Ford Mountaineer - 2000 Fuse Box Diagram

Ford Mountaineer - 2000 Fuse Box Diagram

All occupants of the vehicle, including the driver, should always
properly wear their safety belts, even when an air bag SRS is
provided.
Always transport children 12 years old and under in the back
seat and always properly use appropriate child restraints.
National Highway Traffic Safety Administration (NHTSA)
recommends a minimum distance of at least 25 cm (10 inches)
between an occupant’s chest and the driver air bag module.
Never place your arm over the air bag module as a deploying air
bag can result in serious arm fractures or other injuries.
Steps you can take to properly position yourself away from the air bag:
Move your seat to the rear as far as you can while still reaching the
pedals comfortably.
Recline the seat slightly (one or two degrees) from the upright
position.
Do not put anything on or over the air bag module. Placing
objects on or over the air bag inflation area may cause those
objects to be propelled by the air bag into your face and torso causing
serious injury.
Do not attempt to service, repair, or modify the Air Bag
Supplemental Restraint System or its fuses. See your Ford or
Lincoln-Mercury dealer.
Seating and safety restraints
127
Do not lean your head on the door. The side air bag could injure
you as it deploys from the side of the seatback.
Do not attempt to service, repair, or modify the air bag
Supplemental Restraint System, its fuses or the seat cover on a
seat containing an air bag. See your Ford or Lincoln Mercury dealer.
All occupants of the vehicle including the driver should always
wear their safety belts even when an air bag SRS is provided.
How does the side air bag system work?
The side air bag system consists of
the following:
An inflatable nylon bag (air bag)
with a gas generator concealed
behind the outboard bolster of
the driver and front passenger
seatbacks.
A special seat cover designed to
allow airbag deployment.
The same warning light,
electronic control and diagnostic
unit as used for the front air
bags.
Two crash sensors located on the
“B” pillar.
Side air bags, in combination with
seat belts, can help reduce the risk of severe injuries in the event of a
significant side impact collision.
The side air bags are fitted on the outboard side of the seatbacks of the
front seats. In certain lateral collisions, the air bag on the side affected
by the collision will be inflated, even if the respective seat is not
occupied. The air bag was designed to inflate between the door panel
and occupant to further enhance the protection provided occupants in
side impact collisions.
Seating and safety restraints
131
2. Insert the key and turn it to OFF. Apply the brake pedal and shift to N
(Neutral).
3. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift lever,
it is possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to
Fuses and relays
in the
Roadside
emergencies
chapter.
Do not drive your vehicle until you verify that the brakelamps
are working.
If your vehicle gets stuck in mud or snow it may be rocked out by
shifting between forward and reverse gears, stopping between shifts, in a
steady pattern. Press lightly on the accelerator in each gear.
Do not rock the vehicle if the engine is not at normal operating
temperature or damage to the transmission may occur.
Do not rock the vehicle for more than a few minutes or damage
to the transmission and tires may occur or the engine may
overheat.
Always set the parking brake fully and make sure the gearshift is
latched in P (Park). Turn off the ignition whenever you leave
your vehicle.
If the parking brake is fully released, but the brake warning lamp
remains illuminated, the brakes may not be working properly.
See your dealer or a qualified service technician.
Driving with a 4–speed automatic transmission (if equipped)
To put your vehicle in gear, start the engine, depress the brake pedal,
then move gearshift lever out of P (Park).
Hold the brake pedal down while you move the gearshift lever
from P (Park) to another position. If you do not hold the brake
pedal down, your vehicle may move unexpectedly and injure someone.
Driving
149
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause
severe wire damage and could start a fire.
Standard fuse amperage rating and color
COLOR
Fuse
Rating
Mini
Fuses
Standard
Fuses
Maxi
Fuses
Cartridge
Maxi
Fuses
Fuse Link
Cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
Pink
40A
Orange
Green
Green
50A
Red
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
15
Roadside emergencies
174
Passenger compartment fuse panel
The fuse panel is located on the left
hand side of the instrument panel
facing the driver’s side door. Pull the
panel cover outward to access the
fuses.
