Ford E-250 - 1998 Fuse Box Diagram

Ford E-250 - 1998 Fuse Box Diagram

Do not place objects or mount equipment on or near the air bag
cover on the steering wheel or in front seat areas that may come
into contact with a deploying air bag. Failure to follow this instruction
may increase the risk of personal injury in the event of a collision.
Do not attempt to service, repair, or modify the Air Bag
Supplemental Restraint System or its fuses. See your Ford or
Lincoln-Mercury dealer.
Children and air bags
For additional important safety
information, read all information on
safety restraints in this guide.
Children should always wear their
safety belts. Failure to follow these
instructions may increase the risk of
injury in a collision.
Air bag can kill or injure a
child in a child seat. If you
must use a forward-facing child
seat in the front seat, move seat
all the way back.
How does the air bag
supplemental restraint system work?
The SRS is designed to activate
when the vehicle sustains sufficient
longitudinal deceleration.
The fact that the air bags did not
inflate in a collision does not mean
that something is wrong with the
system. Rather, it means the forces
were not of the type sufficient to
cause activation.
Seating and safety restraints
47
The parking brake is not designed to stop a moving vehicle. However, if
the normal brakes fail, the parking brake can be used to stop your
vehicle in an emergency. Since the parking brake applies only the rear
brakes, the vehicle’s stopping distance will increase greatly and the
handling of your vehicle will be adversely affected.
Push the pedal downward again to
release the parking brake. Driving
with the parking brake on will cause
the brakes to wear out quickly and
reduce fuel economy.
TRANSMISSION OPERATION
Brake-shift interlock
This vehicle is equipped with a brake-shift interlock feature that prevents
the gearshift from being moved from P (Park) unless the brake pedal is
depressed.
If you cannot move the gearshift out of P (Park) with the brake pedal
depressed:
1. Apply the parking brake, turn ignition key to LOCK, then remove the
key.
2. Insert the key and turn it to OFF. Apply the brake pedal and shift to N
(Neutral).
3. Start the vehicle.
If it is necessary to use the above procedure to move the gearshift, it is
possible that a fuse has blown and the vehicle’s brakelamps may not be
operating properly. Refer to
Fuses and relays
in the
Roadside
emergencies
chapter.
Do not drive your vehicle until you verify that the brakelamps
are working.
HOOD
PUSH
ON
PUSH
OFF
Driving
65
FUSES AND RELAYS
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing any electrical
components.
Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause
severe wire damage and could start a fire.
Standard fuse amperage rating and color
Fuse rating
Color
5 amp
Tan
7.5 amp
Brown
10 amp
Red
15 amp
Light blue
20 amp
Yellow
20 amp fuse link
Light blue
25 amp
Natural
30 amp
Light green
30 amp fuse link
Pink
40 amp fuse link
Green
50 amp fuse link
Red
60 amp fuse link
Yellow
80 amp fuse link
Black
100 amp fuse link
Dark blue
Passenger compartment fuse panel
The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the panel cover to access the fuses.
15
15
Roadside emergencies
79
To remove a fuse use the fuse puller tool provided on the fuse panel
cover.
The fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Description
1
20A
RABS/4WABS Module
2
15A
Brake Warning Diode/Resistor, Instrument
Cluster, Warning Chime, 4WABS Relay,
Warning Indicators
3
15A
Main Light Switch, RKE Module, Radio
4
15A
Power Locks w/RKE, Illuminated Entry,
Warning Chime, Modified Vehicle, Power
Mirrors, Main Light Switch, Courtesy Lamps
5
20A
RKE Module, Power Lock Switches, Memory
Lock, Power Locks with RKE
1
2
3
4
5
7
6
8
9
10
11
42
43
44
13
12
14
15
16
17
19
18
20
21
22
23
25
24
26
27
28
29
31
30
32
33
34
35
37
36
38
39
40
41
Roadside emergencies
80
Fuse/Relay
Location
Fuse Amp
Rating
Description
6
10A
Shift Interlock, Speed Control, DRL Module
7
10A
Multi-Function Switch, Turn Signals
8
30A
Radio Capacitor(s), Ignition Coil, PCM Diode,
PCM Power Relay, Fuel Heater, Glow Plug
Relay (Diesel)
9
30A
Wiper Control Module, Windshield Wiper
Motor
10
20A
Main Light Switch, (External Lamps)
Multi-Function Switch (Flash-to-pass)
11
15A
Brake Pressure Switch, Multi-Function Switch
(Hazards), RABS, Brake Pedal Position
Switch
12
15A
Transmission Range (TR) Sensor, Auxiliary
Battery Relay
13
15A
Blend Door Actuator, Function Selector
Switch
14
5A
Instrument Cluster (Air Bag and Charge
Indicator)
15
5A
Trailer Battery Charge Relay
16
30A
Power Seats
17
Not Used
18
Not Used
19
10A
Air Bag Diagnostic Monitor
20
5A
Overdrive Cancel Switch
21
30A
Power Windows*
22
15A
Memory Power Radio
23
20A
Cigar Lighter, Data Link Connector (DLC)
24
5A
Illuminated Entry Module
25
10A
Left Headlamp (Low Beam)
26
-
Not Used
27
5A
Radio
28
25A
Power Plug
Roadside emergencies
81
Fuse/Relay
Location
Fuse Amp
Rating
Description
29
Not Used
30
15A
Headlamps (High Beam Indicator), DRL
31
10A
Right Headlamp (Low Beam), DRL
32
Not Used
33
Not Used
34
10A
Transmission Range (TR) Sensor
35
Not Used
36
5A
(Cluster, A/C, Illumination, Radio), Steering
Column Assembly
37
Not Used
38
10A
Air Bag Diagnostic Monitor
39
Not Used
40
30A
Modified Vehicle
41
30A
Modified Vehicle
42
Not Used
43
20A C.B.
Power Windows*
44
Not Used
*Either fuse 21 or circuit breaker 43 will be present for power
windows.
Power distribution box
The power distribution box is located in the engine compartment. The
power distribution box contains high-current fuses that protect your
vehicle’s main electrical systems from overloads.
Always disconnect the battery before servicing high current
fuses.
Always replace the cover to the Power Distribution Box before
reconnecting the battery or refilling fluid reservoirs.
Roadside emergencies
82
The high-current fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Description
1
Not Used
2
Not Used
3
Not Used
4
10A
PCM Keep Alive Memory, Instrument Cluster
5
10A
Right Trailer Turn Signal
6
10A
Left Trailer Turn Signal
7
Not Used
8
60A
I/P Fuses 5, 11, 23, 38, 4, 10, 16, 22, 28
9
30A
PCM Power Relay, Engine Compartment Fuse
4
10
60A
Auxiliary Battery Relay, Engine Compartment
Fuses 14, 22
11
30A
IDM Relay (1998 1/2 Vehicles)
12
60A
Engine Compartment Fuses 26, 27
13
50A
Blower Motor Relay (Blower Motor)
A
B
3
2
1
4
6
5
7
15
14
13
12
11
10
9
8
23
22
21
20
19
18
17
16
24
26
25
27
29
C
D
G
F
E
K
J
H
28
Roadside emergencies
83
Fuse/Relay
Location
Fuse Amp
Rating
Description
14
30A
Trailer Running Lamps Relay, Trailer Backup
Lamps Relay
15
40A
Main Light Switch
16
50A
RKE Module, Auxiliary Blower Motor Relay
17
30A
Fuel Pump Relay, IDM (Diesel)
18
60A
I/P Fuses 40, 41
19
60A
4WABS Module
20
20A
Electric Brake Controller
21
50A
Modified Vehicle Power
22
40A
Trailer Battery Charge Relay (Modified
Vehicles Only)
23
60A
Ignition Switch
24
Not Used
25
20A
NGV Module
26
10A
Generator/Voltage Regulator (Diesel Only)
27
15A
DRL Module, Horn Relay
28
PCM Diode
29
Not Used
A
Not Used
B
Not Used
C
-
Trailer Backup Lamps Relay
D
-
Trailer Running Lamps Relay
E
-
Trailer Battery Charge Relay
F
-
IDM Relay
G
-
PCM Relay
H
-
Blower Motor Relay
J
-
Horn Relay
K
-
Fuel Pump Relay, IDM Relay (Diesel)
Relays
Relays are located in the power distribution box and should be replaced
by qualified technicians.
Roadside emergencies
84