Kia Rio - 2010 Fuse Box Diagram

Kia Rio - 2010 Fuse Box Diagram

3 15
Knowing your vehicle
Power windows (if equipped)
The ignition switch must be in the ON
position for power windows to operate.
Each door has a power window switch
that
controls
that
door’s
window.
However, the driver has a power window
lock switch which can block the operation
of passenger windows.
NOTICE
While driving with the rear windows
down or with the sunroof (if equipped)
in an open(or partially open position),
your vehicle may demonstrate a wind
buffeting or pulsation noise. This noise
is a normal occurrence and can be
reduced or eliminated by taking the fol-
lowing actions. If the noise occurs with
one or both of the rear windows down,
partially lower
both front windows
approximately one inch. If you experi-
ence the noise with the snroof open,
slightly reduce the size of the sunroof
opening.
NOTICE
To prevent the power window system
from the possibility of damage, do not
open or close two windows at the same
time. This will also ensure the longevi-
ty of the fuse.
(Continued)
(Continued)
Never try to operate the main switch
on the driver's door and the individ-
ual door window switch in opposing
directions at the same time. If this is
done, the window will stop and cannot
be opened or closed.
Window opening and closing
The driver’s door has a master power
window switch that controls all the win-
dows in the vehicle. To open or close a
window, press down (5) or pull up (5) the
front portion of the corresponding switch.
Automatic power window down
(driver’s window, if equipped)
Depressing the power window switch
momentarily to the second detent posi-
tion (6) completely lowers the driver’s
window even when the switch is
released. To stop the window at the
desired position while the window is in
operation, pull up the switch momentarily
to the opposite direction of the window
movement.
1JBH2013
1JBA3011
Knowing your vehicle
78
3
Digital clock (if equipped)
Whenever the battery terminals or mem-
ory fuse are disconnected, you must
reset the time.
When the ignition switch is in the ACC or
ON position, the clock buttons operates
as follows:
• HOUR:
Pressing the “H” button with your fin-
ger, a pencil or similar object will
advance the time displayed by one
hour.
• MINUTE:
Pressing the “M” button with your fin-
ger, a pencil or similar object will
advance the time displayed by one
minute.
RESET:
To clear away minutes, press the “R”
button with your finger, a pencil or sim-
ilar object. Then the clock will be set
precisely on the hour.
For example, if the “R” button is
pressed while the time is between 9:01
and 9:29, the display will be reset to
9:00.
9:01 ~ 9:29
9:00
9:30 ~ 9:59
10:00
1JBN3103A
In case of an emergency
6
6
ELECTRICAL CIRCUIT PROTECTION
Fuses
A vehicle’s electrical system is protected
from electrical overload damage by
fuses.
This vehicle has two fuse panels, one
located in the driver's side panel
bolster,
the other in the engine compartment
near the battery.
If any of your vehicle’s lights, acces-
sories, or controls do not work, check the
appropriate circuit fuse. If a fuse has
blown, the element inside the fuse will be
melted.
If the electrical system does not work,
first check the driver’s side fuse panel.
Always replace a blown fuse with one of
the same rating.
If the replacement fuse blows, this indi-
cates an electrical problem. Avoid using
the system involved and immediately
consult an authorized Kia dealer.
Two kinds of fuses are used: standard for
lower amperage rating and main for high-
er amperage ratings.
Fuse replacement
NOTICE
Do not use a screwdriver or any other
metal object to remove fuses because it
may cause a short circuit and damage
the system.
WARNING
- Fuse replace-
ment
• Never replace a fuse with any-
thing but another fuse of the
same rating.
• A higher capacity fuse could
cause damage through overheat-
ing and possibly a fire.
Never install a wire instead of the
proper fuse - even as a temporary
repair. It may cause extensive
wiring damage and possibly a
fire.
1LDA4002
Standard
Main fuse
Normal
Normal
Blown
Blown
6 7
In case of an emergency
Driver-side panel bolster
1. Turn the ignition switch and all other
switches off.
2. Open the cover.
4. Pull the suspected fuse straight out.
Use the removal tool (1) provided in
the engine compartment fuse/relay
box.
5. Check the removed fuse; replace it if it
is blown.
Spare fuses are provided in the fuse
panel in engine compartment.
6. Push in a new fuse of the same rating,
and make sure it fits tightly in the clips.
If it fits loosely, consult an authorized Kia
dealer.
If you do not have a spare, use a fuse of
the same rating from a circuit you may
not need for operating the vehicle, such
as the audio fuse.
If the headlights or other electrical com-
ponents do not work and the fuses are
OK, check the fuse block in the engine
compartment. If a fuse is blown, it must
be replaced.
1JBA6004
1
6JBN6003
In case of an emergency
8
6
Engine compartment
1. Turn the ignition switch and all other
switches off.
2. Remove the fuse box cover by press-
ing the taps and pulling up.
3. Check the removed fuse; replace it if it
is blown.
4. Push in a new fuse of the same rating,
and make sure it fits tightly in the clips.
If it fits loosely, consult an authorized Kia
dealer.
NOTICE
After checking the fuse box in the engine
compartment, securely install the fuse
box cover.
If not, electrical failures may
occur from water leaking in.
Main fuse
If the MAIN fuse is blown, it must be
removed as follows:
1. Disconnect the negative battery cable.
2. Remove the screws shown in the pic-
ture above.
3. Replace the fuse with a new one of the
same rating.
4. Reinstall in the reverse order of
removal.
NOTICE
If the MAIN fuse is blown, consult an
authorized Kia dealer.
