Ford Ranger - 1999 Fuse Box Diagram

Ford Ranger - 1999 Fuse Box Diagram

Do not attempt to service, repair, or modify the Air Bag
Supplemental Restraint System or its fuses. See your Ford or
Lincoln-Mercury dealer.
Children and air bags
For additional important safety information, read all information on
safety restraints in this guide.
Children must always be properly restrained. Failure to follow these
instructions may increase the risk of injury in a collision.
An infant in a rear-facing seat faces a high risk of serious or fatal
injuries from a deploying passenger air bag. Rear facing infant
seats should NEVER be placed in the front seats, unless the passenger
air bag is turned off. See
Passenger air bag ON/OFF switch.
How does the air bag supplemental restraint system work?
The air bag SRS is designed to
activate when the vehicle sustains
sufficient longitudinal deceleration.
The fact that the air bags did not
inflate in a collision does not mean
that something is wrong with the
system. Rather, it means the forces
were not of the type sufficient to
cause activation. Air bags are
designed to inflate in frontal and
near-frontal collisions, not rollover,
side-impact, or rear-impacts.
Seating and safety restraints
83
TRANSMISSION OPERATION
Brake-shift interlock
This vehicle is equipped with a brake-shift interlock feature that prevents
the gearshift from being moved from P (Park) unless the brake pedal is
depressed.
If you cannot move the gearshift out of P (Park) with the brake pedal
depressed:
1. Apply the parking brake, turn ignition key to LOCK, then remove the
key.
2. Insert the key and turn it to OFF. Apply the brake pedal and shift to N
(Neutral).
3. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift, it is
possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to
Fuses and relays
in the
Roadside
emergencies
chapter.
Do not drive your vehicle until you verify that the brakelamps
are working.
If your vehicle gets stuck in mud or snow it may be rocked out by
shifting from forward and reverse gears, stopping between shifts, in a
steady pattern. Press lightly on the accelerator in each gear.
Do not rock the vehicle for more than a few minutes. The
transmission and tires may be damaged or the engine may
overheat.
Always set the parking brake fully and make sure the gearshift is
latched in P (Park). Turn off the ignition whenever you leave
your vehicle.
If the parking brake is fully released, but the brake warning lamp
remains illuminated, the brakes may not be working properly.
See your dealer or a qualified service technician.
Driving
107
The fuel pump shut-off switch is
located in the passenger’s foot well,
behind the kick panel.
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause
severe wire damage and could start a fire.
15
15
Roadside emergencies
134
Standard fuse amperage rating and color
COLOR
Fuse
Rating
Mini Fuses
Standard
Fuses
Maxi Fuses
Fuse Link
Cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
40A
Orange
Orange
50A
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
Passenger compartment fuse panel
The fuse panel is located on the left
hand side of the instrument panel
facing the driver’s side door. Pull the
panel cover outward to access the
fuses.
Roadside emergencies
135
To remove a fuse use the fuse puller tool provided on the fuse panel
cover.
The fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Description
1
7.5A
Power Mirror Switch
2
7.5A
Blower Motor Relay, PAD Module, Air Bag
Diagnostic Monitor
3
7.5A
Left Stop/Turn Trailer Tow Connector
4
10A
Left Headlamp
5
10A
Data Link Connector (DLC)
6
Not Used
7
7.5A
Right Stop/Turn Trailer Tow Connector
8
10A
Right Headlamp, Fog Lamp Relay
9
7.5A
Brake Pedal Position Switch
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
29
30
35
36
31
32
33
34
27
28
Roadside emergencies
136
Fuse/Relay
Location
Fuse Amp
Rating
Description
10
7.5A
Speed Control Servo/Amplifier Assembly,
Generic Electronic Module (GEM), Shift Lock
Actuator, Blend Door Actuator, A/C-Heater
Assembly, Turn Signals
11
7.5A
Instrument Cluster, Daytime Running Lights
(DRL), RABS Resistor
12
Not Used
13
20A
Brake Pedal Position Switch
14
20A or 10A
20A: If equipped with Rear Anti-Lock Brake
System (RABS) Module.
