Honda Fit - 2009 Fuse Box Diagram

Honda Fit - 2009 Fuse Box Diagram

Your vehicle's audio system will
disable itself if it is disconnected
from electrical power for any reason.
To make it work again, you must
enter a specific digit code using the
preset buttons. Because there are
hundreds of number combinations
possible from specific digits, making
the system work without knowing
the exact code is nearly impossible.
You should have received a card that
lists your audio system's code and
serial numbers. It is best to store this
card in a safe place at home. In
addition, you should write the audio
system's serial number in this
owner's manual.
If you lose the card, you must obtain
the code number from a dealer. To
do this, you will need the system's
serial number.
If your vehicle's battery is
disconnected or goes dead, or the
radio fuse is removed, the audio
system will disable itself. If this
happens, you will see
‘‘
ENTER
CODE
’’
in the frequency display the
next time you turn on the system.
Use the preset buttons to enter the
code. On vehicles with navigation
system, touch the Done icon to set
the code. The code is on the radio
code card included in your owner's
manual kit. When it is entered
correctly, the radio will start playing.
If you make a mistake entering the
code, do not start over; complete the
sequence, then enter the correct
code. You have 10 tries to enter the
correct code. If you are unsuccessful
in 10 attempts, you must then leave
the system on for 1 hour before
trying again.
Radio Theft Protection
191
Features
2009
Fit
5. Release the parking brake.
Manual transmission:
1. Move the shifter into the Neutral
position.
2. Release the parking brake.
Leave the ignition switch in the
ACCESSORY (I) position so the
steering wheel does not lock. Make
sure the radio and any items plugged
into the accessory power sockets are
turned off so you do not run down
the battery.
When you stop towing your vehicle
and shift out of the neutral position,
you may not be able to move the shift
lever from neutral to reverse or Park.
If this happens, press the brake pedal
and turn the ignition switch to the
ON (II) position, then shift out of
neutral.
Extended Towing
If you tow more than 8 hours in one
day, you should repeat the above
procedure at least every 8 hours
(when you stop for fuel, etc.)
Failure to follow the recommended
instructions exactly will result in severe
automatic transmission damage. If you
cannot shift the transmission or start
the engine, your vehicle must be
transported on a flat-bed truck or
trailer.
When towing your vehicle for long
periods, remove the 20A Accessory
Socket and 30A Radio fuses to
reduce drain on battery. These fuses
are located in the interior fuse box
and are shown as number 13 and 61
below.
CONTINUED
Towing Your Vehicle Behind a Motorhome
239
Driving
2009
Fit
Only remove the fuses after you have
performed the transmission shifting
procedure, and the key is in the
ACCESSORY (I) position. Store the
fuses in an obvious location (center
pocket, etc) as a reminder to re-
install the fuses before driving the
vehicle.
On vehicles without navigation system
If the radio fuse is removed, the
audio system will disable itself. The
next time you turn on the radio you
will see
‘‘
ENTER CODE
’’
in the
frequency display. Use the preset
buttons to enter the code (see page
191
).
When the audio system is disabled,
the clock setting in the audio system
will be canceled. You will need to
reset the clock (see page
192
).
On vehicles with navigation system
The navigation system will also
disable itself. The next time you turn
on the ignition switch, the system
will require you to enter
‘‘
ENTER
CODE
’’
before it can be used. Refer
to the navigation system manual.
ACCESSORY SOCKET FUSE
RADIO FUSE
Towing Your Vehicle Behind a Motorhome
240
2009
Fit
Turn the ignition switch to the
START (III) position. If the
headlights do not dim, check the
condition of the fuses. If the fuses
are OK, there is probably
something wrong with the
electrical circuit for the ignition
switch or starter motor. You will
need a qualified technician to
determine the problem. See
Emergency Towing
on page
311
.
If the headlights dim noticeably or go
out when you try to start the engine,
either the battery is discharged or
the connections are corroded. Check
the condition of the battery and
terminal connections (see page
279
).
You can then try jump starting the
vehicle from a booster battery (see
page
299
).
