Ford Ford GT - 2006 Fuse Box Diagram

Ford Ford GT - 2006 Fuse Box Diagram

5. To prolong the life of the wiper blades, it is highly recommended to
scrape off the ice on the windshield before turning on the wipers. The
layer of ice has many sharp edges and can damage the micro edge of the
wiper rubber element.
TILT STEERING COLUMN
Pull the locking lever down to tilt
and telescope the steering column
to the desired orientation. Return
the lever to its original position to
secure the wheel.
Never adjust the steering wheel when the vehicle is moving.
AUXILIARY POWER POINT
Power point outlets are designed
for accessory use only. Do not
hang any type of accessories or
accessory bracket from the their
plugs. Improper use of the
power point outlet can cause
damage not covered by your
warranty.
The maximum power the power
point can supply is 20A and 240
Watts. Exceeding these limits will result in a blown fuse.
Always keep the power point caps closed when not being used.
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Driver Controls
25
National Highway Traffic Safety Administration (NHTSA)
recommends a minimum distance of at least 10 inches (25 cm)
between an occupant’s chest and the driver air bag module.
Never place your arm over the air bag module as a deploying air
bag can result in serious arm fractures or other injuries.
Steps you can take to properly position yourself away from the air bag:
Move your seat to the rear as far as you can while still reaching the
pedals comfortably.
Recline the seat slightly (one or two degrees) from the upright
position.
Do not put anything on or over the air bag module. Placing
objects on or over the air bag inflation area may cause those
objects to be propelled by the air bag into your face and torso causing
serious injury.
Do not attempt to service, repair, or modify the air bag
supplemental restraint system (SRS) or its fuses. See your Ford
or Lincoln Mercury dealer.
Modifying or adding equipment to the front end of the vehicle
(including frame, bumper, front end body structure and tow
hooks) may affect the performance of the air bag system, increasing
the risk of injury. Do not modify the front end of the vehicle.
Children and air bags
For additional important safety information, read all information on
safety restraints in this guide.
Children must always be properly restrained. Failure to follow these
instructions may increase the risk of injury in a collision.
Air bags can kill or injure a child in a child seat.
NEVER
place a
rear-facing child seat in front of an active air bag. If you must
use a forward-facing child seat in the front seat, move the seat all the
way back and turn the passenger air bag off. Refer to
Passenger air
bag ON/OFF switch
in this chapter of the owner’s guide.
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Seating and Safety Restraints
49
This switch has a red reset button
on top of it and is located in the
front passenger’s footwell, behind an
access panel and to the left of the
fuse panel. To access the switch, roll
back the floor mat and unscrew the
four release pins on the panel.
To reset the switch:
1. Turn the ignition OFF.
2. Check the fuel system for leaks.
3. If no leaks are apparent, reset the
switch by pushing in on the reset
button.
4. Turn the ignition ON.
5. Wait a few seconds and return
the key to OFF.
6. Make another check for leaks.
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
Note:
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause severe wire
damage and could start a fire.
15
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
107
Standard fuse amperage rating and color
COLOR
Fuse
rating
Mini
fuses
Standard
fuses
Maxi
fuses
Cartridge
maxi
fuses
Fuse link
cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
Pink
40A
Orange
Green
Green
50A
Red
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
Passenger compartment fuse panel
The fuse panel is located in the
passenger footwell, behind an access
panel. Roll back the floor mat and
unscrew the four release pins on the
panel to access the fuse panel.
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
108
The fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
1
Not used
2
Not used
3
15A*
Front and rear park lamps,
License plate lamps, Side markers
4
10A*
Ignition switch, Start relay,
Cluster start signal, Start cut-out
relay
5
2A*
Powertrain Control Module (PCM)
relay coil, Injector relay coil
6
10A*
Center High-Mounted Stop Lamp
(CHMSL), Stop lamps
7
5A*
Climate control module (if
equipped), EPATS module
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
109
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
8
15A*
Door ajar indicator, Headlamp
indicator, Cluster, Radio, OBD II,
Mirrors
9
20A**
Power door lock motors,
Electronic door latch motors
10
5A*
Rear defroster switch indicator
light
11
Not used
12
5A*
Radio delayed accessory
13
Not used
14
Not used
15
30A**
Power window motors
16
5A*
McIntosh audio power supply
17
15A*
Headlamps
18
15A*
Lighting (interior);
Stop/turn/hazard lamps
19
Not used
20
15A*
Horn
21
5A*
Seat belt indicator
22
5A*
Climate control module (if
equipped)
23
Not used
24
Not used
25
20A*
Wiper motor, Washer motor
26
5A*
Heated PCV
27
5A*
EPATS module
28
10A*
Instrument cluster Run/Start
power
29
10A*
Back-up lamps
30
Not used
31
Not used
32
10A*
Climate control module
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
110
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
33
15A*
Restraint Control Module (RSM),
Passenger Air bag Deactivation
(PAD) indicator lamp, ACS switch
34
5A*
Anti-lock Brake System (ABS)
Run/Acc Input
35
Not used
* Mini fuse ** Cartridge fuse
Power distribution box
The power distribution box is
located in the front compartment.
