Polaris Outlaw 525 IRS - 2011 Fuse Box Diagram

Polaris Outlaw 525 IRS - 2011 Fuse Box Diagram

39
Features and Controls
Main Key Switch
The main key switch must be in the RUN position to start the engine. See page 66 for starting
procedures.
Start Button
Press the start button to engage the starter. Always release the start button promptly when the
engine starts. If the starter fails to engage, replace the blown fuse or see your POLARIS
dealer.
Engine Stop Switch
Move the stop switch either left or right to the OFF
position to stop the engine quickly. The engine will
not start or run when the switch is off.
Both the main switch and the engine stop switch will
shut off all electrical power to the vehicle, including
lights.
OFF
OFF
RUN
174
Troubleshooting
Engine Doesn’t Turn Over
Engine Pings or Knocks
Possible Cause
Solution
Fuseable link
See POLARIS dealer for replacement
Low battery voltage
Recharge battery to 12.8 VDC
Loose battery connections
Check all connections and tighten
Loose solenoid connections
Check all connections and tighten
Possible Cause
Solution
Poor quality or low octane fuel
Replace with recommended fuel
Incorrect ignition timing
See your POLARIS dealer
Incorrect spark plug gap or heat range
Set gap to specs or replace plugs
182
Troubleshooting
Engine Overheats
Possible Cause
Solution
Debris lodged in screen
Remove and clean the screen
Plugged radiator
Use a garden hose to flush any debris from the radia-
tor fins. NOTE: High pressure washers can deform the
radiator fins and reduce cooling efficiency.
Insufficient coolant
Check levels and fill as needed; check for leaks
Insufficient air flow due to slow operation
Operate at a faster speed to increase air flow
Cooling system has not been bled
Bleed the cooling system
Foam has formed in cooling system
Drain and replace coolant with recommended coolant
Bent cooling hose
Shorten or replace hose
Defective thermostat or thermoswitch
See your POLARIS dealer
Blown fan fuse or defective fan
Replace fuse and check fan for proper operation or see
your POLARIS dealer
188
Warranty
WARRANTY COVERAGE AND EXCLUSIONS:
LIMITATIONS OF WARRANTIES AND REMEDIES
The POLARIS limited warranty excludes any failures that are not caused by a defect in material or workmanship. This warranty
does not cover accidental damage, normal wear and tear, abuse or improper handling. This warranty also does not cover any
ATV that has been altered structurally, modified, neglected, improperly maintained, used for racing, or used for purposes other
than for which it was manufactured, or for any damages which occur during trailer transit or as a result of unauthorized service
or the use of unauthorized parts. In addition, this warranty does not cover physical damage to paint or finish, stress cracks, tear-
ing or puncturing of upholstery material, corrosion, or defects in parts, components or the ATV due to fire, explosions or any
other cause beyond POLARIS' control.
Warranty does not apply to parts exposed to friction surfaces, stresses, environmental conditions and/or contamination for
which they were not designed or not intended, including but not limited to the following items:
Wheels and tires
Finished and unfinished surfaces
Suspension components
Carburetor/Throttle body components
Brake components
Engine components
Seat components
Drive belts
Clutches and components
Hydraulic components
Steering components
Circuit breakers/Fuses
Batteries
Electronic components
Light bulbs/Sealed beam lamps