Nissan GT-R - 2014 Fuse Box Diagram

Nissan GT-R - 2014 Fuse Box Diagram

0-8
Illustrated table of contents
1.
Outside mirror control switch (P.3-28)
2.
Center dial*
3.
Audio system*
4.
Heater and air conditioner*
5.
Multi function display*
6.
Hazard warning flasher switch (P.6-2)
7.
Glove box (P.2-58)
8.
Fuse box cover (P.8-24)
9.
Power outlet (P.2-54)
10. Rear window defroster switch (P.2-49)
11. Front passenger air bag status light (P.1-41)
12. Compact Disc slot*
13. Trunk release power cancel switch (P.3-21)
*:
Refer
to
the
separate
Multi
Function
Display
Owner’s Manual.
INSTRUMENT PANEL
0-10
Illustrated table of contents
1.
Fuse/fusible link holder (P.8-24)
2.
Battery (P.8-17)
3.
Engine oil filler cap (P.8-12)
4.
Strut support bar (P.GTR-9)
5.
Engine oil dipstick (P.8-12)
6.
Brake fluid reservoir (P.8-15)
7.
Air cleaner (P.8-20)
8.
Power steering fluid reservoir (P.8-14)
9.
Radiator filler cap (P.8-10)
10. Coolant reservoir cap (pressure type) (P.8-10)
11. Coolant reservoir (P.8-10)
12. Window washer fluid reservoir (P.8-16)
ITEMS
GT-R SPECIFIED FLUIDS
Engine oil
Mobil 1 (0W-40)*1
Transmission oil
Genuine NISSAN Transmission
Oil R35 Special
Differential oil
(front and rear)
Differential Oil R35 COMPE-
TITION type 2189E
Brake fluid
Genuine NISSAN Brake Fluid
R35 Special II*2
*1: Mobil 1 (0W-40) (100% synthetic) is the factory
fill oil. The VR38 engine with its plasma-sprayed
bores
was
developed
using
this
oil.
NISSAN
cannot
ensure
proper
engine
operation
and
durability if other 0W-40 synthetic oil is used. If
Mobil 1 (0W-40) is not available, Mobil 1 (10W-
40) (100% synthetic) may be used; however,
some performance loss may be noticed.
*2: Genuine NISSAN Brake Fluid R35 Special II is the
factory
fill
brake
fluid.
The
Vehicle
Dynamic
Control (VDC) unit and other related parts were
specially designed for this brake fluid and NISSAN
cannot ensure proper operation of the vehicle if
other brake fluid is used.
ENGINE COMPARTMENT
2-4
Instruments and controls
1.
Outside mirror control switch (P.3-28)
2.
Center dial*
3.
Audio system*
4.
Heater and air conditioner*
5.
Multi function display*
6.
Hazard warning flasher switch (P.6-2)
7.
Glove box (P.2-58)
8.
Fuse box cover (P.8-24)
9.
Power outlet (P.2-54)
10. Rear window defroster switch (P.2-49)
11. Front passenger air bag status light (P.1-41)
12. Compact Disc slot*
13. Trunk release power cancel switch (P.3-21)
*:
Refer
to
the
separate
Multi
Function
Display
Owner’s Manual.
INSTRUMENT PANEL
.
Push the plug in as far as it will go.
If good contact is not made, the plug
may overheat or the internal tem-
perature fuse may open.
Next to the steering wheel
Pull out the cap to use the outlet.
Replace the cap after use.
Inside the console box
Open the cap to use the outlet.
Close the cap after use.
Instruments and controls
2-55
8-8
Maintenance and do-it-yourself
1.
Fuse/fusible link holder
2.
Battery
3.
Engine oil filler cap
4.
Strut support bar
5.
Engine oil dipstick
6.
Brake fluid reservoir
7.
Air cleaner
8.
Power steering fluid reservoir
9.
Radiator filler cap
10. Coolant reservoir cap (pressure type)
11. Coolant reservoir
12. Window washer fluid reservoir
NOTICE
The coolant reservoir is equipped with a
pressure type cap, and the radiator is
equipped with a non-pressure type cap.
Do not switch the radiator filler cap and
the coolant reservoir cap. Doing so will
cause
substandard
cooling
perfor-
mance and overheating.
ENGINE COMPARTMENT CHECK
LOCATIONS
8-24
Maintenance and do-it-yourself
If the inside of the disc rotors are cold during the
winter and the surface becomes hot due to a
heavy force being applied repeatedly to the
brakes, cracks may occur near the coolant hole
on the surface of the disc rotor. Cracks may also
occur due to a heavy force being repeatedly
applied to the brakes during high performance
driving. In these cases it may be necessary to
replace the disc rotors or brake pads depending
on the condition of the crack. Contact a GT-R
certified NISSAN dealer for replacement.
ENGINE COMPARTMENT
CAUTION
Never use a fuse of a higher or lower
amperage rating than that specified on
the fuse box cover. This could damage
the electrical system or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
1.
Be sure the ignition switch is pushed to the
OFF or LOCK position and the headlight
switch is turned to OFF.
2.
Open
the
engine
hood
and
remove
the
cover on the battery and the fuse/fusible link
holder.
3.
Remove the fuse/fusible link holder cover.
4.
Remove the fuse with the fuse puller that is
located in the engine compartment fuse box.
FUSES
5.
If the fuse is open
*
A
, replace it with a new
fuses
*
B
. Spare fuses are stored in the
passenger compartment fuse box.
6.
If a new fuse also opens, have the electrical
system checked and repaired by a GT-R
certified NISSAN dealer.
Fusible links
If any electrical equipment does not operate and
fuses are in good condition, check the fusible
links. If any of these fusible links are melted,
replace only with genuine NISSAN parts.
PASSENGER COMPARTMENT
CAUTION
Never use a fuse of a higher or lower
amperage rating than that specified on
the fuse box cover. This could damage
the electrical system or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
1.
Be sure the ignition switch is pushed to the
OFF or LOCK position and the headlight
switch is turned to OFF.
2.
Open the fuse box lid.
Maintenance and do-it-yourself
8-25
8-26
Maintenance and do-it-yourself
3.
Remove the fuse with the fuse puller
*
A
.
4.
If the fuse is open, replace it with a new fuse.
5.
If a new fuse also opens, have the electrical
system checked and repaired by a GT-R
certified NISSAN dealer.
Extended storage fuse switch
To reduce battery drain, the extended storage
fuse switch comes from the factory switched off.
Prior to delivery of your vehicle, the switch is
pushed in (switched on) and should always
remain on.
If any electrical equipment does not operate,
remove the extended storage fuse switch and
check for an open fuse.
NOTE:
If the extended storage fuse switch mal-
functions, or if the fuse is open, it is not
necessary to replace the switch. In this
case, remove the extended storage fuse
switch and replace it with a new fuse of the
same rating.
How to remove the extended storage
switch:
1.
To remove the extended storage fuse switch,
be sure the ignition switch is in the OFF or
LOCK position.
2.
Be sure the headlight switch is in the OFF
position.
3.
Remove the fuse box cover.
4.
Pinch the locking tabs
*
1
found on each
side of the extended storage fuse switch.
5.
Pull
the
extended
storage
fuse
switch
straight out from the fuse box
*
2
.