Nissan JUKE - 2011 Fuse Box Diagram

Nissan JUKE - 2011 Fuse Box Diagram

SSI0769
1.
Outside mirror remote control switch (P.3-26)
2.
Headlight, fog light and turn signal switch
— Headlight (P.2-34)
— Turn signal light (P.2-37)
— Fog light* (P.2-37)
3.
Steering wheel
— Electric power steering system (P.5-34)
— Horn (P.2-38)
— Driver’s supplemental air bag (P.1-35)
4.
Wiper and washer switch (P.2-31)
5.
Selector lever or shift lever
— Continuously Variable Transmission (CVT)
(P.5-16)
— Manual Transmission (MT) (P.5-20)
6.
Fuse box cover (P.8-20)
7.
Vehicle Dynamic Control (VDC) OFF switch
(P.5-37)
8.
All-Wheel Drive (AWD) switch* (P.5-29)
9.
Tilting steering wheel lever (P.3-25)
10. Steering-wheel-mounted controls (left side)
— Audio control (P.4-49)
— Bluetooth
®
Hands-Free Phone System control
(P.4-52)
11. Ignition
switch
(models
without
Intelligent
Key
system) (P.5-9)
12. Steering-wheel-mounted controls (right side)
— Cruise control switches (P.5-26)
13. Heated seat switch* (P.2-39)
*:
if so equipped
COCKPIT
0-6
Illustrated table of contents
SDI2639
MR16DDT ENGINE
1.
Engine oil filler cap (P.8-8)
2.
Radiator filler cap (P.8-7)
— Vehicle overheat (P.6-9)
3.
Brake and clutch* fluid reservoir (P.8-11)
4.
Air cleaner (P.8-16)
5.
Window washer fluid reservoir (P.8-12)
6.
Engine drive belt location (P.8-14)
7.
Engine oil dipstick (P.8-8)
8.
Engine coolant reservoir (P.8-7)
9.
Fuse/fusible link holder (P.8-19)
10. Battery (P.8-12)
— Jump starting (P.6-7)
*:
for Manual Transmission (MT) models
ENGINE COMPARTMENT
Illustrated table of contents
0-9
SSI0769
1.
Outside mirror remote control switch
2.
Headlight, fog light and turn signal switch
— Headlight
— Turn signal light
— Fog light*
3.
Steering wheel
— Electric power steering system
— Horn
— Driver’s supplemental air bag
4.
Wiper and washer switch
5.
Selector lever or shift lever
— Continuously Variable Transmission (CVT)
— Manual Transmission (MT)
6.
Fuse box cover
7.
Vehicle Dynamic Control (VDC) OFF switch
8.
All-Wheel Drive (AWD) switch*
9.
Tilting steering wheel lever
10. Steering-wheel-mounted controls (left side)
— Audio control
— Bluetooth
®
Hands-Free Phone System control
11. Ignition
switch
(models
without
Intelligent
Key
system)
12. Steering-wheel-mounted controls (right side)
— Cruise control switches
13. Heated seat switch*
*:
if so equipped
COCKPIT
2-2
Instruments and controls
SIC4525
The power outlet is located in the instrument
panel.
CAUTION
.
The
outlet
and
plug
may
be
hot
during or immediately after use.
.
Do not use with accessories that
exceed a 12 volt, 120W (10A) power
draw. Do not use double adapters or
more than one electrical accessory.
.
Use power outlet with the engine
running
to
avoid
discharging
the
vehicle battery.
.
Avoid using power outlet when the
air conditioner, headlights or rear
window defroster is on.
.
This power outlet is not designed
for use with a cigarette lighter unit.
.
Push the plug in as far as it will go.
If good contact is not made, the plug
may overheat or the internal tem-
perature fuse may open.
.
Before inserting or disconnecting a
plug, be sure the electrical acces-
sory being used is turned OFF.
.
When not in use, be sure to close
the
cap.