1JBA6005
1JBA6007
6 9
In case of an emergency
Engine compartment
Fuse/Relay panel description
Inside the fuse/relay box covers, you can find the fuse/relay
label describing fuse/relay name and capacity.
Description
Fuse rating
Protected component
BATT_1
50A
Alternator, Battery
ECU A
30A
Engine control unit
RAD
30A
Radiator fan
COND
30A
Condenser fan
ECU B
10A
Engine control unit
SPARE
-
Spare fuse
HORN
10A
Horn
IGN1
30A
Ignition
IGN2
40A
Ignition
BATT_2
30A
Alternator, Battery
MAIN
125A
Alternator
MDPS
80A
Power steering wheel
ABS1
40A
ABS
ABS2
40A
ABS
P/WDW
30A
Power window
BLW
40A
Blower
SPARE
-
Spare fuse
A/CON1
10A
Air conditioner
A/CON2
10A
Air conditioner
ECU D
10A
Engine control unit
SNSR
10A
Sensors
INJ
15A
Injector
ECU C
20A
Engine control unit
SPARE
-
Spare fuse
SPARE
-
Spare fuse
HORN
-
Horn relay
MAIN
-
Main relay
Engine compartment
OJB060008
In case of an emergency
10
6
Description
Fuse rating
Protected component
FUEL PUMP
-
Fuel pump relay
RAD FAN
-
Radiator fan relay
COND FAN2
-
Condenser fan relay
FUEL HTR
-
Fuel filter heater relay
BLOWER
-
Blower motor relay
START
-
Start motor relay
COND FAN1
-
Condenser fan relay
A/CON
-
Air conditioner relay
1JBH6009
Driver-side knee bolster
6 11
In case of an emergency
Driver-side knee bolster
Description
Fuse rating
Protected component
RR WIPER
15A
Rear wiper
H/LP(LH)
10A
Headlight (left)
FR WIPER
25A
Front wiper
BLOWER
10A
Blower
H/LP(RH)
10A
Headlight (right)
S/ROOF
20A
Sunroof
STOP LP
15A
Stop light
C/DR LOCK
20A
Central door lock
IGN COIL
15A
Ignition coil
ABS
10A
ABS
B/UP LP
10A
Back-up light
SPARE
-
Spare fuse
C/LIGHTER
25A
Cigar lighter
FOLD'G
10A
Outside rearview mirror folding
HTD SEAT
20A
Seat warmer
AMP
25A
Amplifier
FR FOG LP
10A
Front fog light
SPARE
-
Spare fuse
ECU
10A
Engine control unit
CLUSTER
10A
Cluster
P/WDW RH
25A
Power window (right)
AUDIO
10A
Audio
RR FOG LP
10A
Rear fog light
IGN
10A
Ignition
Description
Fuse rating
Protected component
HTD GLASS
30A
Rear window defroster
A/BAG
15A
Air bag
TCU
10A
Automatic transaxle control
SNSR
10A
Sensors
SPARE
-
Spare fuse
MULT B/UP
10A
Cluster, ETACS, A/C, Clock,
Room lamp
AUDIO
15A
Audio
P/WDW LH
25A
Power window (left)
HTD MIRR
10A
Outside rearview mirror heater
TAIL LP(LH)
10A
Taillight (left)
TAIL LP(RH)
10A
Taillight (right)
HAZARD
10A
Hazard warning light
T/SIG LP
10A
Turn signal light
A/BAG IND
10A
Air bag warning
START
10A
Start motor
In case of an emergency
12
6
Memory fuse
Your vehicle is equipped with a memory
fuse to prevent battery discharge if your
vehicle is parked without being operated
for prolonged periods. Use the following
procedures before parking the vehicle for
prolonged period.
1. Turn off the engine.
2. Turn off the headlights and tail lights.
3. Open the driver-side knee bolster
cover and pull up the “MULT B/UP 10A
/ AUDIO 15A”.
NOTICE
If the memory fuse is pulled up from
the fuse panel, the warning chime,
audio, clock and interior lamps, etc.,
will not operate. Some items must be
reset after replacement.
• Even though the memory fuse is
pulled up, the battery can still be dis-
charged by operation of the head-
lights or other electrical devices.
If emergency towing is necessary, we
recommend having it done by an author-
ized Kia dealer or a commercial tow-truck
service. Proper lifting and towing proce-
dures are necessary to prevent damage
to the vehicle.The use of wheel dollies or
flatbed equipment is recommended.
For trailer towing guidelines information,
refer to section 5 “Driving Tips”.
1JBA6010
TOWING
1JBA6501
7 9
Maintenance
ENGINE COMPARTMENT
OJB050002
1. Engine coolant reservoir
2. Engine oil filler cap
3. Brake fluid reservoir
4. Air cleaner
5. Fuse box
6. Negative battery terminal
7. Positive battery terminal
8. Auto transaxle oil dipstick
(if equipped)
9. Radiator cap
10. Engine oil dipstick
11. Power steering fluid reservoir
(if equipped)
12. Windshield washer fluid
reservoir
Type A
Maintenance
10
7
OJB050001C
1. Engine coolant reservoir
2. Engine oil filler cap
3. Brake fluid reservoir
4. Air cleaner
5. Fuse box
6. Negative battery terminal
7. Positive battery terminal
8. Auto transaxle oil dipstick (if equipped)
9. Radiator cap
10. Engine oil dipstick
11. Power steering fluid reservoir
(if equipped)
12. Windshield washer fluid reservoir
Type B