycle away from the sidestand until the motorcycle is fully upright. Swing
the sidestand back into its fully retracted position.
A
B
C
98
MAINTENANCE
Rear Suspension
Adjust Rear Shock Absorber Preload (Ride Height)
1.
S
Rest motorcycle on sidestand. Remove right side cover.
S
Remove the fuse box from right panel (page 128). Make sure
rear brake fluid reservoir cap is secured to prevent fluid loss.
S
Remove three bolts (A) holding fuse box bracket to chassis.
S
Remove the wire harness dart (B) from the fuse box bracket
by squeezing the tabs with a long nose pliers.
S
. Carefully pull and rotate the fuse box bracket toward the front
of the motorcycle.
2.
The uppermost spanner nut on the shock is the locknut (1). The
spanner nut closest to the spring is the adjuster nut (2). Loosen the
locknut by turning it counterclockwise (as viewed from the top of
shock absorber) with the spanner wrench.
3.
Spray a light lubricant on the adjuster nut where it contacts the
spring. DO NOT allow spray to contact the drive belt.
4.
Adjust shock absorber preload by rotating adjuster nut clockwise (as
viewed from the top of shock absorber) to INCREASE the ride
height measurement (firm), and counterclockwise to DECREASE
the ride height measurement (softer). Re-check ride-height.
5.
Tighten lock nut securely against adjuster nut.
6.
Reinstall fuse box bracket. Securely tighten the 3 bolts.
7.
Re-install fuse box and right side cover.
A
B
1. Preload Adjustment Locknut
2. Preload Adjuster Nut
3. Increase Ride Height Measurement
4. Reduce Ride Height Measurement
1
3
4
2
123
MAINTENANCE
Seat Removal and Installation
There are two separate seats, the operator’s seat and the passenger seat (except 8-Ball). It is not necessary to
remove the passenger seat for regular maintenance. The passenger seat mounting screws are located on each side of
the seat under the chrome covers.
Always make sure the seats are securely fastened before riding the motorcycle. A loose seat could
cause a sudden shift in riding position, causing loss of control.
WARNING
1.
Remove the right and left side covers.
2.
Remove the fuse box from the bracket (see page 26).
3.
Remove the screws located on the right and left sides of
the operator’s seat.
4.
Lift the rear of the seat and pull rearward and up to
remove.
5.
To reinstall the seat, slide the tongue of the seat into the
rubber mount at rear of fuel tank.
6.
Push down on the rear of the seat until the screw holes
align.
7.
Ensure the front seat mount is engaged in the front
rubber mount, then install the screws and tighten securely.
8.
Reinstall the fuse box and the left and right side covers.
1. Remove Side Covers
2. Remove Fuse Box and
Right Seat Screw
3. Remove Left Seat Screw
4. Lift Rear of Seat, Pull
Rearward
2
3
4
124
MAINTENANCE
Battery
The battery contains sulfuric acid, which can cause severe burns. Do not allow sulfuric acid to
contact skin, eyes, or clothing.
Antidotes:
External: Flush with water.
Internal: Drink large quantities of water or milk. Follow with milk of magnesia, beaten eggs, or
vegetable oil. Call physician immediately.
Eyes: Flush with water for 15 minutes and get prompt medical attention.
WARNING
The motorcycle uses a permanently sealed, maintenance-free battery. Do not remove the battery cap strip for any
reason. Keep the battery connections clean and tight at all times.
Notice
If your VICTORY motorcycle will not be used for a period of 6 weeks or longer, a maintenance charger
should be connected to the battery. A fused maintenance charger connection is provided beneath the left side cover. The
connector is designed for use with the VICTORY maintenance charger available at your authorized VICTORY dealer.
128
MAINTENANCE
Fuses
Use only recommended amperage fuses to avoid damage to the electrical system.
Caution
1.
Remove the right side cover and release the fuse box from the bracket.
2.
Release the tabs on each side of the fuse box cover, and remove the cover.
3.
Remove the damaged fuse from the fuse box and seat the new fuse firmly in its
place. A spare 15 amp fuse is located in the fuse box.
4.
Reinstall the fuse box cover with the double cutout toward the front of the
motorcycle. The fuse box decal should be readable from the right side of the
motorcycle.
5.
Reinstall the fuse box to the bracket.
NOTE:
The fuse box assembly can be removed by lifting the lever tab at the front
of the fuse box and sliding the box forward to release from bracket.
6.
Reinstall the side cover and the operator’s seat.
Fuse Application
Fuse Size
Engine / ECM
15 amp
Fuel Pump
10 amp
Headlamp / Brake Lamp
15 amp
Tail Lamp, Flashers, Indicator Lamp, Horn
15 amp
Ignition / Gauges
15 amp
Spare Fuse
15 amp
1
157
SPECIFICATIONS
Model Year 2007
VEGAS / VEGAS EIGHT BALL
KINGPIN / KINGPIN TOUR
Wheels and Tires
Front Wheel Type/Size
Cast or Billet 21 x 2.15
Cast or Billet 18 x 3.0
Rear Wheel Type Size
Cast or Billet 18 x 5.0
Cast or Billet 18 x 5.0
Front Tire Type/Size
Dunlop Elite 3
(90/90 - 21
54H)
Dunlop 491 Elite ll
(130/70 - B18
63H)
Rear Tire Type/Size
Dunlop D417 (180/55-B18
74V)
Dunlop D417 (180/55-B18 74V)
Electrical
Alternator
38 Amp Max Output
38 Amp Max Output
Battery
12 Volts 18 Amp Hour
12 Volts 18 Amp Hour
Lights and Fuses
Fuses
Engine / ECM
15 amp
15 amp
Fuel Pump
10 amp
10 amp
Headlamp / Brake Lamp
15 amp
15 amp
Tail Lamp, Flashers,
Indicator Lamps, Horn
15 amp
15 amp
Ignition / Gauges
15 amp
15 amp
Bulbs
Headlamp (International)
High: H8 / Low H11 (H4)
High: H8 / Low H11 (H4)
Taillight
Non-Serviceable LED
Non-Serviceable LED
Turn Signal
R10W
R10W
Indicator
2.3 Watt Wedge Base
2.3 Watt Wedge Base
NOTE: Dimensions and specifications may vary with features, options and accessories.