Ford Escape - 2007 Fuse Box Diagram

Ford Escape - 2007 Fuse Box Diagram

AUXILIARY POWER POINT (12VDC)
Power outlets are designed for accessory plugs only. Do not insert
any other object in the power outlet as this will damage the
outlet and blow the fuse. Do not hang any type of accessory or
accessory bracket from the plug. Improper use of the power
outlet can cause damage not covered by your warranty.
The auxiliary power point is located
in the floor console. Cigarette lighter
(if equipped) is located in the
instrument panel.
Do not use the power point for
operating the cigarette lighter
element (if equipped).
To prevent the fuse from being
blown, do not use the power
point(s) over the vehicle capacity of
12 VDC/180W.
To prevent the battery from being discharged, do not use the power
point longer than necessary when the engine is not running.
Always keep the power point caps closed when not being used.
Cigar/Cigarette lighter (if equipped)
Do not plug optional electrical accessories into the cigarette lighter
socket.
Do not hold the lighter in with your hand while it is heating, this will
damage the lighter element and socket. The lighter will be released from
its heating position when it is ready to be used.
Improper use of the lighter can cause damage not covered by your
warranty.
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Driver Controls
56
The National Highway Traffic Safety Administration (NHTSA)
recommends a minimum distance of at least 10 inches (25 cm)
between an occupant’s chest and the driver airbag module.
Never place your arm over the airbag module as a deploying
airbag can result in serious arm fractures or other injuries.
To properly position yourself away from the airbag:
Move your seat to the rear as far as you can while still reaching the
pedals comfortably.
Recline the seat slightly one or two degrees from the upright position.
Do not put anything on or over the airbag module. Placing
objects on or over the airbag inflation area may cause those
objects to be propelled by the airbag into your face and torso causing
serious injury.
Do not attempt to service, repair, or modify the airbag
supplemental restraint systems or its fuses. See your authorized
dealer.
Modifications to the front end of the vehicle, including frame,
bumper, front end body structure, tow hooks and B-pillar
surrounding parts may affect the performance of the airbag sensors
increasing the risk of injury. Do not modify the front end of the
vehicle.
Additional equipment may affect the performance of the airbag
sensors increasing the risk of injury. Please refer to the
Body
Builders Layout Book
for instructions about the appropriate
installation of additional equipment.
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Seating and Safety Restraints
113
A difficulty with the system is indicated by one or more of the following:
The readiness light will either
flash or stay lit.
The readiness light will not
illuminate immediately after
ignition is turned on.
A series of five beeps will be heard. The tone pattern will repeat
periodically until the problem and/or light are repaired.
If any of these things happen, even intermittently, have the SRS serviced
at an authorized dealer immediately. Unless serviced, the system may not
function properly in the event of a collision.
Seat-mounted side airbag system (if equipped)
Do not place objects or mount equipment on or near the airbag
cover on the side of the seatbacks of the front seats or in front
seat areas that may come into contact with a deploying airbag. Failure
to follow these instructions may increase the risk of personal injury in
the event of a collision.
Do not use accessory seat covers. The use of accessory seat
covers may prevent the deployment of the side airbags and
increase the risk of injury in an accident.
Do not lean your head on the door. The side airbag could injure
you as it deploys from the side of the seatback.
Do not attempt to service, repair, or modify the airbag SRS, its
fuses or the seat cover on a seat containing an airbag. See an
authorized dealer.
All occupants of the vehicle should always wear their safety belts
even when an airbag SRS is provided.
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Seating and Safety Restraints
121
Safety Canopy
³
system (if equipped)
Do not place objects or
mount equipment on or
near the headliner at the siderail
that may come into contact with a
deploying Safety Canopy
²
. Failure
to follow these instructions may
increase the risk of personal injury
in the event of a collision.
Do not lean your head on the door. The Safety Canopy
²
could
injure you as it deploys from the headliner.
Do not attempt to service, repair, or modify the Safety Canopy
²
system, its fuses, the A, B, or C pillar trim, or the headliner on a
vehicle containing a Safety Canopy
²
. See your authorized dealer.
All occupants of the vehicle including the driver should always
wear their safety belts even when an airbag SRS and Safety
Canopy
²
system is provided.
To reduce risk of injury, do not obstruct or place objects in the
deployment path of the inflatable Safety Canopy
²
.
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Seating and Safety Restraints
124
If you cannot move the gearshift lever out of P (Park) with ignition in
the RUN position and the brake pedal depressed, it is possible that a
fuse has blown or the vehicle’s brakelamps are not operating properly.
Refer to
Fuses and relays
in the
Roadside Emergencies
chapter.
If the fuse is not blown, perform the following procedure:
1. Apply the parking brake, turn the ignition to LOCK, then remove the
key.
2. Using a screwdriver or similar
tool, carefully pry out the small,
round, tethered Brake Transmission
Shift Interlock (BTSI) cover cap
located to the right of the gearshift
lever.
3. Insert a screwdriver or similar
tool straight down into the access
hole and press downward while
pulling the gearshift lever out of the
P (Park) position and into the N
(Neutral) position.
4. Remove tool and reinstall BTSI tethered cover cap.
5. Start the vehicle and release the parking brake.
Do not drive your vehicle until you verify that the brakelamps
are working.
Always set the parking brake fully and make sure the gearshift is
latched in P (Park). Turn the ignition to the LOCK position and
remove the key whenever you leave your vehicle.
