Nissan GT R - 2012 Fuse Box Diagram

Nissan GT R - 2012 Fuse Box Diagram

0-8
Illustrated table of contents
1.
Outside mirror control switch (P.3-28)
2.
Center dial*
3.
Audio system*
4.
Heater and air conditioner*
5.
Multi function display*
6.
Hazard warning flasher switch (P.2-52)
7.
Glove box (P.2-57)
8.
Fuse box cover (P.8-23)
9.
Power outlet (P.2-54)
10. Rear window defroster switch (P.2-48)
11. Front passenger air bag status light (P.1-38)
12. Compact Disc slot*
13. Trunk release power cancel switch (P.3-21)
*:
Refer
to
the
separate
Multi
Function
Display
Owner’s Manual.
INSTRUMENT PANEL
0-10
Illustrated table of contents
1.
Fuse/fusible link holder (P.8-23)
2.
Battery (P.8-16)
3.
Engine oil filler cap (P.8-12)
4.
Strut support bar (P.GTR-8)
5.
Engine oil dipstick (P.8-12)
6.
Brake fluid reservoir (P.8-14)
7.
Air cleaner (P.8-20)
8.
Power steering fluid reservoir (P.8-14)
9.
Radiator filler cap (P.8-10)
10. Coolant reservoir cap (pressure type) (P.8-10)
11. Coolant reservoir (P.8-10)
12. Window washer fluid reservoir (P.8-15)
ITEMS
GT-R SPECIFIED FLUIDS
Engine oil
Mobil 1 (0W-40)*1
Transmission oil
Genuine NISSAN Transmission
Oil R35 Special
Differential oil
(front and rear)
Castrol SAF-XJ 75W-140
Brake fluid
Genuine NISSAN Brake Fluid
R35 Special II*2
*1: Mobil 1 (0W-40) (100% synthetic) is the factory
fill oil. The VR38 engine with its plasma-sprayed
bores
was
developed
using
this
oil.
NISSAN
cannot
ensure
proper
engine
operation
and
durability if other 0W-40 synthetic oil is used. If
Mobil 1 (0W-40) is not available, Mobil 1 (10W-
40) (100% synthetic) may be used; however,
some performance loss may be noticed.
*2: Genuine NISSAN Brake Fluid R35 Special II is the
factory
fill
brake
fluid.
The
Vehicle
Dynamic
Control (VDC) unit and other related parts were
specially designed for this brake fluid and NISSAN
cannot ensure proper operation of the vehicle if
other brake fluid is used.
ENGINE COMPARTMENT
2-4
Instruments and controls
1.
Outside mirror control switch (P.3-28)
2.
Center dial*
3.
Audio system*
4.
Heater and air conditioner*
5.
Multi function display*
6.
Hazard warning flasher switch (P.2-52)
7.
Glove box (P.2-57)
8.
Fuse box cover (P.8-23)
9.
Power outlet (P.2-54)
10. Rear window defroster switch (P.2-48)
11. Front passenger air bag status light (P.1-38)
12. Compact Disc slot*
13. Trunk release power cancel switch (P.3-21)
*:
Refer
to
the
separate
Multi
Function
Display
Owner’s Manual.
INSTRUMENT PANEL
2-54
Instruments and controls
CAUTION
.
The
outlet
and
plug
may
be
hot
during or immediately after use.
.
Do not use with accessories that
exceed a 12 volt, 120W (10A) power
draw. Do not use double adapters or
more than one electrical accessory.
.
This power outlet is not designed
for use with a cigarette lighter unit.
.
Before inserting or disconnecting a
plug, be sure the electrical acces-
sory being used is turned OFF.
.
When not in use, be sure to close
the
cap.
Do
not
allow
water
to
contact the outlet.
NOTICE
.
Use power outlet with the engine
running
to
avoid
discharging
the
vehicle battery.
.
Avoid using power outlet when the
air conditioner, headlights or rear
window defroster is on.
.
Push the plug in as far as it will go.
If good contact is not made, the plug
may overheat or the internal tem-
perature fuse may open.
Next to the steering wheel
Pull out the cap to use the outlet.
Replace the cap after use.
POWER OUTLETS
8-8
Maintenance and do-it-yourself
1.
