Ford Focus - 2006 Fuse Box Diagram

Ford Focus - 2006 Fuse Box Diagram

Installing a garage door opener (if equipped)
The storage compartment can be converted to accommodate a variety of
aftermarket garage door openers:
Place the VELCRO
²
hook onto
the side of the aftermarket
transmitter opposite of the
button.
Place the transmitter into storage
compartment, button down.
Place the provided height
adaptors onto the back of the
door as needed.
Close the door.
Press the depression in the door
to activate the transmitter.
AUXILIARY POWER POINT (12VDC)
Power outlet is designed for accessory plugs only. Do not insert
any other object in the power outlet as this will damage the
outlet and blow the fuse. Do not hang any type of accessory or
accessory bracket from the plug. Improper use of the power
outlet can cause damage not covered by your warranty.
The auxiliary power point is located
on the instrument panel.
Do not use the power point for
operating the cigarette lighter
element (if equipped).
To prevent the fuse from being
blown, do not use the power point
over the vehicle capacity of 12
VDC/180W.
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
41
Do not attempt to service, repair, or modify the airbag
supplemental restraint systems or its fuses. See your authorized
dealer.
Children and airbags
Children must always be properly
restrained. Accident statistics
suggest that children are safer when
properly restrained in the rear
seating positions than in the front
seating position. Failure to follow
these instructions may increase the
risk of injury in a collision.
Airbags can kill or injure a
child in a child seat.
NEVER
place a rear-facing child
seat in front of an active airbag. If
you must use a forward-facing
child seat in the front seat, move
the seat all the way back.
How does the airbag supplemental restraint system work?
The airbag SRS is designed to
activate when the vehicle sustains
longitudinal deceleration sufficient
to cause the sensors to close an
electrical circuit that initiates airbag
inflation. The fact that the airbags
did not inflate in a collision does not
mean that something is wrong with
the system. Rather, it means the
forces were not of the type
sufficient to cause activation. Front
airbags are designed to inflate in
frontal and near-frontal collisions, not rollover, side-impact, or
rear-impacts unless the collision causes sufficient longitudinal
deceleration.
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Seating and Safety Restraints
84
Do not use accessory seat covers. The use of accessory seat
covers may prevent the deployment of the side airbags and
increase the risk of injury in an accident.
Do not lean your head on the door. The side airbag could injure
you as it deploys from the side of the seatback.
Do not attempt to service, repair, or modify the airbag SRS, its
fuses or the seat cover on a seat containing an airbag. See your
authorized dealer.
All occupants of the vehicle should always wear their safety belts
even when an airbag SRS is provided.
How does the side airbag system work?
The side airbag system consists of
the following:
An inflatable nylon bag (airbag)
with a gas generator concealed
behind the outboard bolster of
the driver and front passenger
seatbacks.
A special seat cover designed to
allow airbag deployment.
The same warning light,
electronic control and diagnostic
unit as used for the front airbags.
Two crash sensors located under
the outboard side of the front
seats, attached to the floor.
Side airbags, in combination with
seat belts, can help reduce the risk of severe injuries in the event of a
significant side impact collision.
The side airbags are fitted on the outboard side of the seatbacks of the
front seats. In certain lateral collisions, the airbag on the side affected by
the collision will be inflated. The front passenger sensing system will
turn off the passenger seat side airbag if the seat is empty (unless for
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Seating and Safety Restraints
92
If you cannot move the gearshift lever out of P (Park) with ignition in
the ON position and the brake pedal depressed:
1. Apply the parking brake, turn ignition key to LOCK, then remove the
key.
When the key is in the ignition and in the OFF position, the
automatic transmission shift lever can be moved from the P
(Park) position without the brake pedal depressed. To avoid unwanted
vehicle movement, always set the parking brake.
2. Using a screwdriver (or similar
tool), remove the protective cover
to the interlock access hole on the
console. Insert the key to release
the interlock.
3. Apply the parking brake, then shift to N (Neutral).
4. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift lever,
it is possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to
Fuses and relays
in the
Roadside
Emergencies
chapter.
Do not drive your vehicle until you verify that the brakelamps
are working.
Always set the parking brake fully and make sure the gearshift is
latched in P (Park). Turn the ignition to the LOCK position and
remove the key whenever you leave your vehicle.
If the parking brake is fully released, but the brake warning lamp
remains illuminated, the brakes may not be working properly.
See your authorized dealer.
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Driving
136
This switch is located in the front
passenger’s footwell, behind the kick
panel access cover.
To reset the switch:
1. Turn the ignition OFF.
2. Check the fuel system for leaks.
3. If no leaks are apparent, reset the
switch by pushing in on the reset
button.
4. Turn the ignition ON.
5. Wait a few seconds and return the key to OFF.
6. Make another check for leaks.
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
Note:
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause severe wire
damage and could start a fire.
