Ford Marauder - 2004 Fuse Box Diagram

Ford Marauder - 2004 Fuse Box Diagram

2. After 20 seconds CHANNELS
CLEARED is displayed. Continue to
hold the buttons.
3. After 10 more seconds,
CHANNELS DEFAULTED is
displayed when all the channel
default codes have been successfully
loaded.
Note:
If you need to train the
garage door opener, refer to
“Train
mode”
in this section.
AUXILIARY POWER POINT
The auxiliary power point is located in the floor console storage bin.
Do not plug optional electrical accessories into the cigarette lighter. Use
the power point.
Do not use the power point for operating the cigarette lighter element.
The Maximum power each power point can supply depends on the fuse
rating. For example: a 20A fuse should supply a maximum of 240 Watts,
a 15A fuse should supply a maximum of 180 Watts and a 10A fuse should
supply a maximum of 120 Watts. Exceeding these limits will result in a
blown fuse.
Always keep the power point caps closed when not being used.
Power outlets are designed for accessory plugs only. Do not hang
any type of accessory or accessory bracket from the plug.
Improper use of the power outlet can cause damage not covered
by your warranty.
Driver Controls
47
Do not attempt to service, repair, or modify the air bag
supplemental restraint systems or its fuses. See your Ford or
Lincoln Mercury dealer.
The front passenger air bag is not designed to offer protection to
an occupant in the center front seating position.
Modifying or adding equipment to the front end of the vehicle
(including frame, bumper, front end body structure and tow
hooks) may affect the performance of the air bag system, increasing
the risk of injury. Do not modify the front end of the vehicle.
Children and air bags
Children must always be properly
restrained. Accident statistics
suggest that children are safer when
properly restrained in the rear
seating positions than in the front
seating position. Failure to follow
these instructions may increase the
risk of injury in a collision.
Air bags can kill or injure a
child in a child seat.
NEVER
place a rear-facing child
seat in front of an active air bag. If
you must use a forward-facing
child seat in the front seat, move
the seat all the way back.
Seating and Safety Restraints
92
A difficulty with the system is indicated by one or more of the following:
The readiness light will either
flash or stay lit.
The readiness light will not
illuminate immediately after
ignition is turned on.
A series of five beeps will be heard. The tone pattern will repeat
periodically until the problem and/or light are repaired.
If any of these things happen, even intermittently, have the SRS serviced
at your dealership or by a qualified technician immediately. Unless
serviced, the system may not function properly in the event of a
collision.
Side air bag system
Do not place objects or mount equipment on or near the air bag
cover on the side of the seatbacks of the front seats or in front
seat areas that may come into contact with a deploying air bag. Failure
to follow these instructions may increase the risk of personal injury in
the event of a collision.
Do not use accessory seat covers. The use of accessory seat
covers may prevent the deployment of the side air bags and
increase the risk of injury in an accident.
Do not lean your head on the door. The side air bag could injure
you as it deploys from the side of the seatback.
Do not attempt to service, repair, or modify the air bag SRS, its
fuses or the seat cover on a seat containing an air bag. See your
Ford or Lincoln Mercury dealer.
All occupants of the vehicle should always wear their safety belts
even when an air bag SRS is provided.
Seating and Safety Restraints
95
If it is necessary to use the above procedure to move the gearshift lever,
it is possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to
Fuses and relays
in the
Roadside
emergencies
chapter.
Do not drive your vehicle until you verify that the brakelamps
are working.
Always set the parking brake fully and make sure the gearshift is
latched in P (Park). Turn the ignition to the LOCK position and
remove the key whenever you leave your vehicle.
If the parking brake is fully released, but the brake warning lamp
remains illuminated, the brakes may not be working properly.
See your dealer or a qualified service technician.
Driving with a 4–speed automatic transmission
Understanding the gearshift positions of the 4–speed automatic
transmission
P (Park)
This position locks the transmission and prevents the rear wheels from
turning.
To put your vehicle in gear:
Start the engine
Depress the brake pedal
Move the gearshift lever into the desired gear
P
R
N
D
2
1
Driving
120
The fuel pump shut-off switch is
located on the left side of the trunk
behind the left rear tail light and the
trunk liner.
Use the following procedure to reset the fuel pump shut-off switch.
1. Turn the ignition to the OFF position.
2. Check the fuel system for leaks.
3. If no fuel leak is apparent, reset the fuel pump shut-off switch by
pushing in on the reset button.
4. Turn the ignition to the ON position. Pause for a few seconds and
return the key to the OFF position.
5. Make a further check for leaks in the fuel system.
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
15
Roadside Emergencies
132
Note:
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause severe wire
damage and could start a fire.
Standard fuse amperage rating and color
COLOR
Fuse
rating
Mini
fuses
Standard
fuses
Maxi
fuses
Cartridge
maxi
fuses
Fuse link
cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
Pink
40A
Orange
Green
Green
50A
Red
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
Passenger compartment fuse panel
The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the panel cover to access the fuses.
To remove a fuse use the fuse puller tool provided on the fuse panel
cover.