The Starter Operates Normally
In this case, the starter motor's speed
sounds normal, or even faster than
normal, when you turn the ignition
switch to the START (III) position,
but the engine does not run.
Are you using a properly coded
key? An improperly coded key will
cause the immobilizer system
indicator in the instrument panel
to blink rapidly (see page
79
).
Are you using the proper starting
procedure? Refer to
Starting the
Engine
on page
216
.
Do you have fuel? Check the fuel
gauge; the low fuel indicator may
not be working.
There may be an electrical
problem, such as no power to the
fuel pump. Check all the fuses (see
page
306
).
If you find nothing wrong, you will
need a qualified technician to find the
problem. See
Emergency Towing
on
page
311
.
If the Engine Won't Start
298
2009
Fit
3. Remove the cover from the under-
hood fuse box (see page
306
).
Connect one jumper cable to the
positive (
) terminal on your
battery. Connect the other end to
the positive (
) terminal on the
booster battery.
4. Connect the second jumper cable
to the negative (
) terminal on
the booster battery. Connect the
other end to the ground strap as
shown. Do not connect this jumper
cable to any other part of the
engine.
5. If the booster battery is in another
vehicle, have an assistant start that
vehicle and run it at a fast idle.
6. Start your vehicle. If the starter
motor still operates slowly, check
that the jumper cables have good
metal-to-metal contact.
7. Once your vehicle is running,
disconnect the negative cable from
your vehicle, then from the
booster battery. Disconnect the
positive cable from your vehicle,
then from the booster battery.
Keep the ends of the jumper cables
away from each other and any metal
on the vehicle until everything is
disconnected. Otherwise, you may
cause an electrical short.
Jump Starting
300
2009
Fit
The vehicle's fuses are contained in
two fuse boxes.
The interior fuse box is behind the
fuse lid. To access it, pull the fuse lid
toward you.
The under-hood fuse box is on the
positive terminal of the battery.
INTERIOR
FUSE LID
FUSE LABEL
INTERIOR
UNDER-HOOD (On Battery)
Fuses
306
2009
Fit
Checking and Replacing Fuses
If something electrical in your
vehicle stops working, check for a
blown fuse first. Determine from the
chart on pages
309
and
310
, or the
diagram on the fuse label, which fuse
or fuses control that device. Check
those fuses first, but check all the
fuses before deciding that a blown
fuse is the cause. Replace any blown
fuses, and check if the device works.
1. Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are off.
2. On the under-hood fuse box,
remove the cover from the fuse
box. On the interior fuse box, pull
the fuse lid toward you.
3. Check each of the large fuses in
the under-hood fuse box and the
interior fuse box by looking
through the top at the wire inside.
4. Check all smaller fuses in the
interior fuse box by pulling out
each one with the fuse puller
provided in the interior fuse box.
FUSE
BLOWN
FUSE PULLER
CONTINUED
Fuses
307
Taking Care of the Unexpected
2009
Fit
5. Look for a blown wire inside the
fuse. If it is blown, replace it with
one of the spare fuses of the same
rating or lower.
If you cannot drive the vehicle
without fixing the problem, and you
do not have a spare fuse, take a fuse
of the same rating or a lower rating
from one of the other circuits. Make
sure you can do without that circuit
temporarily (such as the accessory
power socket or radio).
If you replace the blown fuse with a
spare fuse that has a lower rating, it
might blow out again. This does not
indicate anything wrong. Replace the
fuse with one of the correct rating as
soon as you can.
Replacing a fuse with one that has a
higher rating greatly increases the
chances of damaging the electrical
system. If you do not have a
replacement fuse with the proper rating
for the circuit, install one with a lower
rating.
6. If the replacement fuse of the same
rating blows in a short time, there
is probably a serious electrical
problem in your vehicle. Leave the
blown fuse in that circuit and have
your vehicle checked by a
qualified technician.
On vehicles without navigation system
If the radio fuse is removed, the
audio system will disable itself. The
next time you turn on the radio you
will see
‘‘
ENTER CODE
’’
in the
frequency display. Use the preset
buttons to enter the code (see page
191
).