15
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
144
Standard fuse amperage rating and color
COLOR
Fuse
rating
Mini
fuses
Standard
fuses
Maxi
fuses
Cartridge
maxi
fuses
Fuse link
cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
Pink
40A
Orange
Green
Green
50A
Red
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
Passenger compartment fuse panel
The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the CD stowage box to access the fuses.
To remove a fuse, use the fuse puller tool provided on the power
distribution box cover located in the engine compartment.
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
145
The fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
R17
Starter relay
R18
Rear wiper intermittent relay
R19
Front wiper intermittent relay
R20
Not used
R21
Not used
R22
Not used
R23
Horn relay
R24
Battery saver relay
R25
Rear defrost/Heated mirror relay
30
10A
Parking lamps
31
20A
Radio
32
15A
Turn signal (GEM)
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
146
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
33
20A
Horn
34
20A
Power sunroof
35
7.5A
Interior lamps, Power mirrors
36
7.5A
A/C switch, Instrument cluster
37
Not used
38
Not used
39
Not used
40
10A
Back-up lamps (automatic
transaxle only)
41
7.5A
Radio and cluster (accessory)
42
10A
Stop lamps, Shift interlock
43
15A
Rear wiper, Sunroof (ignition)
44
Not used
45
7.5A
Recirculated air, Air conditioning
46
Not used
47
20A
Cigar lighter/Power point
48
10A
Data link connector
49
25A
Rear defroster
50
7.5A
Heated mirror, Heated backlite
indicator
51
7.5A
Front passenger sensing system
52
15A
Heated seats
53
10A
Back-up lamps (manual transaxle
only), Speed control
54
25A
Rear power windows
55
25A
Front power windows
56
20A
Front wipers
57
Not used
58
Not used
59
7.5A
Light switch (headlamps)
60
7.5A
Air bag module
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
147
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
61
7.5A
PATS modules, Instrument cluster
62
7.5A
Radio (Start)
63
20A
Power locks (GEM)
Fuse 63 is located on the back of the fuse panel. See your authorized
dealer for service of this fuse.
Power distribution box
The power distribution box is located in the engine compartment. The
power distribution box contains high-current fuses that protect your
vehicle’s main electrical systems from overloads.
Always disconnect the battery before servicing high current
fuses.
To reduce risk of electrical shock, always replace the cover to
the Power Distribution Box before reconnecting the battery or
refilling fluid reservoirs.
If the battery has been disconnected and reconnected, refer to the
Battery
section of the
Maintenance and Specifications
chapter.
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
148
To remove a fuse, use the fuse puller tool provided on the power
distribution box cover.
The high-current fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
1
40A
Main power supply (to passenger
compartment fuse panel)
2
Not used
3
Not used
4
30A
Air pump motor (PZEV engine
only)
5
Not used
6
50A
Engine cooling fan (Primary fuse)
7
40A
Main power supply (to passenger
compartment fuse panel)
8
30A
Ignition switch, Starter solenoid
9
20A
Engine management
10
1A
Battery voltage sense
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
149
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
11
30A
Subwoofer
12
15A
Fuel pump motor
13
Not used
14
Not used
15
20A
ABS (valves)
16
10A
Low beam (left-hand side)
17
10A
Low beam (right-hand side)
18
15A
Heated Exhaust Gas Oxygen
(HEGO) sensors
19
40A
Heater blower motor
20
10A
Engine module (KAP)
21
10A
A/C
22
20A
Daytime Running Lights (DRL)
23
Not used
24
30A
Anti-lock Brake System (ABS)
(pumps)
25
Not used
26
15A
Fog lamps
27
15A
High beams
28
Not used
29
10A
ABS module, Speed control
R1
Ignition relay
R2
Air pump motor relay (PZEV
engine only)
R3
Cooling fan (high-speed)
R4
Cooling fan (low-speed)
R5
High beams relay, Fog lamps
R6
Low beams relay
R7
Fuel pump relay
R8
Engine management relay
R9
Cooling fan relay
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
150
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
R10
Cooling fan relay
R11
A/C clutch solenoid relay
R12
DRL relay
R13
Not used
R14
Not used
R15
Not used
R16
Not used
D1
PCM diode
D2
Not used
D3
A/C clutch diode
D4
Not used
CHANGING A FLAT TIRE
If you get a flat tire while driving:
do not brake heavily.
gradually decrease the vehicle’s speed.
hold the steering wheel firmly.
slowly move to a safe place on the side of the road.
The use of tire sealants may damage your tires.
Dissimilar spare tire/wheel information
Failure to follow these guidelines could result in an increased
risk of loss of vehicle control, injury or death.
If you have a dissimilar spare tire/wheel, then it is intended for
temporary use only. This means that if you need to use it, you should
replace it as soon as possible with a road tire/wheel that is the same size
and type as the road tires and wheels that were originally provided by
Ford. If the dissimilar spare tire or wheel is damaged, it should be
replaced rather than repaired.
2006 Focus
(foc)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
151