Do
not
allow
water
to
contact the outlet.
CUP HOLDERS
CAUTION
.
Avoid abrupt starting and braking
when the cup holder is being used
to prevent spilling the drink. If the
liquid is hot, it can scald you or your
passenger.
.
Use only soft cups in the cup holder.
Hard objects can injure you in an
accident.
POWER OUTLET
STORAGE
Instruments and controls
2-41
5.
Other
buttons
can
be
set
in
the
same
manner.
If the battery cable is disconnected, or if the fuse
opens, the radio memory will be erased. In that
case, reset the desired stations.
Radio Data System (RDS):
RDS stands for Radio Data System, and is a
data information service transmitted by some
radio stations on the FM band (not AM band)
encoded
within
a
regular
radio
broadcast.
Currently, most RDS stations are in large cities,
but many stations are now considering broad-
casting RDS data.
RDS can display:
.
Station call sign, such as “WHFR 98.3”.
.
Station name, such as “The Groove”.
.
Music or programming type such as “Clas-
sical”, “Country” or “Rock”.
.
Traffic reports about delays or construction.
If the station broadcasts RDS information, the
RDS icon is displayed.
RADIO DISPLAY change:
When the RADIO DISPLAY change button is
pushed during the FM or SAT radio mode, the
radio display will change in the following order.
.
For FM radio:
Frequency
PS (Programme Service)/PTY
(Programme type)
.
For XM Satellite Radio:
Category Name
?
Channel Name
?
Artist/
Feature
?
Song/Program
In the FM radio mode, pushing the DISP button
will switch the frequency display to the PTY
display (if available), and if the DISP button is
not
pushed
again
within
5
seconds,
it
will
automatically switch to the PS display. If PTY
is not available, pushing the DISP button will
only switch between the frequency display and
the PS display.
SAA3490
Compact Disc (CD) player operation
Place the ignition switch in the ACC or ON
position, and insert the CD into the slot with the
label side facing up. The CD will be guided
automatically into the slot and start playing.
After loading the disc, the number of tracks on
the disc will appear on the display.
If the radio is already operating, it will auto-
matically turn off and the CD will play.
If the system has been turned off while the CD
was playing, pushing the PWR button will start
the CD.
Do not use 3.1 in (8 cm) discs.
4-36
Heater, air conditioner, audio and phone systems
TUNE (Tuning):
.
For AM and FM radio
Turn the TUNE knob for manual tuning.
.
For XM Satellite Radio
Turn the TUNE knob to seek channels from
all of the categories when any category is
not selected.
SEEK tuning:
.
For AM and FM radio
Push the SEEK/CATEGORY button
or
to tune from low to high or high to low
frequencies and to stop at the next broad-
casting station.
.
For XM Satellite Radio
Push the SEEK/CATEGORY button
or
to tune to the first channel of the next
or previous category.
Tuning with the touchscreen (AM and FM
radio):
When in AM or FM mode, the radio can be
tuned using the touchscreen. To bring up the
visual tuner, touch the “Tune” key on the lower
right corner of the screen. A screen appears
with a bar running from low frequencies on the
left to high frequencies on the right. Touch the
screen at the location of the frequency you wish
to tune and the station will change to that
frequency. To return to the regular radio display
screen, touch the “OK” key.
to
Station memory operations:
12 stations/channels can be set for the FM band
(6 each for FM1 and FM2), 18 for XM radio (6
each for XM1, XM2 and XM3) and 6 stations
can be set for the AM band.
1.
Choose the radio band using the radio band
select button.
2.
Tune to the desired station/channel using
the SEEK/CATEGORY button or the TUNE
knob.
3.
Push and hold the desired station preset
button
to
until the beep sound is
heard.
4.
The station indicator will then come on and
the sound will resume. Memorizing is now
complete.
5.
Other
buttons
can
be
set
in
the
same
manner.