When the audio system is disabled,
the clock setting in the audio system
will be canceled. You will need to
reset the clock (see page
192
).
On vehicles with navigation system
The navigation system will also
disable itself. The next time you turn
on the ignition switch, the system
will require you to enter
‘‘
ENTER
CODE
’’
before it can be used. Refer
to the navigation system manual.
BLOWN
Fuses
308
2009
Fit
INTERIOR FUSE BOX
No.
Amps.
Circuits Protected
1
10 A
Back Up
2
(7.5 A)
TPMS
3
20 A
Driver's Power Window
4
Not Used
5
10 A
Back Up Light
6
10 A
SRS
7
(10 A)
Transmission SOL
8
7.5 A
SRS
9
(20 A)
Fog Light
10
7.5 A
A/C
11
7.5 A
ABS/VSA
12
10 A
ACG
13
20 A
ACC Socket
14
7.5 A
Key Lock/Radio
15
7.5 A
Daytime Running Light
16
10 A
Rear Wiper
17
20 A
Front Passenger's Power
Window
18
20 A
Rear Passenger's Side
Power Window
19
20 A
Rear Driver's Side Power
Window
20
15 A
Fuel Pump
21
15 A
Washer
22
7.5 A
Meter
23
10 A
Hazard
24
10 A
Stop/Horn
25
Not Used
No.
Amps.
Circuits Protected
26
10 A
LAF
27
(30 A)
Door Lock Main
28
20 A
Headlight Main
29
10 A
Small Light
30
30 A
Main Fan Motor
31
Not Used
32
10 A
Right Headlight Low Beam
33
15 A
IG Coil
34
10 A
Left Headlight Low Beam
35
(15 A)
Door Lock
36
(15 A)
Door Lock
37
30 A
ABS/VSA
FSR
38
(15 A)
Door Lock
39
15 A
IGP
40
Not Used
41
Not Used
42
Not Used
43
(7.5 A)
MG Clutch
44
7.5 A
STS
45
Not Used
46
Not Used
47
(30 A)
Sub Fan Motor
48
10 A
Left Headlight High Beam
49
(15 A)
Door Lock
50
(15 A)
Door Lock
: If equipped
CONTINUED
Fuse Locations
309
Taking Care of the Unexpected
2009
Fit
No.
Amps.
Circuits Protected
51
10 A
Right Headlight High Beam
52
15 A
DBW
53
Not Used
54
20 A
Rear Defogger
55
10 A
Heated Mirror
56
30 A
Front Wiper
57
30 A
Blower Motor
58
30 A
ABS/VSA
Motor
59
20 A
Rear Defogger
30 A
60
50 A/
40 A
IG Main/Option Main
61
30 A
Radio
62
Not Used
: If equipped
UNDER-HOOD FUSE BOX
Under-hood Fuse Box (On the battery)
Amps.
Circuits Protected
100 A
Battery
70 A
EPS
20 A
Horn/Hazard
Fuse Locations
310
2009
Fit
Battery
Capacity
12 V
32 AH/5 HR
12 V
34 AH/5 HR
12 V
40 AH/20 HR
Fuses
Interior
See page
309
or the fuse label
attached to the dashboard.
Under-hood
See page
310
or the fuse box cover.
Alignment
Toe-in
Front
0.0 in (0 mm)
Rear
0.10 in (2.5 mm)
Camber
Front
Rear
Caster
Front
3°20'
Tires
Size
Front/Rear
175/65R15 84S
1
185/55R16 83H
2
Spare
T125/70D15 95M
3
T135/80D15 99M
4
Pressure
Front/Rear
32 psi (220 kPa,
2.2 kgf/cm
2
)
1
33 psi (230 kPa,
2.3 kgf/cm
2
)
2
Spare
60 psi (420 kPa,
4.2 kgf/cm
2
)
1: All models except Sport
2: Sport model
3: On models without VSA system and all Canadian models with
manual transmission
4: On models with VSA system
Specifications
320
2009
Fit