P
R
N
D
2
1
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Driving
179
flash. Press the flasher control again to turn them off. Use it when your
vehicle is disabled and is creating a safety hazard for other motorists.
Note:
With extended use, the flasher may run down your battery.
FUEL PUMP SHUT-OFF SWITCH
This device stops the electric fuel pump from sending fuel to the engine
when your vehicle has had a substantial jolt.
After an accident, if the engine cranks but does not start, this switch
may have been activated.
This switch is located in the front
passenger’s footwell, behind a
flip-up cover, by the kick panel
access cover.
To reset the switch:
1. Turn the ignition OFF.
2. Check the fuel system for leaks.
3. If no leaks are apparent, reset the
switch by pushing in on the reset
button.
4. Turn the ignition ON.
5. Wait a few seconds and return
the key to OFF.
6. Make another check for leaks.
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
15
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
199
Note:
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause severe wire
damage and could start a fire.
Standard fuse amperage rating and color
COLOR
Fuse
rating
Mini
fuses
Standard
fuses
Maxi
fuses
Cartridge
maxi
fuses
Fuse link
cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
Pink
40A
Orange
Green
Green
50A
Red
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
200
Passenger compartment fuse panel
The fuse panel is located on the
right-hand side of the center
console, by the instrument panel.
Remove the panel cover to access
the fuses.
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
201
The fuses are coded as follows:
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
1
15A*
Trailer tow park lamps
2
Not used
3
15A*
Front and rear park lamps
4
10A*
Ignition switch
5
2A*
Powertrain Control Module (PCM
relay), Fuel pump relay, Main fan
relay, High/Low speed fan relay 2,
PATS module
6
15A*
Center High-Mounted Stop Lamp
(CHMSL), Stop lamps, PCM,
Anti-lock Brake System (ABS),
Speed control, Brake On-Off
switch
7
10A*
Instrument cluster, Diagnostic
connector, Power mirror switch,
Radio
8
5A*
Canister vent
9
30A**
Power door locks, Power seats
10
15A*
Heated mirrors
11
15A*
Sunroof, Electrochromatic mirror
12
5A*
Radio
13
Not used
14
Not used
15
30A**
Power windows
16
15A*
Subwoofer
17
15A*
Low beams
18
10A*
4WD
19
Not used
20
15A*
Horn
21
10A*
Rear wiper motor, Rear wiper
washer
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
202
Fuse/Relay
Location
Fuse Amp
Rating
Passenger Compartment Fuse
Panel Description
22
10A*
Instrument cluster
23
Not used
24
20A*
Cigar lighter
25
20A*
Front wiper motor, Front wiper
washer
26
5A*
Climate control system mode
switch
27
5A*
Speed control cancel switch
28
10A*
Instrument cluster
29
10A*
Reverse park aid
30
Not used
31
Not used
32
10A*
Brake-Transmission shift lock
33
15A*
Air bag module, Passenger Air bag
Deactivation (PAD) indicator
lamp, Occupant Classification
Sensor (OCS)
34
5A*
ABS module, Evac and Fill, Speed
control
35
5A*
Heated seats module, 4WD
* Mini fuse ** Cartridge fuse
Power distribution box
The power distribution box is
located in the engine compartment.
The power distribution box contains
high-current fuses that protect your
vehicle’s main electrical systems
from overloads.
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
203
Always disconnect the battery before servicing high current
fuses.
To reduce risk of electrical shock, always replace the cover to
the Power Distribution Box before reconnecting the battery or
refilling fluid reservoirs.
If the battery has been disconnected and reconnected, refer to the
Battery
section of the
Maintenance and Specifications
chapter.
The high-current fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
1
Not used
2
25A*
Headlamp power
3
25A*
High beams, Turn signals, Interior
lamps, Headlamp power
4
5A*
Keep Alive Power (KA PWR)
5
15A*
Heated Exhaust Gas Oxygen
(HEGO) sensors
6
20A*
Fuel pump
7
40A**
RUN/ACC relay -
Electrochromatic mirror, Cigar
lighter, Front and rear wipers
8
30A**
Powertrain Control Module
(PCM), Injectors and coil
9
15A*
Alternator
10
30A*
Heated seats
11
10A*
PCM
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
204
Fuse/Relay
Location
Fuse Amp
Rating
Power Distribution Box
Description
12
20A*
Power point
13
20A*
Fog lamps
14
15A*
A/C clutch, A/C relay
15
30A*
Anti-lock Brake System (ABS)
solenoid
16
25A*
I/P fuse panel (RUN/START)
17
50A**
Ignition (main)
18
40A**
Blower motor
19
40A**
Accessory delay relay - Subwoofer
and 4WD, Low beam
20
60A**
ABS
21
40A**
Horn, CHMSL, Cluster, Power
locks and power seats
22
40A** (I4)
Cooling fan
50A** (V6)
23
40A**
Rear defroster, Park lamps relay
24
40A** (I4)
High/Low speed fan
50A** (V6)
25
Shunt
R2
PCM relay
R3
Fuel pump relay
R4
Cooling fan relay
R5
High/Low speed fan relay 1
R6
Blower motor relay
R7
Starter relay
R8
High/Low speed fan relay 2
R9
Fog lamps relay
R10
A/C relay
D1
Not used
D2
A/C diode
* Mini fuse ** Cartridge fuse
2007 Escape
(204)
Owners Guide (post-2002-fmt)
USA
(fus)
Roadside Emergencies
205