Fuse/fusible link holder
2.
Battery
3.
Engine oil filler cap
4.
Strut support bar
5.
Engine oil dipstick
6.
Brake fluid reservoir
7.
Air cleaner
8.
Power steering fluid reservoir
9.
Radiator filler cap
10. Coolant reservoir cap (pressure type)
11. Coolant reservoir
12. Window washer fluid reservoir
NOTICE
The coolant reservoir is equipped with a
pressure type cap, and the radiator is
equipped with a non-pressure type cap.
Do not switch the radiator filler cap and
the coolant reservoir cap. Doing so will
cause
substandard
cooling
perfor-
mance and overheating.
ENGINE COMPARTMENT CHECK
LOCATIONS
dry road, especially after washing the vehicle or
driving in rain. Contact a GT-R certified NISSAN
dealer if the noise and vibration continue.
Frequent hard braking may cause scorching of
the brake pads. This will require the brake pads
to be replaced, even if the wear limit has not
been reached. Have the brake pads and disc
rotors inspected at the regular vehicle inspec-
tions.
For
more
details,
contact
a
GT-R
certified
NISSAN dealer.
REPLACING THE BRAKE PADS
NISSAN generally recommends to replace all
four sets of brake pads and disc rotors at the
same time to maintain maximum brake perfor-
mance.
However, replacing only the brake pads may be
allowed in some cases (four wheels or only front
wheels depending on the conditions). A GT-R
certified technician must inspect the vehicle and
determine that only the brake pads need to be
replaced. In this case, replacing all brake pads
and disc rotors as a set is not necessary.
Note that the replacement of brake pads and the
disc rotors as a set on all four wheels should be
performed when a GT-R certified technician
determines that this is the correct repair.
If the inside of the disc rotors are cold during the
winter and the surface becomes hot due to a
heavy force being applied repeatedly to the
brakes, cracks may occur near the coolant hole
on the surface of the disc rotor. Cracks may also
occur due to a heavy force being repeatedly
applied to the brakes during high performance
driving. In these cases it may be necessary to
replace the disc rotors or brake pads depending
on the condition of the crack. Contact a GT-R
certified NISSAN dealer for replacement.
ENGINE COMPARTMENT
CAUTION
Never use a fuse of a higher or lower
amperage rating than that specified on
the fuse box cover. This could damage
the electrical system or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
1.
Be sure the ignition switch is pushed to the
OFF or LOCK position and the headlight
switch is turned to OFF.
Maintenance and do-it-yourself
8-23
FUSES
8-24
Maintenance and do-it-yourself
2.
Open
the
engine
hood
and
remove
the
cover on the battery and the fuse/fusible link
holder.
3.
Remove the fuse/fusible link holder cover.
4.
Remove the fuse with the fuse puller that is
located in the engine compartment fuse box.
5.
If the fuse is open
*
A
, replace it with a new
fuses
*
B
. Spare fuses are stored in the
passenger compartment fuse box.
6.
If a new fuse also opens, have the electrical
system checked and repaired by a GT-R
certified NISSAN dealer.
Fusible links
If any electrical equipment does not operate and
fuses are in good condition, check the fusible
links. If any of these fusible links are melted,
replace only with genuine NISSAN parts.
PASSENGER COMPARTMENT
CAUTION
Never use a fuse of a higher or lower
amperage rating than that specified on
the fuse box cover. This could damage
the electrical system or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
1.
Be sure the ignition switch is pushed to the
OFF or LOCK position and the headlight
switch is turned to OFF.
2.
Open the fuse box lid.
3.
Remove the fuse with the fuse puller
*
A
.
4.
If the fuse is open, replace it with a new fuse.
5.
If a new fuse also opens, have the electrical
system checked and repaired by a GT-R
certified NISSAN dealer.
Extended storage switch
To reduce battery drain, the extended storage
switch comes from the factory switched off.
Prior to delivery of your vehicle, the switch is
pushed in (switched on) and should always
remain on.
If any electrical equipment does not operate,
remove the extended storage switch and check
for an open fuse.
NOTE:
If the extended storage switch malfunc-
tions,
or
if
the
fuse
is
open,
it
is
not
necessary to replace the switch. In this
case, remove the extended storage switch
and replace it with a new fuse of the same
rating.
