Nissan Frontier - 2003 Fuse Box Diagram

Nissan Frontier - 2003 Fuse Box Diagram

The power outlets are for powering electrical
accessories such as cellular telephones. They
are rated at 12 Volts 120 Watts maximum.
CAUTION
Take care as the outlet and plug may be
hot during or immediately after use.
This power outlet is not designed for
use with a cigarette lighter unit.
Do not use with accessories that ex-
ceed a 12 volt, 120W (10A) power draw.
Do not use double adapters or more
than one electrical accessory.
Use this power outlet with the engine
running. (If the engine is stopped, this
could result in a discharged battery.)
Avoid using when the air conditioner,
headlights or rear window defroster is
on.
Before
inserting
or
disconnecting
a
plug, be sure the electrical accessory
being used is turned OFF.
Push the plug in as far as it will go. If
good contact is not made, the plug may
overheat or the internal temperature
fuse may blow.
When not in use, be sure to close the
cap. Do not allow water to contact the
outlet.
Front
WIC0330
Console
WIC0331
Rear
WIC0332
POWER OUTLET (if so equipped)
2-24
Instruments and controls
pressed, and stops at the next broadcasting sta-
tion. If using the
button, once the highest
broadcasting station is reached, the radio contin-
ues in the SEEK mode at the lowest broadcasting
station. If using the
button, once the lowest
broadcasting station is reached, the radio contin-
ues in the SEEK mode at the highest broadcast-
ing station.
Manual tuning
Use the
and
buttons for manual
tuning. To move quickly through the channels,
hold either of the tuning buttons down.
SCAN tuning
Push and hold the SEEK/TRACK tuning button
(
or
) for more than 1.5 seconds.
SCAN illuminates in the display window, and the
radio station blinks. SCAN tuning begins from
low to high frequencies or high to low frequen-
cies, depending on which button is pressed.
SCAN tuning stops at each broadcasting station
for 5 seconds. When scanning, SCAN is solid
and the radio station blinks. When temporarily
stopped on a station, SCAN blinks and the sta-
tion display is solid. Pushing the button again
during this 5 second period stops SCAN tuning
and the radio remains tuned to that station.
0
Station memory operations
Each preset mode (A, B or C) has 6 presets,
capable of storing any combination of AM and FM
stations.
Press the PRESET ABC button to change be-
tween the presets:
A
B
C
The radio displays icon A, B or C to indicate
which set of presets is active.
To store a radio station in a preset:
1. Select the desired preset by pressing PRE-
SET ABC.
2. Tune to the desired station.
3. Press the desired station select button for
more than 3 seconds. For example, in the
illustrations, ch2 is to be memorized. The
radio
mutes
when
the
select
button
is
pushed.
4. When the indicator illuminates in the display
and the sound resumes, memorizing is com-
plete.
5. Other station select buttons can be set in
the same manner.
If the battery cable is disconnected, or if the radio
fuse opens, the radio memory is canceled. In that
case, reset the desired stations.
LHA0119
4-14
Heater, air conditioner and audio systems
Station memory operation — Travel Preset
is OFF
Each preset mode (A, B or C) has 6 presets,
capable of storing any combination of AM, FM
and FM RDS stations.
Press the PRESET ABC button to change be-
tween the presets:
A
B
C
The radio displays icon A, B or C to indicate
which set of presets is active.
To store a radio station in a preset:
1. Tune to the desired station.
2. Press the desired station select button (>2
seconds). For example, in the illustrations
ch3 is to be memorized.
3. When the indicator illuminates in the station
selection button, a beep will sound indicat-
ing memorization is complete. For FM sta-
tions, the indicator will turn green. For AM
stations, the indicator will turn amber.
4. Other station select buttons can be set in
the same manner.
If the battery cable is disconnected, or if the radio
fuse opens, the radio memory is canceled. In that
case, reset the desired stations.
LHA0081
WHA0064
Heater, air conditioner and audio systems
4-19
VG33E engine
1.
Fuse/fusible link holder
2.
Power steering fluid reservoir
3.
Automatic transmission fluid dipstick
(A/T model)
4.
Brake fluid reservoir
5.
Clutch fluid reservoir (M/T model)
6.
Air cleaner
7.
Windshield washer fluid reservoir
8.
Engine oil dipstick
9.
Radiator cap
10.
Engine oil filler cap
11.
Coolant reservoir
12.
Battery
WDI0269
Maintenance and do-it-yourself
8-7
VG33ER engine
1.
Fuse/fusible link holder
2.
Power steering fluid reservoir
3.
Automatic transmission fluid dipstick
(A/T model)
4.
Supercharger
5.
Brake fluid reservoir
6.
Air cleaner
7.
Windshield washer fluid reservoir
8.
Engine oil dipstick
9.
Radiator cap
10.
Engine oil filler cap
11.
Coolant reservoir
12.
Battery
WDI0270
8-8
Maintenance and do-it-yourself
1.
Fuse box
2.
Spare fuses
3.
Fuse puller
PASSENGER COMPARTMENT
CAUTION
Never use a fuse of a higher amperage
rating
than
specified
on
the
fuse
box
cover. This could damage the electrical
system or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
1. Be sure the ignition switch and the headlight
switch are OFF.
2. Pull the fuse box cover to remove
s
A
.
3. Remove the fuse with the fuse puller
s
B
.
WDI0304
FUSES
Maintenance and do-it-yourself
8-29
4. If the fuse is open, replace it with a known
good fuse.
5. Push the fuse box cover to install.
6. If a new fuse also opens, have the electrical
system checked and repaired by a NISSAN
dealer.
Replace the battery in the keyfob as follows:
s
1
Open the lid using a coin.
s
2
Remove the battery.
s
3
Install a new battery with the “+” facing
down.
Recommended
battery:
Toshiba
CR2025
or
equivalent.
s
4
Close the lid securely.
WDI0200
WPD0160
KEYFOB BATTERY REPLACEMENT
8-30
Maintenance and do-it-yourself