Roadside Emergencies
133
The fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
1
15A
Audio, CD changer
2
5A
Audio
3
7.5A
Mirrors
4
10A
Air bags
5
Not used
6
15A
Instrument cluster warning lamps
module, Overdrive control switch,
Lighting Control Module (LCM),
Gauge pack, Analog cluster
7
10A
Driver’s Door Module (DDM),
Audio (Start)
8
25A
Powertrain Control Module (PCM)
power relay, Coil-on plugs, Radio
noise capacitor, Passive Anti-Theft
System (PATS)
9
5A
Transmission range sensor
27
25
26
24
23
21
22
19
20
18
16
17
15
14
12
13
10
30
32
31
28
29
11
9
7
8
6
5
3
4
1
2
Roadside Emergencies
134
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
10
10A
Rear window defrost, Heated
mirrors
11
5A
Traction control indicator relay
(ABS w/traction control only)
12
15A
Multi-function switch for
turn/hazard lamps
13
5A
Audio (Run/Accy)
14
10A
Anti-lock Brake System (ABS),
Instrument Cluster
15
15A
Speed control, LCM, EATC blower
motor relay, Door lock switch
illumination, Moonroof, Heated
seat switch
16
15A
Reversing lamps, Shift lock, DRL
module, VAP Steering, Electronic
day/night mirror, Overhead
console, Air suspension, Climate
control, Heated seat module,
Speed chime module (GCC only),
DDM, Back-up lamps
17
7.5A
Wiper motor
18
15A
Fog lamps
19
15A
Brake lamps, Brake signal for
PCM, ABS and speed control
module, DDM
20
Not used
21
15A
LCM for park lamps and interior
illumination, Autolamp/Sunload
sensor
22
20A
Speed control servo,
Multi-function switch for hazard
lamps, Brake on/off switch, Feed
for IP fuse 19
Roadside Emergencies
135
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
23
15A
EATC module, Instrument cluster,
LCM, Interior lamps, Door lock
switches
24
10A
Left-hand low beam
25
15A
Cigar lighter
26
10A
Right-hand low beam
27
25A
LCM for cornering lamps and high
beam headlamps, Police vehicle
option
28
20A*
Power windows
29
Not used
30
Not used
31
Not used
32
Not used
* Circuit breaker
Power distribution box
The power distribution box is located in the engine compartment. The
power distribution box contains high-current fuses that protect your
vehicle’s main electrical systems from overloads.
Always disconnect the battery before servicing high current
fuses.
Always replace the cover to the power distribution box before
reconnecting the battery or refilling fluid reservoirs
If the battery has been disconnected and reconnected, refer to the
Battery
section of the
Maintenance and specifications
chapter.
Roadside Emergencies
136
The high-current fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
1
25A*
Audio
2
20A*
Power point
3
25A*
Heated seats
4
15A*
Horns
5
20A*
Fuel pump module
6
15A*
Alternator
7
25A*
Moonroof
8
20A*
Driver’s Door Module (DDM)
9
Not used
10
Not used
11
20A*
Daytime running lamps
12
Not used
13
Not used
14
Not used
15
Not used
503
502
501
24
23
401
20
19
22
21
RELAY
302
RELAY
304
RELAY
303
RELAY
301
207
201
202
203
204
209
206
208
205
602
601
118
114
110
106
102
117
113
109
105
101
116
112
108
104
115
111
107
103
18
16
14
12
10
8
6
4
2
17
15
13
11
9
7
5
3
1
Roadside Emergencies
137
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
16
Not used
17
Not used
18
Not used
19
15A*
Powertrain Control Module
(PCM), Fuel injectors
20
15A*
PCM, HEGOs
21
Not used
22
Not used
23
Not used
24
Not used
101
30A**
Ignition switch, Starter motor
solenoid via starter relay, IP fuses
7, 9, 12 and 14
102
50A**
Cooling fan (engine)
103
40A**
Blower motor
104
40A**
Heated backlight relay
105
30A**
PCM power relay, Diagnostic
connector, PDB fuses 19 and 20,
A/C clutch relay, Fuel pump
module relay
106
40A**
Anti-lock Brake System (ABS)
107
Not used
108
Not used
109
Not used
110
Not used
111
Not used
112
50A**
Ignition switch feed to IP fuses 4,
6, 8, 11, 13, 15, 17, 20, 22 and 28
113
50A**
Feeds IP fuses 3, 5, 21, 23, 25, 27
114
30A**
VAP Steering, Air suspension
compressor, Instrument cluster
Roadside Emergencies
138
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
115
50A**
Ignition switch feed to IP fuses 16
and 18
116
30A**
Wipers
117
Not used
118
20A**
ABS
201
1/2 ISO
Horn relay
202
1/2 ISO
PCM relay
203
1/2 ISO
Fuel pump relay
204
1/2 ISO
A/C clutch relay
205
1/2 ISO
Traction control switch relay
206
Not used
207
1/2 ISO
Fog lamp relay
208
1/2 ISO
Moonroof relay
209
1/2 ISO
Hi-beam disable with fog lamp
relay
301
Full ISO
Blower motor relay
302
Full ISO
Starter solenoid relay
303
Full ISO
Air suspension relay
304
Full ISO
Heated backlight relay
401
Not used
501
Diode
PCM diode
502
Diode
A/C clutch
503
Not used
601
Not used
602
20A**
Adjustable pedals, Power seat,
Locks, Decklid, Lumbar
* Mini fuse ** Circuit breaker/Maxi fuse
Relays
Relays are located in the power distribution box and should be replaced
by qualified technicians.
Roadside Emergencies
139