Ford E-250 - 1999 Fuse Box Diagram

Ford E-250 - 1999 Fuse Box Diagram

Steps you can take to properly position yourself away from the airbag:
Move your seat to the rear as far as you can while still reaching the
pedals comfortably.
Recline the seat slightly (one or two degrees) from the upright
position.
Do not put anything on or over the air bag module. Placing
objects on or over the air bag inflation area may cause those
objects to be propelled by the air bag into your face and torso causing
serious injury.
Do not attempt to service, repair, or modify the Air Bag
Supplemental Restraint System or its fuses. See your Ford or
Lincoln-Mercury dealer.
Children and air bags
For additional important safety
information, read all information on
safety restraints in this guide.
Children must always be properly
restrained. Accident statistics
suggest that children are safer when
properly restrained in the rear
seating positions than in the front
seating position. Failure to follow
these instructions may increase the
risk of injury in a collision.
Air bags can kill or injure a
child in a child seat.
NEVER
place a rear-facing child
seat in front of an active air bag. If
you must use a forward-facing
child seat in the front seat, move
the seat all the way back.
Seating and safety restraints
84
TRACTION-LOK AXLE (IF EQUIPPED)
This axle provides added traction on slippery surfaces, particularly when
one wheel is on a poor traction surface. Under normal conditions, the
Traction-Lok axle functions like a standard rear axle.
Extended use of other than the manufacturer’s specified size tires on a
Traction-Lok rear axle could result in a permanent reduction in
effectiveness. This loss of effectiveness does not affect normal driving
and should not be noticeable to the driver.
To avoid injury, never run the engine with one wheel off the
ground, such as when changing a tire.
TRANSMISSION OPERATION
Brake-shift interlock
This vehicle is equipped with a brake-shift interlock feature that prevents
the gearshift from being moved from P (Park) unless the brake pedal is
depressed.
If you cannot move the gearshift out of P (Park) with the brake pedal
depressed:
1. Apply the parking brake, turn ignition key to LOCK, then remove the
key.
2. Insert the key and turn it to OFF. Apply the brake pedal and shift to N
(Neutral).
3. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift, it is
possible that a fuse has blown or the vehicle’s brakelamps are not
operating properly. Refer to
Fuses and relays
in the
Roadside
emergencies
chapter.
Do not drive your vehicle until you verify that the brakelamps
are working.
If your vehicle gets stuck in mud or snow it may be rocked out by
shifting from forward and reverse gears, stopping between shifts, in a
steady pattern. Press lightly on the accelerator in each gear.
Driving
108
For commercial stripped chassis
vehicles, the fuel pump shut-off
switch is located on a bracket above
the brake pedal.
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause
severe wire damage and could start a fire.
15
15
Roadside emergencies
125
Standard fuse amperage rating and color
COLOR
Fuse
Rating
Mini
Fuses
Standard
Fuses
Maxi
Fuses
Cartrigde
Maxi
Fuses
Fuse Link
Cartridge
2A
Grey
Grey
3A
Violet
Violet
4A
Pink
Pink
5A
Tan
Tan
7.5A
Brown
Brown
10A
Red
Red
15A
Blue
Blue
20A
Yellow
Yellow
Yellow
Blue
Blue
25A
Natural
Natural
30A
Green
Green
Green
Pink
Pink
40A
Orange
Green
Orange
50A
Red
Red
Red
60A
Blue
Yellow
70A
Tan
Brown
80A
Natural
Black
Passenger compartment fuse panel
The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the panel cover to access the fuses.
To remove a fuse use the fuse puller tool provided on the fuse panel
cover.