If the battery cable is disconnected, or if the fuse
opens, the radio memory will be erased. In that
case, reset the desired stations/channels.
Touchscreen (XM Satellite Radio):
When the XM Satellite Radio is being played,
the
following
items
are
available
with
the
touchscreen operation.
.
Channels
Displays a list of channels. Touch a preferred
channel displayed on the list to change to
that channel.
.
Categories
Displays
a
list
of
categories.
Touch
a
preferred channel displayed on the list to
display options within that category.
Compact Disc (CD) player operation
Place the ignition switch in the ACC or ON
position and insert the Compact Disc (CD) into
the slot with the label side facing up. The CD will
be guided automatically into the slot and start
playing.
If the radio is already operating, it will auto-
matically turn off and the CD will play.
If the system has been turned off while the CD
was playing, pushing the ON·OFF button will
start the CD.
Do not use 3.1 in (8 cm) discs.
4-42
Heater, air conditioner, audio and phone systems
difficulties or excessive emissions, and could
affect
your
warranty
coverage.
If
in
doubt
about any servicing, we recommend that
it be done by a NISSAN dealer.
SDI2639
MR16DDT ENGINE
1.
Engine oil filler cap
2.
Radiator filler cap
3.
Brake and clutch* fluid reservoir
4.
Air cleaner
5.
Window washer fluid reservoir
6.
Engine drive belt location
7.
Engine oil dipstick
8.
Engine coolant reservoir
9.
Fuse/fusible link holder
10. Battery
*:
for Manual Transmission (MT) models
ENGINE COMPARTMENT CHECK
LOCATIONS
8-6
Maintenance and do-it-yourself
SDI2654
ENGINE COMPARTMENT
CAUTION
Never use a fuse of a higher or lower
amperage rating than that specified on
the fuse box cover. This could damage
the electrical system or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
1.
Be sure the ignition switch and the headlight
switch are turned off.
2.
Open the engine hood.
3.
Remove the fuse/fusible link holder cover by
pushing the tab
*
1
and lifting the cover
from the right side
*
2
, then the left side
*
3
.
4.
Locate the fuse that needs to be replaced.
5.
Remove
the
fuse
using
the
fuse
puller
located in the passenger compartment fuse
box.
SDI1754
6.
If the fuse is open
*
A
, replace it with a new
fuse
*
B
.
7.
If a new fuse also opens, have the electrical
system checked and repaired by a NISSAN
dealer.
The holder
*
4
also contains the fuses. For
checking and/or replacing, see a NISSAN
dealer.
FUSES
Maintenance and do-it-yourself
8-19
SDI2642
Fusible links
If any electrical equipment does not operate and
the
fuses are
in good
condition,
check
the
fusible links in the holders
*
1
and
*
2
. If any of
these fusible links are melted, replace only with
genuine NISSAN parts.
For checking and replacing the fusible links in
the holders
*
2
, see a NISSAN dealer.
SDI2643
PASSENGER COMPARTMENT
CAUTION
Never use a fuse of a higher or lower
amperage rating than that specified on
the fuse box cover. This could damage
the electrical system or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
1.
Be sure the ignition switch and the headlight
switch are turned off.
2.
Remove the fuse box cover
*
1
.
3.
Remove the fuse with the fuse puller
*
2
.
8-20
Maintenance and do-it-yourself
SDI1754
4.
If the fuse is open
*
A
, replace it with a new
fuse
*
B
.
5.
If a new fuse also opens, have the electrical
system checked and repaired by a NISSAN
dealer.
CAUTION
Be
careful
not
to
allow
children
to
swallow the battery and removed parts.
SDI2134
KEYFOB
Replace the battery in the keyfob as follows:
1.
Remove the screw.
2.
Insert a small screwdriver into the slit of the
corner and twist it to separate the upper part
KEY BATTERY REPLACEMENT
Maintenance and do-it-yourself
8-21