Kia Amanti - 2008 Fuse Box Diagram

Kia Amanti - 2008 Fuse Box Diagram

3 95
Knowing your vehicle
Clock
Analog
Whenever the battery terminals, A/V
CLOCK fuse, or Power Connect are dis-
connected, you must reset the time.
When the ignition switch is in the ACC or
ON position, the clock buttons operate as
follows:
: time increases one minute each time
the button is pressed. It increases
continuously if pressed longer than 3
seconds.
Digital (if equipped)
Whenever the battery terminals, A/V
CLOCK fuse, or Power Connect are dis-
connected, you must reset the time.
For details, see end of chapter 3.
OGH026078
OGH026077N
6 5
In case of an emergency
Do not allow the jumper cables to con-
tact anything except the correct bat-
tery terminals or the correct ground.
Do not lean over the battery when
making connections.
5. Start the engine of the vehicle with the
booster battery and let it run at 2,000
rpm, then start the engine of the vehi-
cle with the discharged battery.
If the cause of your battery discharging is
not apparent, you should have your vehi-
cle checked by an Authorized Kia Dealer.
Refer to illustration on page 6-4.
Pu
s
h-
s
tarting
Vehicles
equipped
with
automatic
transaxle cannot be push-started.
Follow the directions in this section for
jump-starting.
Fu
s
e
s
A vehicle’s electrical system is protected
from electrical overload damage by
fuses.
WARNING
Never tow a vehicle to
s
tart it
becau
s
e the
s
udden
s
urge forward
when the engine
s
tart
s
could cau
s
e
a colli
s
ion with the tow vehicle.
ELECTRICAL CIRCUIT
PROTECTION
1VQA4037
Normal
Normal
Blown
Blown
Normal
Blown
In case of an emergency
6
6
WARNING
- Fu
s
e replace-
ment
• Never replace a fu
s
e with any-
thing but another fu
s
e of the
s
ame rating.
• A higher capacity fu
s
e could
cau
s
e damage and po
ss
ibly a
fire.
Never in
s
tall a wire in
s
tead of the
proper fu
s
e - even a
s
a temporary
repair. It may cau
s
e exten
s
ive
wiring damage and po
ss
ibly a
fire.
Do not u
s
e a
s
crewdriver or any
other metal object to remove
fu
s
e
s
becau
s
e it may cau
s
e a
s
hort circuit and damage the
s
y
s
-
tem.
This vehicle has two fuse panels, one
located in the driver's side knee bolster,
the other in the engine compartment
near the battery.
If any of your vehicle’s lights, acces-
sories, or controls do not work, check the
appropriate circuit fuse. If a fuse has
blown, the element inside the fuse will be
melted.
If the electrical system does not work,
first check the driver’s side fuse panel.
Always replace a blown fuse with one of
the same rating.
If the replacement fuse blows, this indi-
cates an electrical problem. Avoid using
the system involved and immediately
consult an Authorized Kia Dealer.
Fu
s
e replacement
1. Turn the ignition switch and all other
switches off.
2. Pull the suspected fuse straight out.
Use the removal tool provided on the
main fuse box in the engine compart-
ment.
3. Check the removed fuse; replace it if it
is blown.
Spare fuses are provided in the fuse
panel.
4. Push in a new fuse of the same rating,
and make sure it fits tightly in the clips.
If it fits loosely, consult an Authorized Kia
Dealer.
1GHA402
Driver - side knee bolster
6 7
In case of an emergency
If you do not have a spare, use a fuse of
the same rating from a circuit you may
not need for operating the vehicle, such
as the radio or room lamp fuse.
If the headlights or other electrical com-
ponents do not work and the fuses are
OK, check the fuse block in the engine
compartment. If a fuse is blown, it must
be replaced.
To check the fuse or relay in the engine
compartment, remove the engine com-
partment shroud.
1. Turn the ignition switch and all other
switches off.
2. Remove the fuse box cover by remov-
ing the bolt on the cover and unhook-
ing the tab on one end and tilting the
cover back toward the other end.
3. Check the fuses. If one is blown,
replace it with a new one of the same
rating.
NOTICE
After checking the fuse box in the engine
compartment, securely install the fuse
box cover.
If not, electrical failures may
occur from water leaking in.