To remove a fuse use the fuse puller tool provided on the fuse panel
cover.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
29
30
35
36
31
32
33
34
27
28
Roadside emergencies
175
The fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse Panel
Description
1
7.5A
Power Mirror Switch, Power Antenna,
Memory Seat
2
7.5A
Blower Motor Relay, Air Bag Diagnostic
Monitor
3
7.5A
Left Stop/Turn Trailer Tow Connector
4
10A
Left Headlamp
5
10A
Data Link Connector (DLC)
6
7.5A
Rear Blower Motor (Without EATC)
7
7.5A
Right Stop/Turn Trailer Tow Connector
8
10A
Right Headlamp, Foglamp Relay
9
7.5A
Brake Pedal Position Switch
10
7.5A
Speed Control/Amplifier Assembly, Generic
Electronic Module (GEM), Shift Lock
Actuator, Blend Door Actuator, A/C -
Heater Assembly, Flasher, Overhead
Console, Load Leveling Module
11
7.5A
Instrument Cluster
12
7.5A
Washer Pump Relay, Rear Washer Pump
Relay
13
20A
Brake Pedal Position Switch, Brake
Pressure Switch
14
10A
4 Wheel Anti-Lock Brake System (4WABS)
Module, 4WABS Main Relay
15
7.5A
Instrument Cluster
16
30A
Windshield Wiper Motor, Wiper Hi-Lo Relay,
Wiper Run/Park Relay
17
25A
Cigar Lighter
18
25A
Drivers Unlock Relay, All Unlock Relay, All
Lock Relay, Power Seats
19
25A
PCM Power Diode
20
7.5A
RAP Module, Generic Electronic Module
(GEM), Radio, Cellular Phone
Roadside emergencies
176
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse Panel
Description
21
15A
Flasher (Hazard)
22
20A
Auxiliary Power Socket
23
Not Used
24
7.5A
Clutch Pedal Position (CPP) Switch,
Starter Interrupt Relay, Anti-Theft
25
7.5A
Generic Electronic Module (GEM),
Instrument Cluster, Securi-Lock
26
10A
Battery Saver Relay, Electronic Shift Relay,
Interior Lamp Relay, Electronic Shift
Control Module
27
15A
DRL, Backup Lamps Switch, DTR Sensor
28
7.5A
Generic Electronic Module (GEM), Radio,
Memory Seat
29
25A
Radio
30
15A
Park Lamp/Trailer Tow Relay
31
Not Used
32
10A
Heated Mirror
33
15A
Headlamps, Daytime Running Lamps (DRL)
Module, Instrument Cluster
34
7.5A
Rear Integrated Control Panel, CD
35
7.5A
Rear Blower Motor (With EATC)
36
7.5A
EATC Memory, CD, Rear Integrated Control
Panel, Memory Seat, Message Center
Roadside emergencies
177
Power distribution box
The power distribution box is
located in the engine compartment.
The power distribution box contains
high-current fuses that protect your
vehicle’s main electrical systems
from overloads.
Always disconnect the battery before servicing high current
fuses.
Always replace the cover to the Power Distribution Box before
reconnecting the battery or refilling fluid reservoirs.
If the battery has been disconnected and reconnected, refer to the
Battery
section of the
Maintenance and care
chapter.
Roadside emergencies
178
The high-current fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box Description
1
60A**
I/P Fuse Panel
2
40A**
Blower Motor Relay
3
50A**
4 Wheel Anti-Lock Brake System (4WABS)
Module
4
30A**
Power Windows, Power Moon Roof, Power
Seat
5
50A**
Ignition Switch, Starter Relay
6
20A**
Transfer Case Relay
7
Not Used
8
20A**
Air Suspension
9
40A**
Air Suspension
10
30A**
PCM Power Relay
1
10A*
A/C Relay
2
30A*
Heated Seats
3
30A*
Heated Backlight
4
15A*
Fog Lamps and Daytime Running Lamps
5
Not Used
5
4
3
2
1
10
9
8
7
6
12
11
10
9
8
7
6
5
4
3
2
1
14
15
13
2
1
1
9
6
10
8
7
5
4
1
2
3
175
MEGAFUSE
Roadside emergencies
179
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box Description
6
10A*
Powertrain Control Module
7
30A*
4 Wheel Anti-Lock System (4WABS)
Module
8
15A*
Rear Wiper Motor
9
20A*
Fuel Pump Relay and RAP Module
10
15A*
Horn Relay
11
15A*
Parklamps Relay and Mainlight Switch
12
30A*
Mainlight Switch and Multifunction Switch
13
15A*
Heated Oxygen Sensor, EGR Vacuum
Regulator, EVR Solenoid, Camshaft Position
(CMP) Sensor, Canister Vent Solenoid
14
30A*
Generator/Voltage Regulator
15
Not Used
1
--
Wiper Park Relay
2
--
A/C Relay
3
--
Wiper High/Low Relay
4
--
PCM Power Relay
5
--
Fuel Pump Relay
6
--
Starter Relay
7
--
Horn Relay
8
--
Rear Wiper Down Relay
9
--
Blower Motor Relay
10
--
Rear Wiper Up Relay
1
--
Not Used
1
--
DRL Diode
2
--
Electronic Engine Controls Diode
* Mini Fuses ** Maxi Fuses
CHANGING THE TIRES
If you get a flat tire while driving, do not apply the brake heavily.
Instead, gradually decrease your speed. Hold the steering wheel firmly
and slowly move to a safe place on the side of the road.
Roadside emergencies
180