Maintenance and do-it-yourself
8-25
8-26
Maintenance and do-it-yourself
How to remove the extended storage
switch:
1.
To remove the extended storage switch, be
sure the ignition switch is in the OFF or
LOCK position.
2.
Be sure the headlight switch is in the OFF
position.
3.
Remove the fuse box cover.
4.
Pinch the locking tabs
*
1
found on each
side of the storage switch.
5.
Pull the storage switch straight out from the
fuse box
*
2
.
WARNING
Be
careful
that
batteries
and
other
removed
components
are
not
swal-
lowed by children.
NOTICE
There is the possibility that the key may
be damaged when the battery is re-
placed.
It
is
recommended
that
you
have the battery replaced by a GT-R
certified NISSAN dealer.
Recommended battery: Lithium battery CR2032
or an equivalent.
1.
Disengage the lock on the reverse side of
the
Intelligent
Key
while
pulling
out
the
mechanical key.
2.
Insert
a
flat-bladed
screwdriver
*
1
wrapped with a cloth into the slit
*
2
and
twist it to separate the case into the upper
and lower parts.
NOTICE
Because there is the risk of scratching
the key, wrap a cloth or similar item
around the screwdriver when separat-
ing
the
parts.
If
the
screwdriver
is
inserted too far into the key, it may
damage the internal circuit board.
INTELLIGENT KEY BATTERY
REPLACEMENT
.
For XM Satellite Radio
Turn the radio TUNE knob to seek channels
from all of the categories when any category
is not selected.
SEEK tuning/CATEGORY (CAT):
.
For AM and FM radio
Push
<
>
or
<
>
to tune from low to
high or high to low frequencies and to stop
at the next broadcasting station.
.
For XM Satellite Radio
Push
<
>
or
<
>
to tune to the first
channel of the next or previous category.
During satellite radio reception, the following
notices will be displayed under certain condi-
tions.
.
NO SIGNAL (No signal is received while the
SAT tuner is connected.)
.
OFF AIR (Broadcasting signed off)
.
CHECK
ANTENNA
(Antenna
connection
error)
.
LOADING
(When
the
initial
setting
is
performed)
.
UPDATING (When the satellite radio sub-
scription is not active)
SCAN tuning:
Push
<SCAN>
to
tune
from
low
to
high
frequencies
and
stop
at
each
broadcasting
station/channel
for
5
seconds.
Pushing
the
button again during this 5 seconds period will
stop SCAN tuning and the radio will remain
tuned to that station/channel.
If
<SCAN>
is not pushed within 5 seconds,
SCAN tuning moves to the next station/channel.
*
1
to
*
6
Station memory operations:
12 stations/channels can be set for the FM band
(6 each for FM1 and FM2), 18 for XM radio (6
each for XM1, XM2 and XM3) and 6 stations
can be set for the AM band.
1.
Choose the radio band using the radio band
select button.
2.
Tune to the desired station/channel using
<
>
,
<
>
,
<SCAN>
or
the
radio
TUNE knob.
3.
Push and hold the desired station preset
button
*
1
to
*
6
until the radio mutes.
4.
The station indicator will then come on and
the sound will resume. Memorizing is now
complete.
5.
Other
buttons
can
be
set
in
the
same
manner.
If the battery cable is disconnected, or if the fuse
opens, the radio memory will be erased. In that
case, reset the desired stations/channels.
List (AM and FM radio):
When [List] on the display is selected while the
FM or AM radio is being played, the preset
station list will be displayed.
If 1 of the 6 preset stations listed is touched and
held, the current station will be stored as the
new preset.
Menu (XM Satellite Radio):
When [Menu] on the display is selected while
the XM Satellite Radio is being played, the menu
list will be displayed.
The following items are available.
.
Preset List
Displays the preset channel list. If 1 of the 6
preset stations listed is touched and held,
the current station will be stored as the new
preset.
.
Customize Channel List
Selects specific channels to skip while using
the
TUNE,
SEEK/CATEGORY or
Menu-
Categories feature.
.
Favorite Artists & Songs
Stores the current artist or song that is being
played. Touch [Alert] to be reminded when
the stored artist or song is playing on a
station while listening to XM.
Audio system
3-13