Polaris Frontier Touring - 2005 Fuse Box Diagram

Polaris Frontier Touring - 2005 Fuse Box Diagram

32
FEATURES AND CONTROLS
Malfunction Indicator Lamp (MIL)
The Frontier is equipped with a
malfunction indicator lamp (CHECK
ENGINE light) to assist your Polaris dealer
in diagnosing problems. The MIL codes
are for reference only. Full diagnostics
must be performed by a Polaris dealer
trained to service EFI systems.
When enabled, the CHECK ENGINE light
will blink in numerical sequences to
indicate the type of failure. For example: two blinks, pause, one blink
is the sequence for code 21. To enable the blink codes, put a 30 amp
automotive fuse in the ACS bypass three times within 2 1/2 seconds,
leaving it in the third time.
NOTE:
Disconnect the negative battery lead for 10 seconds to clear
the code.
CAUTION
If the ACS 30 AMP bypass fuse is left in, electrical drainage will
occur. To avoid electrical drainage, always remove the fuse from
the ACS bypass AFTER the End of Sequence message (61)
appears.
MIL Diagnostic Code Summary
CODE
MIL
Description
21
Yes
Lost synchronization
Synchronization of crankshaft position lost
22
Yes
Throttle position sensor circuit error
Sensor signal is shorted to ground or at battery potential
23
Yes
RAM error
Hardware failure or serial EEPROM not initialized or failure
24
Yes
Speed circuit / sensor error
Crankshaft position sensor failure (if MIL stays on when cranking
there is no speed sensor input)
31
Yes
System too lean
Lambda sensor shorted to ground or battery voltage
32
Yes
02 Sensor circuit error
Short to battery or no activity detected
33
No
System too rich
Short term adaption at upper or lower limit.
34
No
Maximum adaption limit reached
Long-term adaption at upper or lower limit
42
Yes
Temperature sensor circuit error
Sensor short to ground/battery voltage/implausible signal
61
NA
End of sequence message
119
WARRANTY
Conditions and Exclusions
In order to qualify for warranty, the product must have been properly set up and tested by
a Polaris Dealer (if applicable). Failure of any dealer to perform the required vehicle Pre-
Delivery Inspection, perform all applicable service bulletins and have the consumer sign
the PDI form prior to delivery may void the warranty. Failure to provide proof of re-
quired periodic maintenance upon request may result in denial of warranty coverage. Use
of the recommended Polaris products for lubrication and maintenance as directed by the
Owner’s manual is highly recommended. Should a failure occur during the warranty
period resulting from the use of non-recommended products, warranty coverage may be
denied.
Warranty does not apply to parts exposed to friction surfaces, stresses, environmental
conditions and/or contamination. The following items are excluded from warranty con-
sideration if the failure was due to wear or not the direct result of a defect:
Skis
Ski wear rods
Tracks
Tires
Slide Rails
Suspension components
Clutches and components
Drive Belts
Steering components
Hydraulic components
Batteries
Circuit Breakers/Fuses
Light bulbs/Sealed beam lamps
Electronic components
Finished and unfinished surfaces
Wheels
Brake components
Throttle body components
Seat components
Engine components
Warranty applies to the product only and does not allow for coverage of personal loss.
Some items are considered “consumable,” meaning they are considered part of normal
maintenance or part of completing an effective repair. The following items are excluded
from warranty coverage in the event of a warranty claim:
Spark Plugs
Lubricants such as oil, grease, etc.
Filters
Batteries (unless defective)
Fuel
Cosmetic damage / repair
Sealants
Coolants
Hotel fees
Meals
Towing charges
Shipping/ handling fees
Mileage
Product pick-up / delivery
Rentals / Loss of product use
Loss of vacation / personal time
This warranty also excludes failures resulting from improper lubrication; improper en-
gine timing; improper fuel; surface imperfections caused by external stress, heat, cold or
contamination; operator error or abuse; improper component alignment, tension, adjust-
ment or altitude compensation; failure due to snow, water, dirt or other foreign substance
ingestion/contamination; improper maintenance; modified components; use of after mar-
ket components resulting in failure; unauthorized repairs; repairs made after the warranty
period expires or by an unauthorized repair center; use of the product in competition or
for commercial purposes. Warranty will not apply to any product which has been dam-
aged by abuse, accident, fire or any other casualty not determined a defect of materials or
workmanship.