10A: If equipped with 4 Wheel Anti-Lock
Brake System (4WABS) Module, 4WABS Main
Relay
15
7.5A
Air Bag Indicator Lamp, Alternator Indicator
Lamp
16
30A
Windshield Wiper Motor, Wiper Hi-Lo Relay,
Wiper Run/Park Relay
17
25A
Cigar Lighter
18
15A
Driver’s Unlock Relay, All-Unlock Relay,
All-Lock Relay
19
25A
PCM Power Diode
20
7.5A
RAP Module, Generic Electronic Module
(GEM), Radio
21
15A
Flasher (Hazard)
22
20A
Auxiliary Power Socket
23
Not Used
24
7.5A
Clutch Pedal Position (CPP) switch, Starter
Interrupt Relay, Anti-Theft
25
7.5A
Generic Electronic Module (GEM),
Instrument Cluster
26
10A
Battery Saver Relay, Electronic Shift Relay,
Interior Lamp Relay, Power Window Relay,
Electronic Shift Control Module, Dome/Map
Lamp, GEM
Roadside emergencies
137
Fuse/Relay
Location
Fuse Amp
Rating
Description
27
15A
Electric Shift, Backup Lamps, Daytime
Running Lamps (DRL), Transmission Control
Switch, Pulse Vacuum Hub Lock
28
7.5A
Generic Electronic Module (GEM), Radio
29
15A
Radio
30
10A
RABS Test Connector
31
Not Used
32
Not Used
33
15A
Headlamps, Daytime Running Lamps (DRL)
Module, Instrument Cluster
34
Not Used
35
15A
Park Lamp/Trailer Tow Relay
36
Not Used
Power distribution box
The power distribution box is
located in the engine compartment
near the battery. The power
distribution box contains
high-current fuses that protect your
vehicle’s main electrical systems
from overloads.
Always disconnect the battery before servicing high current
fuses.
Roadside emergencies
138
Always replace the cover to the Power Distribution Box before
reconnecting the battery or refilling fluid reservoirs.
The high-current fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Description
1
50A**
I/P Fuse Panel
2
40A**
Blower Motor Relay
3
50A**
4 Wheel Anti-Lock Brake System (4WABS)
Module
4
20A**
Power Windows
5
50A**
Ignition Switch, Starter Relay
1
10A*
A/C Relay
2
Not Used
3
20A*
Electronic Shift Relay and Electronic Shift
Control Module
4
15A*
Fog Lamp and Daytime Running Lamps
5
Not Used
5
4
3
2
1
12
11
10
9
8
7
6
5
4
3
2
1
14
15
13
9
6
10
8
7
5
4
1
2
3
2
1
1
175
MEGAFUSE
11
13
12
14
Roadside emergencies
139
Fuse/Relay
Location
Fuse Amp
Rating
Description
6
10A*
Powertrain Control Module
7
30A*
4 Wheel Anti-lock Brake System (4WABS)
Module
8
30A*
PCM Relay
9
20A*
Fuel Pump Relay and RAP Module
10
15A*
Horn Relay
11
15A*
Parklamps Relay and Main Light Switch
12
30A*
Main Light Switch and Multifunction Switch
13
15A*
Heated Oxygen Sensor, EGR Vacuum
Regulator, EVR Solenoid, Camshaft Position
Sensor (CMP), Canister Vent Solenoid
14
30A*
Generator Voltage Regulator
15
Not Used
1
Wiper Park Relay
2
A/C Relay
3
Wiper Hi/Lo Relay
4
PCM Power Relay
5
Fuel Pump Relay
6
Starter Relay
7
Horn Relay
8
Fog Lamp Control Relay
9
Blower Motor Relay
10
Foglamp Isolation Relay
11
Not Used
12
Not Used
13
Park Lamp/Trailer Tow Relay
14
Washer Pump Relay
1
RABS Resistor
1
RABS Diode
2
Electronic Engine Controls Diode
* Mini Fuses ** Maxi Fuses
Roadside emergencies
140