Polaris Scrambler XP 850 EPS - 2013 Fuse Box Diagram

Polaris Scrambler XP 850 EPS - 2013 Fuse Box Diagram

37
FEATURES AND CONTROLS
Front Rack/Compartment
Release the front rack latches
and remove the rack to gain
access to the front compart-
ment. To reinstall the rack,
hold the rack as shown in the
illustration. Position the front
edge in the tabs, then push the
rack downward and secure
the latches.
Access the following
components in the front
compartment:
Radiator cap
Brake fluid reservoir
• Battery
Coolant recovery bottle cap
Electrical/fuse/relay components
Latches
Brake Fluid
Reservoir
Radiator
Cap
Coolant Bottle Cap
Electrical/Fuse/Relay
Battery
79
MAINTENANCE
Fuse Replacement
If the engine stops or will not start,
or if you experience other electri-
cal failures, a fuse may need
replacement. Locate and correct
any short circuits that may have
caused the blown fuse, then
replace the fuse.
1.
Remove the front rack.
2.
Remove the fuse box cover.
3.
Remove the suspect fuse from
the fuse panel. If the fuse is
blown, install a new fuse with
the same amperage rating.
4.
Reinstall the fuse box cover.
5.
Reinstall the front rack.
Fuse Box
109
WARRANTY
WARRANTY COVERAGE AND EXCLUSIONS:
LIMITATIONS OF WARRANTIES AND REMEDIES
The POLARIS limited warranty excludes any failures that are not caused by a defect in
material or workmanship. This warranty does not cover accidental damage, normal wear
and tear, abuse or improper handling. This warranty also does not cover any vehicle that
has been altered structurally, modified, neglected, improperly maintained, used for rac-
ing, or used for purposes other than for which it was manufactured, or for any damages
which occur during trailer transit or as a result of unauthorized service or the use of
unauthorized parts. In addition, this warranty does not cover physical damage to paint or
finish, stress cracks, tearing or puncturing of upholstery material, corrosion, or defects in
parts, components or the vehicle due to fire, explosions or any other cause beyond
POLARIS' control.
Warranty does not apply to parts exposed to friction surfaces, stresses, environmental
conditions and/or contamination for which they were not designed or not intended,
including but not limited to the following items:
Wheels and tires
Finished and unfinished surfaces
Suspension components
Carburetor/Throttle body components
Brake components
Engine components
Seat components
Drive belts
Clutches and components
Hydraulic components
Steering components
Circuit breakers/Fuses
Batteries
Electronic components
Light bulbs/Sealed beam lamps