Roadside emergencies
126
The fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Description
1
20A
RABS/4WABS Module
2
15A
Brake Warning Diode/Resistor, Instrument
Cluster, Warning Chime, 4WABS Relay,
Warning Indicators
3
15A
Main Light Switch, RKE Module, Radio
4
15A
Power Locks w/RKE, Illuminated Entry,
Warning Chime, Modified Vehicle, Power
Mirrors, Main Light Switch, Courtesy Lamps
5
20A
RKE Module, Power Lock Switches,
Memory Lock, Power Locks with RKE
6
10A
Shift Interlock, Speed Control, DRL Module
7
10A
Multi-Function Switch, Turn Signals
1
2
3
4
5
7
6
8
9
10
11
42
43
44
13
12
14
15
16
17
19
18
20
21
22
23
25
24
26
27
28
29
31
30
32
33
34
35
37
36
38
39
40
41
Roadside emergencies
127
Fuse/Relay
Location
Fuse Amp
Rating
Description
8
30A
Radio Capacitor(s), Ignition Coil, PCM
Diode, PCM Power Relay, Fuel Heater,
Glow Plug Relay (Diesel Only)
9
30A
Wiper Control Module, Windshield Wiper
Motor
10
20A
Main Light Switch, (External Lamps)
Multi-Function Switch (Flash-to-pass)
11
15A
Brake Pressure Switch, Multi-Function
Switch (Hazards), RABS, Brake Pedal
Position Switch
12
15A
Transmission Range (TR) Sensor, Auxiliary
Battery Relay
13
15A
Blend Door Actuator, Function Selector
Switch
14
5A
Instrument Cluster (Air Bag and Charge
Indicator)
15
5A
Trailer Battery Charge Relay
16
30A
Power Seats
17
Not Used
18
Not Used
19
10A
Air Bag Diagnostic Monitor
20
5A
Overdrive Cancel Switch
21
30A
Power Windows*
22
15A
Memory Power Radio
23
20A
Cigar Lighter, Data Link Connector (DLC)
24
5A
Illuminated Entry Module
25
10A
Left Headlamp (Low Beam)
26
Not Used
27
5A
Radio
28
25A
Power Plug
29
Not Used
30
15A
Headlamps (High Beam Indicator), DRL10A
Roadside emergencies
128
Fuse/Relay
Location
Fuse Amp
Rating
Description
31
10A
Right Headlamp (Low Beam), DRL
32
Not Used
33
Not Used
34
10A
Transmission Range (TR) Sensor
35
Not Used
36
5A
(Cluster, A/C, Illumination, Radio), Steering
Column Assembly
37
Not Used
38
10A
Air Bag Diagnostic Monitor
39
Not Used
40
30A
Modified Vehicle
41
30A
Modified Vehicle
42
Not Used
43
20A C.B.
Power Windows*
44
Not Used
* Either fuse 21 or circuit breaker 43 will be present for power
windows.
Power distribution box
The power distribution box is located in the engine compartment. The
power distribution box contains high-current fuses that protect your
vehicle’s main electrical systems from overloads.
Always disconnect the battery before servicing high current
fuses.
Always replace the cover to the Power Distribution Box before
reconnecting the battery or refilling fluid reservoirs.
Roadside emergencies
129
The high-current fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Description
1
Not Used
2
Not Used
3
Not Used
4
10A
PCM Keep Alive Memory, Instrument
Cluster
5
10A
Right Trailer Turn Signal
6
10A
Left Trailer Turn Signal
7
Not Used
8
60A
I/P Fuses 5, 11, 23, 38, 4, 10, 16, 22, 28
9
30A
PCM Power Relay, Engine Compartment
Fuse 4
10
60A
Auxiliary Battery Relay, Engine
Compartment Fuses 14, 22
11
30A
IDM Relay
12
60A
Engine Compartment Fuses 26, 27
13
50A
Blower Motor Relay (Blower Motor)
A
B
3
2
1
4
6
5
7
15
14
13
12
11
10
9
8
23
22
21
20
19
18
17
16
24
26
25
27
29
C
D
G
F
E
K
J
H
28
Roadside emergencies
130
Fuse/Relay
Location
Fuse Amp
Rating
Description
14
30A
Trailer Running Lamps Relay, Trailer
Backup Lamps Relay
15
40A
Main Light Switch
16
50A
RKE Module, Auxiliary Blower Motor Relay
17
30A
Fuel Pump Relay, IDM (Diesel)
18
60A
I/P Fuses 40, 41
19
60A
4WABS Module
20
20A
Electric Brake Controller
21
50A
Modified Vehicle Power
22
40A
Trailer Battery Charge Relay (Modified
Vehicles Only)
23
60A
Ignition Switch
24
Not Used
25
20A
NGV Module
26
10A
Generator/Voltage Regulator (Diesel Only)
27
15A
DRL Module, Horn Relay
28
PCM Diode
29
Not Used
A
Not Used
B
Not Used
C
Trailer Backup Lamps Relay
D
Trailer Running Lamps Relay
E
Trailer Running Lamps Relay
F
IDM Relay
G
PCM Relay
H
Blower Motor Relay
J
Horn Relay
K
Fuel Pump Relay, IDM Relay (Diesel)
Relays
Relays are located in the power distribution box and should be replaced
by qualified technicians.
Roadside emergencies
131