1GHA403A
1GHA404
OGH056001
Engine compartment
Junction Box
Main Fuse
In case of an emergency
8
6
Main fu
s
e
If the BATT (60A) or ALT (150A) fuse are
blown, it must be removed as follows:
1. Disconnect the negative battery cable.
2. Remove the nuts shown in the picture
above.
3. Replace the fuse with a new one of the
same rating.
4. Reinstall in the reverse order of
removal.
OGH046004
Engine compartment
91950-3F100
Fu
s
e/Relay panel de
s
cription
Inside the fuse/relay box covers, you can find the fuse/relay label describing fuse/relay
name and capacity.
6 9
In case of an emergency
De
s
cription
Fu
s
e rating
Protected component
1
FUEL PUMP
20A
Fuel pump
2
H/LP (LO-LH)
15A
Headlight (low-left)
3
ABS
10A
Anti-lock brake system
4
IGN COIL
15A
Ignition coil
5
A/CON COMP
10A
Air-conditioner compressor
6
ATM
20A
Automatic transaxle control relay
7
MAIN
20A
Engine control unit relay
8
O2 SNSR
15A
Oxygen sensor
9
EGR
15A
Power train control system sensors
10
HORN
15A
Horn
11
TAIL
20A
Tail light
12
SUNROOF
20A
Sun roof
13
P/SEAT (RH)
20A
Power seat (right)
14
FOG LP (FR)
15A
Fog light (front)
15
H/LP (HI)
15A
Headlight (high)
16
SPARE
30A
spare fuse
17
SPARE
20A
spare fuse
18
SPARE
15A
spare fuse
19
SPARE
10A
spare fuse
20
P/SEAT (LH)
30A
Power seat (left)
21
AMP
20A
Radio amplifier
22
DRL*
15A
Daytime running light
Engine compartment
De
s
cription
Fu
s
e rating
Protected component
23
H/LP (LO-RH)
15A
Headlight (low beam-right)
24
I/P B+
30A
All electrical system
25
ECU
10A
Engine control unit
26
INJECTOR
10A
Injector
27
ECS *
15A
Electronic control suspension
BLOWER
40A
Blower motor
IGN 1
30A
Ignition switch
ABS 2
30A
Anti-lock brake system
ABS 1
30A
Anti-lock brake system
IGN 2
30A
Ignition switch
S/WARM
30A
Seat warmer
H/LP (LO-LH)
-
Headlight relay (low beam-left)
FUEL PUMP
-
Fuel pump relay
HORN
-
Horn relay
START
-
Start motor relay
A/CON
-
Air conditioner relay
H/LP (HI)
-
Headlight relay (high beam)
FOG LP (FR)
-
Fog light relay (front)
TAIL LP
-
Taillight relay
WIPER
-
Wiper relay
BATT
60A
Alternator, Battery
ALT
150A
Alternator
COOLING
60A
Cooling fan
* : if equipped
6 11
In case of an emergency
Power connector
Your vehicle is equipped with a power connector to prevent bat-
tery discharge if your vehicle is parked without being operated
for prolonged periods. Use the following procedures before
parking the vehicle for prolonged period.
1. Turn off the engine.
2. Turn off the headlights and tail lights.
3. Open the driver-side knee bolster cover and pull up the
“POWER/CONN”.
NOTICE
If the power connector is pulled up from the fuse panel, the
warning chime, AV system, clock and intetrior lamps, etc.,
will not operate. Some items must be reset after replace-
ment.
Even though the power connector is pulled up, the battery
can still be discharged by operation of the headlights or
other electrical devices.
De
s
cription
Fu
s
e rating
Protected component
A/CON
10A
Air-conditioning system
P/WDW(LH)
20A
Power window (left)
TAIL LP(RH)
10A
Taillight (right)
BACK WARN’G
10A
Back warning system
DR LP
10A
Door courtesy lamp
MIRROR HTD
15A
Outside review mirror defroster
ENG SNSR
10A
Power train control system sensors
T/REDUCER
10A
Seat belt tension reducer
CLOCK
10A
Clock
WIPER(FR)
25A
Wiper (front)
EPS
10A
Electronic power steering
TAIL LP(LH)
10A
Tail light (left)
ROOM LP
10A
Room lamp
AV, CLOCK
15A
Audio, Clock
LAN UNIT
10A
Lan unit
TPMS
15A
-
H/LP WASHER
20A
Headlight washer
SHUNT CONN
-
Switch illumination
POWER/CONN
-
Power connector
1GHA403
Power
connector