Ford Low Cab Forward - 2007 Fuse Box Diagram

Ford Low Cab Forward - 2007 Fuse Box Diagram

Engine starting (parking brake applied)
Safety/Emergency
equipment:
Prior to entering the cab, verify that the
vehicle is equipped with spare electrical fuses
(if used), three red reflective triangles, a
properly charged and rated fire extinguisher
and wheel chocks. Walk around the vehicle
and check that all steps and grab handles,
inside and out as well as behind, are tight and
clean. Use extreme caution and a three-point
stance at all times. Check door latches for
positive closing, latching and locking.
Starting the engine:
Verify the parking brake is set and the
transmission is in P (Park).
When the WAIT TO START indicator light in
the instrument cluster turns off, turn the key
to START.
Accelerator:
With the engine running and the transmission
in P (Park), depress the accelerator and verify
that it operates smoothly without any binding
or irregular feel. Remove your foot from the
pedal and make sure the engine returns to idle
speed immediately.
Steering linkage
free play:
Check for excessive free play in the steering
linkages. The steering wheel should have less
than two inches (five centimeters) of free play
at rim of steering wheel.
Brake check:
Pump the brake pedal three times, then apply
firm pressure to the pedal and hold it for five
seconds. Once applied, the pedal should not
move; if it does, there may be a leak or
another problem. Do not drive the vehicle
until the problem is fixed.
Parking brake:
Check that the parking brake will hold the
vehicle by gently trying to pull forward with
the parking brake applied.
2007 Low Cab Forward Truck
(lcf)
Supplement
USA
(fus)
Vehicle Inspection Guide
12
3. Remove the shifter shroud, then
depress the override mechanism as
shown in the illustration.
4. While depressing the override
mechanism,
apply the brake pedal
and shift to N (Neutral).
5. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift lever,
it is possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to
Fuses
in the
Roadside Emergencies
chapter.
Do not drive your vehicle until you verify that the brakelamps
are working.
Always set the parking brake fully and make sure the gearshift is
latched in P (Park). Turn the ignition to the LOCK position and
remove the key whenever you leave your vehicle.
If the parking brake is fully released, but the brake warning lamp
remains illuminated, the brakes may not be working properly.
See your dealer or a qualified service technician as soon as possible.
2007 Low Cab Forward Truck
(lcf)
Supplement
USA
(fus)
Driving
81
GETTING ROADSIDE ASSISTANCE
To fully assist you should you have a vehicle concern, Ford offers a
complimentary roadside assistance program. This program is separate
from the New Vehicle Limited Warranty and is not applicable to vehicles
sold in Canada. The service is available:
24–hours, seven days a week
for the New Vehicle Limited Warranty period (U.S.) of two years
(unlimited miles)
Roadside assistance will cover:
jump-starts.
lock-out assistance.
towing to the nearest Ford Motor Company dealership, or towing to
your selling dealership if within 35 miles (56 km). Even non-warranty
related tows, like accidents or getting stuck in the mud or snow, are
covered (some exclusions apply, such as impound towing or
repossession).
Using roadside assistance
Complete the roadside assistance identification card and place it in your
wallet for quick reference. This card is found in the Owner Guide
portfolio in the glove compartment.
To receive roadside assistance in the United States, call 1-800-241-3673.
If you need to arrange roadside assistance for yourself, Ford will
reimburse a reasonable amount. To obtain information about
reimbursement, call 1-800-241-3673.
HAZARD FLASHER
The hazard flasher control is located
on the instrument panel, to the right
of the steering wheel. The hazard
flashers will operate when the
ignition is off.
Push in the flasher control and all front and rear direction signals will
flash. Press the flasher control again to turn them off. Use it when your
vehicle is disabled and is creating a safety hazard for other motorists.
Note:
With extended use, the flasher may run down your battery.
FUSING
If electrical components in the vehicle are not working, a fuse may have
blown. Blown fuses are identified by a broken wire within the fuse.
Check the appropriate fuses before replacing any electrical components.
2007 Low Cab Forward Truck
(lcf)
Supplement
USA
(fus)
Roadside Emergencies
93
Note:
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause severe wire
damage and could start a fire.
Power distribution box (PDB)
The PDB is located behind the cab
on the right-hand frame rail, behind
a protective cover.
To access the PDB, the protective
cover must be taken off the vehicle
by removing the two screws (shown
in illustration), then gently pulling
the cover off.
Note:
Remove and install the cover
carefully so that no wires or cables
become disconnected or damaged.
Note:
Always re-install the
protective cover to avoid water or
fluids from damaging the PDB or
other electrical components.
2007 Low Cab Forward Truck
(lcf)
Supplement
USA
(fus)
Roadside Emergencies
94
Once the cover has been removed,
simply lift the tab on the PDB cover
to access the fuses and relays.
Always disconnect the
battery before servicing high
current fuses.
2007 Low Cab Forward Truck
(lcf)
Supplement
USA
(fus)
Roadside Emergencies
95
The fuses and relays are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Fuse Description
1
Not used
2
30A*
Starter
3
20A*
Park lamps
4
40A*
Injector Driver Module (IDM)/Powertrain
Control Module (PCM)
5
30A*
Headlamps
6
40A*
Blower motor
7
25A*
Wipers
8
30A*
Electric brakes
9
20A*
Door locks
10
20A*
Stoplamps
11
20A*
Fuel pump
12
20A*
RUN/ACC feed
13
20A*
RUN/START feed
14
15A**
Horn
15
10A**
Cluster
16
15A**
Back-up lamps
17
15A**
Fog lamps
18
15A**
Transmission
19
20A*
Fuel heater
20
60A*
Anti-lock Brake System (ABS) module
21
20A*
Trailer lighting circuit
22
30A*
Body builder circuits
23
40A*
Trailer battery charge
24
20A**
Cigar lighter
25
20A**
Hazard flasher
26
15A**
Remote Keyless Entry (RKE)
27
10A**
Radio
28
10A**
Dome lamp
29
60A*
ABS pump
2007 Low Cab Forward Truck
(lcf)
Supplement
USA
(fus)
Roadside Emergencies
96
Fuse/Relay
Location
Fuse Amp
Rating
Fuse Description
30
30A*
HVAC pusher fan
31
20A*
Diagnostic connector
32
40A*
Power windows
33
25A*
Body builder prep
34
20A*
A/C clutch
35
20A*
Cluster
36
Not used
37
10A**
Turn signals
38
Not used
39
10A**
Cornering lamps
40
10A**
IDM logic power, Fan drive
41
10A**
PCM power
42
10A**
Radio
43
Not used
44
Not used
45
Not used
46
5A**
PCM key power
47
Micro relay
Body builder prep
48
Micro relay
Fuel pump
49
Micro relay
Back-up lamps
50
Micro relay
PCM
51
Micro relay
Fuel heater
52
Micro relay
Transmission
53
Micro relay
A/C clutch
54
Micro relay
Fog lamps
55
Full ISO
relay
IDM
56
Full ISO
relay
Wiper
57
Full ISO
relay
Starter
2007 Low Cab Forward Truck
(lcf)
Supplement
USA
(fus)
Roadside Emergencies
97
Fuse/Relay
Location
Fuse Amp
Rating
Fuse Description
58
Not used
59
Micro relay
Park lamps
60
Transmission relay diode
61
Not used
* Cartridge fuse **Mini fuse
Relays
The relay box is located under the center of the instrument panel.
The instrument panel lower trim
panel must be removed to access
the relays. Remove the plastic rivet
from the driver side of the trim
panel.
2007 Low Cab Forward Truck
(lcf)
Supplement
USA
(fus)
Roadside Emergencies
98