The power distribution box contains
high-current fuses that protect your
vehicle’s main electrical systems
from overloads.
Note:
The luggage compartment liner must be removed to access the
power distribution box. Refer to
Removing the luggage compartment
liner
in the
Maintenance and Specifications
chapter.
Always disconnect the battery before servicing high current
fuses.
To reduce risk of electrical shock, always replace the cover to
the Power Distribution Box before reconnecting the battery or
refilling fluid reservoirs.
If the battery has been disconnected and reconnected, refer to the
Battery
section of the
Maintenance and Specifications
chapter.
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
111
The high-current fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
1
40A**
SJB (Instrument panel fuse panel)
2
40A**
SJB (Instrument panel fuse panel)
3
30A**
SJB (Instrument panel fuse panel)
4
40A**
Anti-lock Brakes System (ABS)
motor
5
30A**
Blower motor
6
30A**
Rear defroster, Park lamp fuse
7
40A**
Powertrain Control Module (PCM)
power fuse, Heated Exhaust Gas
Oxygen (HEGO) sensor fuse
8
40A**
Cooling fan (High-speed fan #2)
9
40A**
Cooling fan (High-speed fan #1)
10
40A**
Cooling fan (Low-speed fan)
11
30A**
Starter solenoid, Ignition switch,
SJB (Instrument panel fuse panel)
Run/Start power
12
30A**
Subwoofer (McIntosh audio only)
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
112
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
13
30A**
Primary Fuel Pump Delivery
Module (FPDM), Secondary Fuel
Pump Delivery Module (FPDM)
14
30A**
Intercooler pump
15
20A*
Alternator field circuit
16
5A*
EEC keep alive power
17
25A*
Lighting (Left headlamp)
18
25A*
Lighting (Right headlamp)
19
20A*
Fog lamps
20
20A*
Anti-lock Brake System (ABS)
module
21
10A*
A/C clutch coil
22
20A*
Power point
23
Full ISO relay
High-speed fan #2
24
Full ISO relay
Low-speed fan
25
Full ISO relay
PCM
26
Full ISO relay
High-speed fan #1
27
20A*
Injector
28
15A*
HEGO sensors
29
15A*
PCM power: PCM, Mass Air Flows
(MAF) sensor/IAT sensor, BFIM,
VMV, CVS, SCBS, Exhaust Gas
Recirculation (EGR) valve, Idle
Air Control (IAC)
30
1
±
2
ISO relay
Supercharger intercooler
31
1
±
2
ISO relay
Right headlamp
32
1
±
2
ISO relay
Left headlamp
* Mini fuse **Cartridge fuse
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
113
Auxiliary relay box
The relay box is located in the front of the vehicle under the hood.
Fuse/Relay
location
Fuse amp
rating
Auxiliary Relay Box Description
1
Mini
resistor
Anti- lock Brakes System (ABS)
2
15A*
Primary Fuel Pump Delivery Module (FPDM)
3
15A*
Secondary Fuel Pump Delivery Module
(FPDM)
4
Mini relay
Starter
5
Micro relay
Air conditioning
6
Micro relay
Fog lamp
7
Micro relay
Accessory cut-out
8
Micro relay
Fuel pump #2
9
Micro relay
Fuel pump #1
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
114
Fuse/Relay
location
Fuse amp
rating
Auxiliary Relay Box Description
10
Micro relay
High speed wiper
11
Micro relay
Intermittent wiper
12
Micro relay
Wiper stop relay
* Mini fuse
JUMP STARTING YOUR VEHICLE
The gases around the battery can explode if exposed to flames,
sparks, or lit cigarettes. An explosion could result in injury or
vehicle damage.
Batteries contain sulfuric acid which can burn skin, eyes and
clothing, if contacted.
Note:
The luggage compartment liner must be removed to access the
battery for jump starting. Refer to
Removing the luggage compartment
liner
in the
Maintenance and Specifications
chapter.
Preparing your vehicle
1.
Use only a 12–volt supply to start your vehicle.
2. Do not disconnect the battery of the disabled vehicle as this could
damage the vehicle’s electrical system.
3. Park the booster vehicle close to the hood of the disabled vehicle
making sure the two vehicles
do not
touch. Set the parking brake on
both vehicles and stay clear of the engine cooling fan and other moving
parts.
4. Check all battery terminals and remove any excessive corrosion before
you attach the battery cables. Ensure the vent caps are tight and level.
5. Turn the heater fan on in both vehicles to protect any electrical
surges. Turn all other accessories off.
200
6
GT
(gto)
Owners Guide (post-2002-fmt)
USA_English
(fus)
Roadside Emergencies
115