FEATURES AND CONTROLS
Battery Discharge Indicator
The battery discharge indicator
displays the amount of charge
removed (used) from fully
batteries are fully charged, the
right-most bar illuminates, indi-
cating 0% has been used. The
charge status indicator will be
solid green (see page 26). As
the batteries discharge, the bar
If batteries are not allowed to recharge fully (solid green light), the battery
discharge indicator may be inaccurate.
When the second bar from the left flashes, battery discharge is at 70%.
The batteries should be recharged as soon as possible.
the batteries more than 80%.
If the two left-most bars begin to flash, battery damage may occur
with continued operation. Stop the vehicle and recharge the batteries.
The hour meter records and displays the hours of actual vehicle move-
ment since manufacture.
Auxiliary 12-Volt Terminal Board
The 12-volt terminal board is located under the hood. It contains con-
stant 12-volt, switched 12-volt and ground terminals that can be used to
power auxiliary lights and accessories. The terminals are limited to 10
Never install any accessory that grounds to the vehicle chassis.
The 12-volt receptacle can be used to power accessories, but is limited
to 10 amps (the terminal board and 12-volt outlet are fused together at
100% Remains (Full Charge)
Recharge the batteries
Check the brake system for
Check the brake pedal for
excessive travel or a spongy
Check the friction pads for
wear, damage and looseness.
Inspect the brake disc spline
and pad wear surface for
Change pads when worn to
3/64" (1 mm).
Always disconnect the main power connector before servicing or
unplugging any electrical components. See page 36.
If you experience electrical failures not related to the batteries, a fuse
may need replacement. Locate and correct any short circuits that may
have caused the blown fuse, then replace the fuse. Spare fuses are
located in the fuse blocks. See your Polaris dealer if you suspect a relay
or diode needs replacement.
main fuse block
under the hood on the driver’s
side. Always install fuses with
the recommended amperage to
avoid damage to the electrical
relay and diode block
located near the main fuse
48-volt fuse block
behind the controller, under the
cargo box. Always install 48-
volt fuses in the 48-volt fuse
Main Fuse Recommendations
48-Volt Fuse Recommendation
48-Volt Fuse Block
WARRANTY COVERAGE AND EXCLUSIONS:
LIMITATIONS OF WARRANTIES AND REMEDIES
The POLARIS limited warranty excludes any failures that are not caused by a defect in
material or workmanship. This warranty does not cover accidental damage, normal wear
and tear, abuse or improper handling. This warranty also does not cover any vehicle that
has been altered structurally, modified, neglected, improperly maintained, used for rac-
ing, or used for purposes other than for which it was manufactured, or for any damages
which occur during trailer transit or as a result of unauthorized service or the use of
unauthorized parts. In addition, this warranty does not cover physical damage to paint or
finish, stress cracks, tearing or puncturing of upholstery material, corrosion, or defects in
parts, components or the vehicle due to fire, explosions or any other cause beyond
Warranty does not apply to parts exposed to friction surfaces, stresses, environmental
conditions and/or contamination for which they were not designed or not intended,
including but not limited to the following items:
Wheels and tires
Finished and unfinished surfaces
Carburetor/Throttle body components
Clutches and components
Light bulbs/Sealed beam lamps